Simulating inhomogeneous flows with different characteristic scales in different coordinate directions using the collide-and-stream based lattice Boltzmann methods (LBM) can be accomplished efficiently using rectangular lattice grids. We develop and investigate a new rectangular central moment LBM based on non-orthogonal moment basis (referred to as RC-LBM). The equilibria to which the central moments relax under collision in this approach are obtained from matching with those corresponding to the continuous Maxwell distribution. A Chapman-Enskog analysis is performed to derive the correction terms to the second order moment equilibria involving the grid aspect ratio and velocity gradients that restores the isotropy of the viscous stress tensor and eliminates the non-Galilean invariant cubic velocity terms of the resulting hydrodynamical equations. A special case of this rectangular formulation involving the raw moments (referred to as the RNR-LBM) is also constructed. The resulting schemes represent a considerable simplification, especially for the transformation matrices and isotropy corrections, and improvement over the existing MRT-LB schemes on rectangular lattice grids that use orthogonal moment basis. Numerical validation study of both the RC-LBM and RNR-LBM for a variety of benchmark flow problems are performed that show good accuracy at various grid aspect ratios. The ability of our proposed schemes to simulate flows using relatively lower grid aspect ratios than considered in prior rectangular LB approaches is demonstrated. Furthermore, simulations reveal the superior stability characteristics of the RC-LBM over RNR-LBM in handling shear flows at lower viscosities and/or higher characteristic velocities. In addition, computational advantages of using our rectangular LB formulation in lieu of that based on the square lattice is shown.
Wall-driven flow in square cavity has been studied extensively, yet it is more frequently for the rectangular cavity flow occurring in practical problems, and some flow characteristics about rectangular cavity have not been fully investigated. As a promising numerical simulation tool, the Lattice Boltzmann Method (LBM) is employed to simulate the lid-driven flow in a two-dimensional rectangular cavity in this paper. First, the code is validated for the standard square cavity, the velocity profiles, stream function values and center positions of the primary and second vortexes at different Re a…
Simulating mobile liquid-gas interfaces with the free-surface lattice Boltzmann method (FSLBM) requires frequent re-initialization of fluid flow information in computational cells that convert from gas to liquid. The corresponding algorithm, here referred to as the refilling scheme, is crucial for the successful application of the FSLBM in terms of accuracy and numerical stability. This study compares five refilling schemes that extract information from the surrounding liquid and interface cells by averaging, extrapolating, or assuming one of the three different equilibrium states. Six numeric…
In this paper, we propose a lattice Boltzmann (LB) model to solve the coupled Cahn-Hilliard-Navier-Stokes equations. Differently from previous efforts, the LB equation for the fluid velocity is decomposed in a space of non-orthogonal central moments where the surface tension force is inserted directly in the equilibrium state. The present scheme is validated against well-consolidated benchmark tests, showing very good accuracy. Moreover, it outperforms the BGK approach in terms of stability, as our algorithm allows us to simulate a very large range of viscosity contrast.
An iterative scheme can be used to find a steady-state solution to the Boltzmann equation, however, it is very slow to converge in the near-continuum flow regime. In this paper, a synthetic iterative scheme is developed to speed up the solution of the linearized Boltzmann equation. The velocity distribution function is first solved by the conventional iterative scheme, then it is corrected such that the macroscopic flow velocity is governed by a diffusion equation which is asymptotic-preserving in the Navier-Stokes limit. The efficiency of the new scheme is verified by calculating the eigenval…
We propose a single-step simplified lattice Boltzmann algorithm capable of performing magnetohydrodynamic (MHD) flow simulations in pipes for very small values of magnetic Reynolds numbers $R_m$. In some previous works, most lattice Boltzmann simulations are performed with values of $R_m$ close to the Reynolds numbers for flows in simplified rectangular geometries. One of the reasons is the limitation of some traditional lattice Boltzmann algorithms in dealing with situations involving very small magnetic diffusion time scales associated with most industrial applications in MHD, which require …
The accuracy of the free-surface lattice Boltzmann method (FSLBM) depends significantly on the boundary condition employed at the free interface. Ideally, the chosen boundary condition balances the forces exerted by the liquid and gas pressure. Different variants of the same boundary condition are possible, depending on the number and choice of the particle distribution functions (PDFs) to which it is applied. This study analyzes and compares four variants, in which (i) the boundary condition is applied to all PDFs oriented in the opposite direction of the free interface's normal vector, inclu…
This paper presents a numerical approximation technique for the Boltzmann equation based on a moment system approximation in velocity dependence and a discontinuous Galerkin finite-element approximation in position dependence. The closure relation for the moment systems derives from minimization of a suitable ϕ-divergence. This divergence-based closure yields a hierarchy of tractable symmetric hyperbolic moment systems that retain the fundamental structural properties of the Boltzmann equation. The resulting combined discontinuous Galerkin moment method corresponds to a Galerkin approximation …
The cascaded or central-moments-based lattice Boltzmann method (CM-LBM) is a robust alternative to the more conventional BGK-LBM for the simulation of high-Reynolds number flows. Unfortunately, its original formulation makes its extension to a broader range of physics quite difficult. To tackle this issue, a recent work [A. De Rosis, Phys. Rev. E 95, 013310 (2017)] proposed a more generic way to derive concise and efficient three-dimensional CM-LBMs. Knowing the original model also relies on central moments that are derived in an adhoc manner, i.e., by mimicking those of the Maxwell-Boltzmann …
