This paper presents an investigation into load dynamics that potentially cause voltage instability or collapse in distribution networks. Through phasor-based, time domain simulations of a dynamic load (DL) model from the literature, we show that the load dynamics alone do not cause voltage instability or collapse. By comparing the DL model to a benchmark model, we identify an important limitation with the DL model. We characterise this limitation and recommend that future work use load models with physical state variables. By investigating when and how load dynamics cause voltage instability, we are well-positioned to develop systems to control and maintain voltage stability in distribution networks.
Unbalanced and nonlinear loads connected to microgrids (MG) with local distributed energy resources (DERs) are two of the leading causes of power quality problems. Nonlinearloads introduce voltage and current harmonics, and single-phase loads can cause voltage and current imbalances in a three-phase network. This paper presents a hierarchical control scheme for voltage-controlled photovoltaic (PV) inverters with unbalanced and nonlinear loads in micro-grids. The hierarchical control consists of primary control and voltage compensation control(VCC) and a DC voltage regulator (VR). The primary c…
This paper studies the impacts of stochastic load fluctuations, namely the fluctuation intensity and the load power variation speed, on power system dynamic voltage stability. Additionally, the trade-off relationship between the two parameters is revealed, which provides important insights regarding the potential of using energy storage to maintain voltage stability under high uncertainty. To this end, Stochastic Differential-Algebraic Equations (SDAEs) are used to model the stochastic load variation; bifurcation analysis is carried out to explain the influence of stochasticity. Numerical stud…
In this paper we propose a new passivity-based control technique for DC power networks comprising the so-called ZIP-loads, i.e., nonlinear loads with the parallel combination of unknown constant impedance (Z), current (I) and power (P) components. More precisely, we propose a novel passifying input and a storage function based on the so-called mixed potential function introduced by Brayton and Moser, leading to a novel passivity property with output port-variable equal to the first time derivative of the voltage. Differently from the existing results in the literature, where restrictive (suffi…
This paper presents a novel grid-forming voltage control strategy for a battery energy storage system to maintain balanced three-phase output voltages when serving unbalanced loads. A stationary reference frame ($αβ$) based control scheme is proposed to regulate positive-sequence and negative-sequence voltages. Compared with the conventional rotating reference frame ($dq$) based control scheme, the proposed scheme shows better dynamic performance. Then, we analyze the system zero-sequence network and propose adding a grounding transformer to the Y/Yg connected output transformer to further red…
In this work, we present a novel consensus-based secondary control scheme for current sharing and voltage balancing in DC microgrids, composed of distributed generation units, dynamic RLC lines, and nonlinear ZIE (constant impedance, constant current, and exponential) loads. Situated atop a primary voltage control layer, our secondary controllers have a distributed structure, and utilize information exchanged over a communication network to compute necessary control actions. Besides showing that the desired objectives are always attained in steady state, we deduce sufficient conditions for the…
The effective way of energy transmission plays a key factor in improving the overall transmission systems efficiency. Many methods are proposed to control the reactive power flow, voltage fluctuations and power factor improvement, The proposed converter topology gives a much significant improvement in transmission systems performance which includes multistage transformers control with the controlled converters along with the series active filters. The overall control strategy which involves the Multistage Voltage Re-Injection Transformer Controlled Converters (MSVRITCC) to reinject the voltage…
A voltage regulation method for slow voltage variations at distribution level is proposed, based on a view of the loads, generators and storage along a distribution line as point weights. The "centers of mass" of the absorbed and injected currents (loads & generation, respectively) are compensated by minimizing the distance between them, through proper re-dispatching of the power of the available units and interruptible loads. The technique is recursively applied to lesser parts of the distribution line to address local phenomena and is assumed to be offered as ancillary service to the system …
Rapid developments in power distribution systems and renewable energy have widened the applications of dc--dc buck--boost converters in dc voltage regulation. Applications include vehicular power systems, renewable energy sources that generate power at a low voltage, and dc microgrids. It is noted that the cascade--connection of converters in these applications may cause instability due to the fact that converters acting as loads have a constant power load (CPL) behavior. In this paper, the output voltage regulation problem of a buck--boost converter feeding a CPL is addressed. The constructio…
In recent times, non-intrusive load monitoring (NILM) has emerged as an important tool for distribution-level energy management systems owing to its potential for energy conservation and management. However, load monitoring in smart building environments is challenging due to high variability of real-time load and varied load composition. Furthermore, as the volume and dimensionality of smart meters data increases, accuracy and computational time are key concerning factors. In view of these challenges, this paper proposes an improved NILM technique using multi-head (Mh-Net) convolutional neura…
In this paper, the power response of power electronic loads in case of voltage drops are measured and their dynamics are analysed. Based on this, dynamic simulation models are derived which can be used for voltage stability investigations. For this, four loads with different power factor techniques are considered. In addition, the impact of the grid impedance and input filter on the power response are measured in the laboratory. Based on the measurements, the simulation models are described. It is also outlined under which aspects the components of the loads are normally dimensioned if no deta…
Dynamic Voltage Restorer (DVR), for some important reasons, is utilized in Power Distribution for protecting loads especially critical loads against some power quality issues like sag, swell, harmonics and faults. Fast transient response for compensating voltage quality is an unavoidable factor. Different control topologies have been applied to this device. In this project, a DVR is deployed to preserve a critical load that is connected in parallel with the grid and A wind turbine. Several situations of power quality issues have been considered. The simulation results of a proposed system that…
