质子交换膜燃料电池气体扩散层及气体通道内两相流动的数值模拟
Numerical simulation of two-phase flow in gas diffusion layer and gas channel of proton exchange membrane fuel cells
摘要:
质子交换膜燃料电池(PEMFC)阴极气体扩散层(GDL)和气体通道(GC)中的液态水与气体传输特性密切相关,从而影响电化学转化率。在这项研究中,GDL和GC区域被用作模拟域,这不同于以往的研究,只集中在其中的任何一个。采用流体体积法对气液两相流行为进行数值研究,水分运移格局演变、水分覆盖率以及局部和总含水饱和度。为了获得GDL几何形状,开发了一种基于内部几何的GDL重建方法。此外,为了研究GDL碳纤维直径的影响,通过改变碳纤维直径但保持孔隙率和几何尺寸恒定,使用相同的程序来重建三种GDL结构。壁面润湿性通过碳纤维表面和通道壁面的静态接触角来介绍。结果表明,GDL纤维的微观结构对阴极场中的两相流流型有显著影响。在两个阴极域的两相流流型演化的不同阶段进行了观察。由于润湿性的差异,GDL/GC界面的水覆盖率小于通道侧壁和顶壁的水覆盖率。研究还发现,GDLs内部的含水饱和度在水突破后趋于稳定,而界面处的局部含水饱和度则保持不规则的振荡。最后但并非最不重要的是,观察到GDL和GC之间的水饱和度平衡要求。就变化的纤维直径而言,较大的纤维直径将导致GDL中较少的水饱和度,但GC中较多的水,此外还导致水在整个域中更快的移动。
英文摘要:
Liquid water within the cathode Gas Diffusion Layer (GDL) and Gas Channel (GC) of Proton Exchange Membrane Fuel Cells (PEMFCs) is strongly coupled to gas transport properties, thereby affecting the electrochemical conversion rates. In this study, the GDL and GC regions are utilized as the simulation domain, which differs from previous studies that only focused on any one of them. A volume-of-fluid method is adopted to numerically investigate the two-phase flow (gas and liquid) behavior, e.g., water transport pattern evolution, water coverage ratio as well as local and total water saturation. To obtain GDL geometries, an in-house geometry-based method is developed for GDL reconstruction. Furthermore, to study the effect of GDL carbon fiber diameter, the same procedure is used to reconstruct three GDL structures by varying the carbon fiber diameter but keeping the porosity and geometric dimensions constant. The wall wettability is introduced with static contact angles at carbon fiber surfaces and channel walls. The results show that the GDL fiber microstructure has a significant impact on the two-phase flow patterns in the cathode field. Different stages of two-phase flow pattern evolution in both cathode domains are observed. Due to the difference in wettability, the water coverage of the GDL/GC interface is smaller than that of the channel side and top walls. It is also found that the water saturation inside the GDLs stabilizes after the water breakthrough, while local water saturation at the interface keeps irregular oscillations. Last but not the least, a water saturation balance requirement between the GDL and GC is observed. In terms of varying fiber diameter, a larger fiber diameter would result in less water saturation in the GDL but more water in the GC, in addition to faster water movement throughout the total domain.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。