With the increasing development of Internet of Things (IoT), the upcoming sixth-generation (6G) wireless network is required to support grant-free random access of a massive number of sporadic traffic devices. In particular, at the beginning of each time slot, the base station (BS) performs joint activity detection and channel estimation (JADCE) based on the received pilot sequences sent from active devices. Due to the deployment of a large-scale antenna array and the existence of a massive number of IoT devices, conventional JADCE approaches usually have high computational complexity and need long pilot sequences. To solve these challenges, this paper proposes a novel deep learning framework for JADCE in 6G wireless networks, which contains a dimension reduction module, a deep learning network module, an active device detection module, and a channel estimation module. Then, prior-feature learning followed by an adaptive-tuning strategy is proposed, where an inner network composed of the Expectation-maximization (EM) and back-propagation is introduced to jointly tune the precision and learn the distribution parameters of the device state matrix. Finally, by designing the inner layer-by-layer and outer layer-by-layer training method, a feature-aided adaptive-tuning deep learning network is built. Both theoretical analysis and simulation results confirm that the proposed deep learning framework has low computational complexity and needs short pilot sequences in practical scenarios.
We propose an improved soft-aided decoding scheme for product codes that approaches the decoding performance of conventional soft-decision TPD with only a 0.2 dB gap while keeping the complexity and internal decoder data flow similarly low as in hard decision decoders.
In this paper, we investigate the performance of a three-node dual-hop cognitive radio network (CRN) with a half-duplex (HD) decode-and-forward (DF) buffer-aided relay. We derive expressions for the average rate and symbol error rate (SER) performance of an adaptive link selection based channel-aware buffer-aided relay (CABR) scheme that imposes peak-power and peak-interference constraints on the secondary nodes, and compare them with those of conventional non-buffer-aided relay (CNBR) and conventional buffer-aided relay (CBR) schemes for a delay-tolerant system. For finite-delay systems, we a…
Lattice reduction (LR) aided multiple-input-multiple-out (MIMO) linear detection can achieve the maximum receive diversity of the maximum likelihood detection (MLD). By emloying the most commonly used Lenstra, Lenstra, and L. Lovasz (LLL) algorithm, an equivalent channel matrix which is shorter and nearly orthogonal is obtained. And thus the noise enhancement is greatly reduced by employing the LR-aided detection. One problem is that the LLL algorithm can not guarantee to find the optimal basis. The optimal lattice basis can be found by the Korkin and Zolotarev (KZ) reduction. However, the KZ …
Energy harvesting (EH) nodes can play an important role in cooperative communication systems which do not have a continuous power supply. In this paper, we consider the optimization of conventional and buffer-aided link adaptive EH relaying systems, where an EH source communicates with the destination via an EH decode-and-forward relay. In conventional relaying, source and relay transmit signals in consecutive time slots whereas in buffer-aided link adaptive relaying, the state of the source-relay and relay-destination channels determines whether the source or the relay is selected for transmi…
We investigate the performance of a two-hop cognitive relay network with a buffered decode and forward (DF) relay. We derive expressions for the rate performance of an adaptive link selection-based buffered relay (ALSBR) scheme with peak power and peak interference constraints on the secondary nodes, and compare its performance with that of conventional unbuffered relay (CUBR) and conventional buffered relay (CBR) schemes. Use of buffered relays with adaptive link selection is shown to be particularly advantageous in underlay cognitive radio networks. The insights developed are of significance…
We consider a simple network consisting of a source, a half-duplex DF relay with a buffer, and a destination. We assume that the direct source-destination link is not available and all links undergo fading. We propose two new buffer-aided relaying schemes. In the first scheme, neither the source nor the relay have CSIT, and consequently, both nodes are forced to transmit with fixed rates. In contrast, in the second scheme, the source does not have CSIT and transmits with fixed rate but the relay has CSIT and adapts its transmission rate accordingly. In the absence of delay constraints, for bot…
