用于精确热流测量的商用热电模块的特性
Characterization of Commercial Thermoelectric Modules for Precision Heat FLux Measurement
摘要:
在这篇文章中,我们提出了一种具有成本效益的方法,使用商业热电模块(TEM)的热流的精确测量。研究了两种不同的TEM测量热流的方法,即基于塞贝克效应的被动模式和基于珀耳帖效应的主动模式。对于这两种模式,作为热通量计的TEM被校准,以显示TEM两端的电压与从0到100 mW的热流率之间的线性关系。虽然这两种模式都表现出足够高的灵敏度,适用于低热流测量,主动模式被证明是$\sim$ 7倍以上的灵敏度比被动模式。从测量不确定度的来源的推测,我们提出了一个双TEM方案,通过操作在被动模式的顶部TEM,而其底部的温度保持恒定的反馈控制的底部TEM。双TEM方案通过稳定底部温度,与单TEM被动模式相比,可以抑制灵敏度不确定性高达4倍。测量1.5 cm $\times$ 1.5 cm TEM的响应时间,对于加热为8.90 $\pm$ 0.97秒,对于冷却为10.83 $\pm$ 0.65秒,这比商用热通量计慢,但仍然足够快以10秒量级的时间分辨率测量热通量。我们相信所得的结果可以促进商业TEM在各种热实验中用于热流测量
英文摘要:
In this article, we present a cost-effective approach to the precision measurement of heat flux using commercial thermoelectric modules (TEMs). Two different methods of measuring heat flux with TEMs are investigated, namely passive mode based on the Seebeck effect and active mode based on the Peltier effect. For both modes, a TEM as a heat fluxmeter is calibrated to show a linear relation between the voltage across the TEM and the heat flow rate from 0 to 100 mW. While both modes exhibit sufficiently high sensitivities suitable for low heat flow measurement, active mode is shown to be $\sim$7 times more sensitive than passive mode. From the speculation on the origin of the measurement uncertainty, we propose a dual TEM scheme by operating the top TEM in passive mode while its bottom temperature maintains constant by the feedback-controlled bottom TEM. The dual-TEM scheme can suppress the sensitivity uncertainty by up to 4 times when compared to the single-TEM passive mode by stabilizing the bottom temperature. The response time of a 1.5 cm $\times$ 1.5 cm TEM is measured to be 8.90 $\pm$ 0.97 seconds for heating and 10.83 $\pm$ 0.65 seconds for cooling, which is slower than commercial heat fluxmeters but still fast enough to measure heat flux with a time resolution on the order of 10 seconds. We believe that the obtained results can facilitate the use of a commercial TEM for heat flux measurement in various thermal experiments
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。