从稳态频率响应测量值估算实验色散曲线
Estimating Experimental Dispersion Curves from Steady-State Frequency Response Measurements
摘要:
色散曲线表征了传播弹性波的相速度和群速度的频率依赖性。许多分析和数值技术从基于物理的模型产生色散曲线。然而,它往往是具有复杂的几何特征和不均匀的材料特性的工程结构的精确建模是具有挑战性的。针对这种情况,本文提出了一种新的方法来估计群速度从实验数据驱动的模型。实验频率响应函数(FRF)用于开发数据驱动模型,{然后用于估计色散曲线}。这种方法的优势,其他传统上使用的瞬态技术源于只需要进行稳态实验。相比之下,瞬态实验通常需要更高的采样率波传播应用,更容易受到噪声的影响。采用矢量拟合(VF)算法从一维结构的实验面内和面外FRF开发数据驱动模型。相应的数据驱动的估计的质量进行了评估,使用分析作为基线的鲁棒性梁。数据驱动模型(使用面外FRF)估计反对称($A_0$)群速度,在40 kHz频带上的最大误差为$4\%$。与此相反,从瞬态实验估计的群速度导致在同一频带上的最大误差为$6\%$。
英文摘要:
Dispersion curves characterize the frequency dependence of the phase and the group velocities of propagating elastic waves. Many analytical and numerical techniques produce dispersion curves from physics-based models. However, it is often challenging to accurately model engineering structures with intricate geometric features and inhomogeneous material properties. For such cases, this paper proposes a novel method to estimate group velocities from experimental data-driven models. Experimental frequency response functions (FRFs) are used to develop data-driven models, {which are then used to estimate dispersion curves}. The advantages of this approach over other traditionally used transient techniques stem from the need to conduct only steady-state experiments. In comparison, transient experiments often need a higher-sampling rate for wave-propagation applications and are more susceptible to noise. The vector-fitting (VF) algorithm is adopted to develop data-driven models from experimental in-plane and out-of-plane FRFs of a one-dimensional structure. The quality of the corresponding data-driven estimates is evaluated using an analytical Timoshenko beam as a baseline. The data-driven model (using the out-of-plane FRFs) estimates the anti-symmetric ($A_0$) group velocity with a maximum error of $4\%$ over a 40~kHz frequency band. In contrast, group velocities estimated from transient experiments resulted in a maximum error of $6\%$ over the same frequency band.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。