We propose a regularized zero-forcing transmit precoding (RZF-TPC) aided and distance-based adaptive coding and modulation (ACM) scheme to support aeronautical communication applications, by exploiting the high spectral efficiency of large-scale antenna arrays and link adaption. Our RZF-TPC aided and distance-based ACM scheme switches its mode according to the distance between the communicating aircraft. We derive the closed-form asymptotic signal-to-interference-plus-noise ratio (SINR) expression of the RZF-TPC for the aeronautical channel, which is Rician, relying on a non-centered channel m…
Unmanned aerial vehicle (UAV) as an aerial base station is a promising technology to rapidly provide wireless connectivity to ground users. Given UAV's agility and mobility, a key question is how to adapt UAV deployment to best cater to the instantaneous wireless traffic in a territory. In this paper, we propose an adaptive deployment scheme for a UAV-aided communication network, where the UAV adapts its displacement direction and distance to serve randomly moving users' instantaneous traffic in the target cell. In our adaptive scheme, the UAV does not need to learn users' exact locations in r…
We consider a bidirectional network in which two users exchange information with the help of a buffer-aided relay. In such a network without direct link between user 1 and user 2, there exist six possible transmission modes, i.e., four point-to-point modes (user 1-to-relay, user 2-to-relay, relay-to-user 1, relay-to-user 2), a multiple access mode (both users to the relay), and a broadcast mode (the relay to both users). Because of the buffering capability at the relay, the transmissions in the network are not restricted to adhere to a predefined schedule, and therefore, all the transmission m…
In this paper, we consider a simple network consisting of a source, a half-duplex decode-and-forward relay, and a destination. We propose a new relaying protocol employing adaptive link selection, i.e., in any given time slot, based on the channel state information of the source-relay and the relay-destination link a decision is made whether the source or the relay transmits. In order to avoid data loss at the relay, adaptive link selection requires the relay to be equipped with a buffer such that data can be queued until the relay-destination link is selected for transmission. We study both d…
In this work we propose an adaptive buffer-aided space-time coding scheme for cooperative wireless networks. A maximum likelihood receiver and adjustable code vectors are considered subject to a power constraint with an amplify-and-forward cooperation strategy. Each multiple-antenna relay is equipped with a buffer and is capable of storing the received symbols before forwarding them to the destination. We also present an adaptive relay selection and optimization algorithm, in which the instantaneous signal to noise ratio in each link is calculated and compared at the destination. An adjustable…
In this paper, we consider the problem of sum rate maximization in a bidirectional relay network with fading. Hereby, user 1 and user 2 communicate with each other only through a relay, i.e., a direct link between user 1 and user 2 is not present. In this network, there exist six possible transmission modes: four point-to-point modes (user 1-to-relay, user 2-to-relay, relay-to-user 1, relay-to-user 2), a multiple access mode (both users to the relay), and a broadcast mode (the relay to both users). Most existing protocols assume a fixed schedule of using a subset of the aforementioned transmis…
This paper considers an active intelligent reflecting surface (IRS)-aided wireless powered communication network (WPCN), where devices first harvest energy and then transmit information to a hybrid access point (HAP). Different from the existing works on passive IRS-aided WPCNs, this is the first work that introduces the active IRS in WPCNs. To guarantee fairness, the problem is formulated as an amplifying power-limited weighted sum throughput (WST) maximization problem, which is solved by successive convex approximation technique and fractional programming alternatively. To balance the perfor…
This work proposes adaptive buffer-aided distributed space-time coding schemes and algorithms with feedback for wireless networks equipped with buffer-aided relays. The proposed schemes employ a maximum likelihood receiver at the destination and adjustable codes subject to a power constraint with an amplify-and-forward cooperative strategy at the relays. Each relay is equipped with a buffer and is capable of storing blocks of received symbols and forwarding the data to the destination if selected. Different antenna configurations and wireless channels, such as static block fading channels, are…
In this letter, we explore the performance limits of short polar codes and find that the maximum likelihood (ML) performance of a simple CRC-polar concatenated scheme can approach the finite blocklength capacity. Then, in order to approach the ML performance with a low average complexity, a CRC-aided hybrid decoding (CA-HD) algorithm is proposed and its decoding process is divided into two steps. In the first step, the received sequence is decoded by the adaptive successive cancellation list (ADSCL) decoding. In the second step, CRC-aided sphere decoding with a reasonable initial radius is use…