Long, lightly loaded feeders serving residential loads may begin to experience voltage excursions as plug-in electric vehicle (PEV) penetration increases. Residential PEV charging tends to occur during peak-load hours on residential feeders, leading to increased peak loads and potential voltage excursions. To avoid voltage excursions, two PEV charging control strategies were investigated using the IEEE 34-bus feeder. The first strategy shifts PEV charging energy from peak hours to off-peak hours; the other strategy allows PEVs to provide reactive power support. Undervoltage excursions seen in …
Voltage collapse is a type of blackout-inducing dynamic instability that occurs when power demand exceeds the maximum power that can be transferred through a network. The traditional (preventive) approach to avoid voltage collapse is based on ensuring that the network never reaches its maximum capacity. However, such an approach leads to inefficient use of network resources and does not account for unforeseen events. To overcome this limitation, this paper seeks to initiate the study of voltage collapse stabilization, i.e., the design of load controllers aimed at stabilizing the point of volta…
In this paper, the impact of stochastic load and renewable generation uncertainty on the dynamic voltage stability margin is studied. Stochastic trajectories describing the uncertainty of load, wind and solar generation have been incorporated in the power system model as a set of Stochastic Differential-Algebraic Equations (SDAEs). A systematic study of Monte Carlo dynamic simulations on the IEEE 39-Bus system has been conducted to compute the stochastic load margin with all dynamic components active. Numerical results show that the uncertainty of both demand and generation may lead to a decre…
Direct Current (DC) power distribution has gained attention in the Residential Nanogrids (RNGs) due to the substantial increase in the number of roof-top Photovoltaic (PV) systems and internally DC appliances used in buildings. Using DC distribution improves the efficiency of the RNGs compared to AC distribution. This paper investigated the efficiency of a DC RNG for low and high distribution voltage levels by exploring reasons for power losses. The studied DC RNG consisted of various types of local loads, on-site PV generation, and battery storage systems. The realistic load, PV profiles, and…
In this paper we consider the problem of voltage regulation of a proton exchange membrane fuel cell connected to an uncertain load through a boost converter. We show that, in spite of the inherent nonlinearities in the current-voltage behaviour of the fuel cell, the voltage of a fuel cell/boost converter system can be regulated with a simple proportional-integral (PI) action designed following the {Passivity-based Control (PBC) approach. The system under consideration consists of a DC-DC converter interfacing a fuel cell with a resistive load. We show that the output voltage of the converter c…
Voltage and Frequency Stability Analysis of Transmission Power Grids with EV Charging Stations
King Fahd University of Petroleum & Minerals (KFUPM)（国王法赫德石油与矿物大学）；Interdisciplinary Research Center for Sustainable Energy Systems (IRC-SES), KFUPM（可持续能源系统交叉研究中心）；SDAIA-KFUPM Joint Research Center for Artificial Intelligence, KFUPM（沙特数据与人工智能局-国王法赫德石油与矿物大学人工智能联合研究中心）；Georgia Institute of Technology（佐治亚理工学院）；RMIT University（皇家墨尔本理工大学）
Emergency control, typically such as under-voltage load shedding (UVLS), is broadly used to grapple with low voltage and voltage instability issues in practical power systems under contingencies. However, existing emergency control schemes are rule-based and cannot be adaptively applied to uncertain and floating operating conditions. This paper proposes an adaptive UVLS algorithm for emergency control via deep reinforcement learning (DRL) and expert systems. We first construct dynamic components for picturing the power system operation as the environment. The transient voltage recovery criteri…
Comparison between Conventional Load Flow, QSTS Simulation, and Dynamic Simulation to Assess the Operation of Step Voltage Regulators in Active Distribution Networks
Due to market, there is flexibility in the price for power purchase by the utility. At the maximum loading condition the cost of power is high, hence conservation voltage reduction (CVR) is a useful technique in reducing power demand of the distribution system. Further, by installing battery energy storage system (BESS) in the distribution system, power can be stored in the BESS when the price is low and can be utilize to supply the demand when the price is high. In this paper, power conserving and cost saving problems are investigated. As we consider loads in distribution system as voltage de…
The adoption of distributed energy resources such as photovoltaics (PVs) has increased dramatically during the previous decade. The increased penetration of PVs into distribution networks (DNs) can cause voltage fluctuations that have to be mitigated. One of the key utility assets employed to this end are step-voltage regulators (SVRs). It is desirable to include tap selection of SVRs in optimal power flow (OPF) routines, a task that turns out to be challenging because the resultant OPF problem is nonconvex with added complexities stemming from accurate SVR modeling. While several convex relax…
The complexity arising in AC microgrids from multiple interacting distributed generation units (DGUs) with intermittent supply behavior requires local voltage-source inverters (VSIs) to be controlled in a distributed or decentralized manner at primary level. In (Strehle et al., 2019), we use passivity theory to design decentralized, plug-and-play voltage and frequency controllers for such VSIs. However, the stability analysis of the closed-loop system requires a load-connected topology, in contrast to real grids where loads are arbitrarily located. In this paper, we expand our former approach …
In this two-part paper we develop a unifying framework for the analysis of the feasibility of the power flow equations for DC power grids with constant-power loads. In Part I of this paper we present a detailed introduction to the problem of power flow feasibility of such power grids, and the associated problem of selecting a desirable operating point which satisfies the power flow equations. We introduce and identify all long-term voltage semi-stable operating points, and show that there exists a one-to-one correspondence between such operating points and the constant power demands for which …
Assessing strategies to manage distributed photovoltaics in Swiss low-voltage networks: An analysis of curtailment, export tariffs, and resource sharing
