This study reports on the vortex-induced lift production mechanisms in low Reynolds number flows over low aspect-ratio rectangular wings. We use a rigorous force partitioning method which allows for the estimation of the pressure-induced aerodynamic loads due to distinct flow features or vortex structures in the flow around the wing. The specific focus of this work is on distinguishing the effect of spanwise and cross-span oriented vortex structures on pressure-induced lift production. We quantify the lift induced on the wing by these different vortices, and also estimate their influence within different regions of the flow-field around the wing and in the wake. By varying the aspect-ratio and angle-of-attack of the wing, we show that for most cases, the spanwise oriented vorticity contributes less to the total lift than cross-span oriented vortices. Furthermore, the spanwise vorticity in the near wake is capable of producing net negative lift on the wing and this is explained by separating and quantifying the influence of vortex cores and regions of strain in the wake. The results demonstrate the utility of the force partitioning method for dissecting the flow physics of vortex dominated flows.
We reveal the effects of sweep on the wake dynamics around NACA 0015 wings at high angles of attack using direct numerical simulations and resolvent analysis. The influence of sweep on the wake dynamics is considered for sweep angles from $0^\circ$ to $45^\circ$ and angles of attack from $16^\circ$ to $30^\circ$ for a spanwise periodic wing at a chord-based Reynolds number of $400$ and a Mach number of $0.1$. Wing sweep affects the wake dynamics, especially in terms of stability and spanwise fluctuations with implications on the development of three-dimensional wakes. We observe that wing swee…
Researchers have hypothesized that the post-stall lift benefit of bird's alular feathers, or alula, stems from the maintenance of an attached leading-edge vortex (LEV) over their thin-profiled, outer hand-wing. Here, we investigate the connection between the alula and LEV attachment via flow measurements in a wind tunnel. We show that a model alula, whose wetted area is 1% that of the wing, stabilizes a recirculatory aft-tilted LEV on a steadily-translating unswept wing inclined at post-stall incidences. The attached vortex is the result of the alula's ability to smoothly merge otherwise separ…
We perform DNS of flow over finite-aspect-ratio NACA 0015 wings to characterize the tip effects on the wake dynamics. This study focuses on the development of three-dimensional separated flow over the wing, and discuss flow structures formed on the wing surface as well as in the far field wake. Vorticity is introduced into the flow in a predominantly two-dimensional manner. The vortex sheet from the wing tip rolls up around the free end to form the tip vortex. At its inception, the tip vortex is weak and its effect is spatially confined. As the flow around the tip separates, the tip effects ex…
This work investigated the vorticity dynamics and stability of leading-edge vortices (LEVs) in revolving wings. Previous studies suggested that Coriolis acceleration and spanwise flow both played key roles in stabilizing the LEV; however, the exact mechanism remains unclear. The current study examined a mechanism that relates the effects of Coriolis acceleration, spanwise flow, and the tilting of the planetary vortex on limiting the growth of the LEV. Specifically, this mechanism states that a vertical gradient in spanwise flow can create a vertical gradient in Coriolis acceleration, which wil…
Flapping flight and swimming are increasingly studied both due to their intrinsic scientific richness and their applicability to novel robotic systems. Strip theory is often applied to flapping wings, but such modeling is only rigorously applicable in the limit of infinite aspect ratio (AR) where the geometry and kinematics are effectively uniform. This work compares the flow features and forces of strip theory and three-dimensional flapping foils, maintaining similitude in the rolling and twisting kinematics while varying the foil AR. We find the key influence of finite AR and spanwise varyin…
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due to its inability to accurately resolve the Kelvin-Helmholtz instability. In this study, a shear layer adapted subgrid length scale is applied to enhance the IDDES prediction of the flow around a finite NACA (National Advisory Committee for Aeronautics) 0012 wing with leading edge horn ice. It is found that applying the new length scale contributes to a more accurate prediction of the separated sh…
Unveiling wing turbulence dynamics through explainable deep learning
ONERA（法国国家航空航天研究院）；Instituto Universitario de Matemática Pura y Aplicada, Universitat Politècnica de València（巴伦西亚理工大学纯数学与应用数学大学研究所）；University of Michigan（密歇根大学）；KTH Royal Institute of Technology（瑞典皇家理工学院）
The results of a DNS of the flow around a wing section represented by a NACA4412 profile, with Rec = 400, 000 and 5 degree angle of attack, are presented in this study. The high-order spectral element code Nek5000 was used for the computations. The Clauser pressure-gradient parameter ? ranges from 0 and 85 on the suction side, and the maximum Re_theta and Re_tau values are around 2,800 and 373, respectively. Comparisons between the suction side with ZPG TBL data show a more prominent wake, a steeper logarithmic region and lower velocities in the buffer region. The APG also leads to a progressi…
The number of studies related to unmanned air vehicles (UAV), micro air vehicles (MAV), wind turbines, birds and insects which operate at low Reynolds (Re) numbers have rapidly increased, recently. In this thesis, unsteady aerodynamics of low Reynolds number flows (Re=25000, 50000 and 75000) on NACA4412 airfoil shaped wing which is mainly used in wind turbines and micro air vehicles and operates at low Reynolds numbers and has aspect ratio of 1 (AR=1) was investigated by means of numerous experimental analyses at various angles of attack changing from 0° to 45°. Due to the obtained force measu…
SuperWing: a comprehensive transonic wing dataset for data-driven aerodynamic design
School of Aerospace Engineering, Tsinghua University, Beijing, China（清华大学北京航空航天工程学院）；School of Computation, Information and Technology, Technical University of Munich, Germany（慕尼黑技术大学计算、信息与技术学院）
Geese achieve stationary takeoff via synergistic wing kinematics and enhanced aerodynamics
J.C. Wu Center for Aerodynamics, School of Aeronautics and Astronautics（航空宇航学院）；Bird Aerospace Technology (Suzhou) Co., Ltd.（鸟航天科技（苏州）有限公司）；Commercial Aircraft Corporation of China（中国商用飞机有限责任公司）；Shanghai Jiao Tong University（上海交通大学）
Unsteady Lifting-Line Theory (ULLT) is a low order method capable of modeling interacting unsteady and finite wing effects at low computational cost. Most formulations of the method assume inviscid flow and small amplitudes. Whilst these assumptions might be suitable for small-amplitude aeroelastic problems at high Reynolds numbers, modern engineering applications increasingly involve lower Reynolds numbers, large amplitude kinematics and vortex structures that lead to aerodynamic non-linearities. This paper establishes that ULLT still provides a good solution for low Reynolds number, large-am…
Information-theoretic machine learning for time-varying mode decomposition of separated aerodynamic flows
Department of Aerospace Engineering, Tohoku University（东京东京大学航空工程系）；Department of Mechanical and Aerospace Engineering, Tokyo University of Science（东京科学大学机械与航空航天工程系）