In this paper, we propose a new dynamic IRS beamforming framework to boost the sum throughput of an intelligent reflecting surface (IRS) aided wireless powered communication network (WPCN). Specifically, the IRS phase-shift vectors across time and resource allocation are jointly optimized to enhance the efficiencies of both downlink wireless power transfer (DL WPT) and uplink wireless information transmission (UL WIT) between a hybrid access point (HAP) and multiple wirelessly powered devices. To this end, we first study three special cases of the dynamic IRS beamforming,namely user-adaptive I…
We consider the uplink of a cloud radio access network (C-RAN), where massive MIMO remote radio heads (RRHs) serve as relays between users and a centralized baseband unit (BBU). Although employing massive MIMO at RRHs can improve the spectral efficiency, it also significantly increases the amount of data transported over the fronthaul links between RRHs and BBU, which becomes a performance bottleneck. Existing fronthaul compression methods for conventional C-RAN are not suitable for the massive MIMO regime because they require fully-digital processing and/or real-time full channel state inform…
Nagoya Institute of Technology（名古屋工业大学）；RIKEN Center for Advanced Intelligence Project（理化学研究所先进智能项目中心）；Osaka City University（大阪市立大学）
The paper presents a deep learning-aided iterative detection algorithm for massive overloaded MIMO systems. Since the proposed algorithm is based on the projected gradient descent method with trainable parameters, it is named as trainable projected descent-detector (TPG-detector). The trainable internal parameters can be optimized with standard deep learning techniques such as back propagation and stochastic gradient descent algorithms. This approach referred to as data-driven tuning brings notable advantages of the proposed scheme such as fast convergence. The numerical experiments show that …
This paper investigates the secure communication in a two-hop cooperative wireless network, where a buffer-aided relay is utilized to forward data from the source to destination, and a passive eavesdropper attempts to intercept data transmission from both the source and relay. Depending on the availability of instantaneous channel state information of the source, two cases of transmission mechanisms, i.e., adaptive-rate transmission and fixed-rate transmission are considered. To enhance the security of the system, novel link selection policies are proposed for both cases to select source-to-re…
Seoul National University of Science and Technology（首尔科学技术大学）
In this study, we consider the application of deep learning (DL) to tabu search (TS) detection in large multiple-input multiple-output (MIMO) systems. First, we propose a deep neural network architecture for symbol detection, termed the fast-convergence sparsely connected detection network (FS-Net), which is obtained by optimizing the prior detection networks called DetNet and ScNet. Then, we propose the DL-aided TS algorithm, in which the initial solution is approximated by the proposed FS-Net. Furthermore, in this algorithm, an adaptive early termination algorithm and a modified searching pr…
Anchor-Aided Multi-User Semantic Communication with Adaptive Decoders
School of Computing, Kyung Hee University（庆熙大学计算机学院）；University of Houston（休斯顿大学）；Department of Computer Science and Engineering, Kyung Hee University（庆熙大学计算机科学与工程系）
University of Macau（澳门大学）；National University of Singapore（新加坡国立大学）
Intelligent reflecting surface (IRS) is an enabling technology to engineer the radio signal prorogation in wireless networks. By smartly tuning the signal reflection via a large number of low-cost passive reflecting elements, IRS is capable of dynamically altering wireless channels to enhance the communication performance. It is thus expected that the new IRS-aided hybrid wireless network comprising both active and passive components will be highly promising to achieve a sustainable capacity growth cost-effectively in the future. Despite its great potential, IRS faces new challenges to be effi…
Intelligent reflecting surface (IRS) has emerged as a promising technique for wireless communication networks. By dynamically tuning the reflection amplitudes/phase shifts of a large number of passive elements, IRS enables flexible wireless channel control and configuration, and thereby enhances the wireless signal transmission rate and reliability significantly. Despite the vast literature on designing and optimizing assorted IRS-aided wireless systems, prior works have mainly focused on enhancing wireless links with single signal reflection only by one or multiple IRSs, which may be insuffic…
