arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2212.01066physics.chem-ph
收藏

喷雾热解法制备用于太阳能电池的还原氧化石墨烯薄膜

Deposition of Reduced Graphene Oxide Thin Film by Spray Pyrolysis Method for Perovskite Solar Cell

Manoj Pandey, Dipendra Hamal, Deepak Subedi, Bijaya Basnet, Rajaram Sah, Santosh K. Tiwari, Bhim Kafle

摘要:

Percent吸收层、电子输运层(ETL)、空穴输运层(HTL)和透明导电氧化物层(TCO)是构成Percent太阳能电池的主要组件。在ETL和HTL之间,夹有吸收层,在吸收太阳辐射之后,在吸收层上产生电子-空穴对。尽管在提高效率方面取得了重大进展,但长期稳定性仍然是一个严重问题。目前的工作集中于通过采用钛白(TiO 2)作为ETL和还原的氧化石墨烯(rGO)作为HTL来对后一个问题做出贡献。具体而言,在本工作中,我们报告了我们的努力,紧凑的钛白(C-TiO 2)和介孔钛白(M-TiO 2)层作为ETL和还原的氧化石墨烯薄膜作为HTL的制备。将C-TiO 2膜旋涂在FTO玻璃上,然后使用刮涂技术浇铸M-TiO 2膜。类似地,rGO膜通过在玻璃基底上喷涂来生产。通过测量其光学性质(薄膜的透射率和反射率)来表征所制备的ETL和HTL层。然后,分别从ETL和HTL的反射率和透射率曲线中提取带隙Eg。在rGO的情况下,我们发现Eg的值为2.1eV,其在2.7eV和0.02eV之间变化,这取决于其基于先前报道的值的还原水平。类似地,C-TiO 2的带隙为4.51 eV,在添加M-TiO 2后降低至4.12 eV,这比先前报道的值高0.9至1.1 eV。然而,在使用M-TiO 2后,带隙显示出比C-TiO 2更小的趋势。在Percent太阳能电池中,ETL和HTL都将被研究。

英文摘要:

The Perovskite absorber layer, the electron transport layer (ETL), the hole transport layer (HTL), and the transparent conducting oxide layer (TCO) are the major components that make up a Perovskite solar cell. Between ETL and HTL, the absorber layer is sandwiched, on which electron-hole pairs are created after absorption of solar radiation. Despite substantial progress toward efficiency, long-term stability still remains a serious concern. Present work focuses toward contributing on the later issue by adopting Titanium dioxide (TiO2) as ETL and reduced graphene oxide (rGO) as HTL. Specifically, in the present work, we report our efforts on the preparation of compact titanium dioxide (C-TiO2) and mesoporous titanium dioxide (M-TiO2) layers as an ETL and a reduced graphene oxide thin film as a HTL. The C-TiO2 film was spin casted on FTO glass followed by casting of M-TiO2 film using Doctor Blading technique. Similarly, the rGO film was produced by spray casting over the glass substrate. The as-prepared ETL and HTL layers were characterized by measuring their optical properties (transmittance and reflectance of thin films). Then, the bandgap, Eg was extracted from reflectance and transmittance curves for ETL and HTL respectively. In the case of rGO, we found the value of Eg to be 2.1 eV, which varies between 2.7eV and 0.02eV depending upon its reduction level based on the previously reported values. Similarly, the bandgap of the C-TiO2 was 4.51 eV which was reduced to 4.12 eV after the addition of M-TiO2, which are 0.9 to 1.1 eV higher than previously reported values. However, bandgap shows decreasing trend after employing M- TiO2 over C-TiO2. In a Perovskite solar cell, both ETL and HTL will be investigated.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