Lattice Boltzmann (LB) models used for the computation of fluid flows represented by the Navier-Stokes (NS) equations on standard lattices can lead to non-Galilean invariant (GI) viscous stress involving cubic velocity errors. This arises from the dependence of their third order diagonal moments on the first order moments for standard lattices, and strategies have recently been introduced to restore GI without such errors using a modified collision operator involving either corrections to the relaxation times or to the moment equilibria. Convergence acceleration in the simulation of steady flo…
A double-distribution-function based lattice Boltzmann method (DDF-LBM) is proposed for the simulation of polyatomic gases in the supersonic regime. The model relies on an extended equilibrium state that is constructed to reproduce the first 13 moments of the Maxwell-Boltzmann distribution exactly. This extends the validity of the standard 5-constraint (mass, momentum and energy) approach and leads to the correct simulation of thermal, compressible flows with only 39 discrete velocities in 3D. The stability of this BGK-LBM is reinforced by relying on Knudsen-number-dependent relaxation times t…
We develop a lattice Boltzmann (LB) model for immiscible two-phase flow simulations with central moments (CMs). This successfully combines a three-dimensional nonorthogonal CM-based LB scheme [A. De Rosis, Phys. Rev. E 95, 013310 (2017)] with our previous color-gradient LB model [S. Saito, Y. Abe, and K. Koyama, Phys. Rev. E 96, 013317 (2017)]. Hydrodynamic melt-jet breakup simulations show that the proposed model is significantly more stable, even for flow with extremely high Reynolds numbers, up to $O(10^6)$. This enables us to investigate the phenomena expected under actual reactor conditio…
In Molnár et al. [Phys. Rev. D 93, 114025 (2016)] the equations of anisotropic dissipative fluid dynamics were obtained from the moments of the Boltzmann equation based on an expansion around an arbitrary anisotropic single-particle distribution function. In this paper we make a particular choice for this distribution function and consider the boost-invariant expansion of a fluid in one dimension. In order to close the conservation equations, we need to choose an additional moment of the Boltzmann equation. We discuss the influence of the choice of this moment on the time evolution of fluid-dy…
A cascaded lattice Boltzmann (LB) approach based on central moments and multiple relaxation times to simulate thermal convective flows, which are driven by buoyancy forces and/or swirling effects, in the cylindrical coordinate system with axial symmetry is presented. In this regard, the dynamics of the axial and radial momentum components along with the pressure are represented by means of the 2D Navier-Stokes equations with geometric mass and momentum source terms in the pseudo Cartesian form, while the evolutions of the azimuthal momentum and the temperature field are each modeled by an adve…
In the present study, the ionic transport and selectivity of electrokinetically-driven flow of power-law fluids in a long pH-regulated rectangular nanochannel are analyzed. The electrical potential and momentum equations are numerically solved through a finite difference procedure for a non-uniform grid. Non-linear Poisson-Boltzmann equation along with the association/dissociation reactions on the surface is considered. In addition, numerical simulations with the finite element method in 3D space are performed to compare the results with those obtained from 2D analysis. Moreover, an analytical…
Extensions to the Navier-Stokes-Fourier Equations for Rarefied Transport: Variational Multiscale Moment Methods for the Boltzmann Equation
Oden Institute for Computational Sciences and Engineering, University of Texas at Austin（德克萨斯大学奥斯汀分校奥登计算科学与工程研究所）；Department of Mechanical Engineering, Eindhoven University of Technology（埃因霍温理工大学机械工程系）
Modelling the vascular transport and adhesion of man-made particles is crucial for optimizing their efficacy in the detection and treatment of diseases. Here, a Lattice Boltzmann and Immersed Boundary methods are combined together for predicting the near wall dynamics of particles with different shapes in a laminar flow. For the lattice Boltzmann modelling, a Gauss-Hermite projection is used to derive the lattice equation, wall boundary conditions are imposed through the Zou-He framework, and a moving least squares algorithm accurately reconstructs the forcing term accounting for the immersed …
We present a new 3D lattice Boltzmann (LB) algorithm based on central moments for the D3Q27 lattice using a cuboid grid, which is parameterized by two grid aspect ratios that are related to the ratios of the particle speeds with respect to that along a reference coordinate direction. The use of the cuboid lattice grid enables the method to compute flows having different characteristic length scales in different directions more efficiently. It is constructed to simulate the Navier-Stokes equations consistently via introducing counteracting corrections to the second order moment equilibria obtai…
Lattice Boltzmann method (LBM) has been applied to predict flow properties of porous media including intrinsic permeability, where it is implicitly assumed that the LBM is equivalent to the incompressible (or near incompressible) Navier-Stokes equation. However, in LBM simulations, high-order moments, which are completely neglected in the Navier-Stokes equation, are still available through particle distribution functions. To ensure that the LBM simulation is correctly working at the Navier-Stokes hydrodynamic level, the high-order moments have to be negligible. This requires that the Knudsen n…
We derive the equations of motion of relativistic, non-resistive, second-order dissipative magnetohydrodynamics from the Boltzmann equation using the method of moments. We assume the fluid to be composed of a single type of point-like particles with vanishing dipole moment or spin, so that the fluid has vanishing magnetization and polarization. In a first approximation, we assume the fluid to be non-resistive, which allows to express the electric field in terms of the magnetic field. We derive equations of motion for the irreducible moments of the deviation of the single-particle distribution …
A plethora of active matter models exist that describe the behavior of self-propelled particles (or swimmers), both with and without hydrodynamics. However, there are few studies that consider shape-anisotropic swimmers and include hydrodynamic interactions. Here, we introduce a simple method to simulate self-propelled colloids interacting hydrodynamically in a viscous medium using the lattice-Boltzmann technique. Our model is based on raspberry-type viscous coupling and a force/counter-force formalism which ensures that the system is force free. We consider several anisotropic shapes and char…
