玻璃管的非稳拉伸与内部通道增压
Unsteady stretching of a glass tube with internal channel pressurisation
AI总结:
研究通过数学建模探讨了在玻璃管内施加过压条件下,非稳加热拉伸形成近均匀孔径和小壁厚尖端的过程,分析了拉力和过压参数对几何形状的影响。
摘要:
本文通过数学建模研究了在玻璃管内施加过压条件下,非稳加热拉伸形成近均匀孔径和小壁厚尖端的过程。为考虑粘度随温度变化,假设了轴向变化的粘度。研究目的是制造连续流体流动的发射器尖端,以避免堵塞。首次证明了通过此工艺制造此类发射器的可行性,并探讨了工艺参数,特别是拉力和过压,对几何形状的影响。对于小参数值,可获得更均匀的孔径,但几何形状对小波动高度敏感。较大参数值导致孔径变化更大,但对波动的敏感性较低。最佳参数取决于制造尖端的拉伸机精度和几何公差允许范围。该模型还可广泛应用于其他设备的制造。
英文摘要:
Mathematical modelling is used to examine the unsteady problem of heating and pulling an axisymmetric cylindrical glass tube with an over-pressure applied within the tube to form tapers with a near uniform bore and small wall thickness at the tip. To allow for the dependence of viscosity on temperature, a prescribed axially varying viscosity is assumed. Our motivation is the manufacture of emitter tips for mass spectrometry which provide a continuous fluid flow and do not become blocked. We demonstrate, for the first time, the feasibility of producing such emitters by this process and examine the influence of the process parameters, in particular the pulling force and over-pressure, on the geometry. For small values of these parameters a more uniform bore may be obtained but the geometry is highly sensitive to small fluctuations. Higher values of the parameters result in more variation in the bore size but less sensitivity to fluctuations. The best parameters depend on the accuracy of the puller used to manufacture the tapers and the permissible tolerances on the geometry. The model has wider application to the manufacture of other devices.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。