An ability of different molecular potentials to reproduce the properties of 2D molybdenum disulphide polymorphs is examined. Structural and mechanical properties, as well as phonon dispersion of the 2H, 1T and 1T' single-layer MoS2 (SL MoS2) phases, were obtained using density functional theory (DFT) and molecular statics calculations (MS) with Stillinger-Weber, REBO, SNAP, and ReaxFF potentials. Quantitative systematic comparison and discussion of the results obtained are reported.
Two-dimensional molybdenum disulphide on graphene grown by chemical vapour deposition is a promising van der Waals system for applications in optoelectronics and catalysis. To extend the fundamental understanding of growth and intrinsic properties of molybdenum disulphide on graphene, molybdenum disulphide on highly oriented pyrolytic graphite is a suitable model system. Here we show, experimentally and by density-functional-theory calculations, that molybdenum disulphide flakes grow in two orientations. One of the orientations is energetically preferred, the other one is rotated by 30 degree.…
The present paper deals with the systematic growth of plasmonic gold nanoparticles (Au NPs) on molybdenum disulphide (MoS$_2$) nanosheets as well as the effect of Au NPs on the optical and magnetic properties. The crystalline nature of the nanocomposites is confirmed by X-ray diffraction and transmission electron microscopic techniques. The optical properties are characterized using absorption and Raman spectroscopic techniques. The electron paramagnetic resonance technique is used to study the magnetic response of the nanocomposites. The paper attempts to gain a fundamental understanding of t…
Thermal transport in single layer molybdenum disulfide (MoS2) is critical to advancing its applications. In this paper, we use molecular dynamics (MD) simulations with first-principles force constants to study the isotope effect on the thermal transport of single layer MoS2. Through phonon modal analysis, we found that isotopes can strongly scatter phonons with intermediate frequencies, and the scattering behavior can be radically different from that predicted by conventional scattering model based on perturbation theory (Tamura's formula). Such a discrepancy becomes smaller for low isotope co…
A plethora of different morphologies are fabricated by the self assembly of molybdenum disulphide (MoS2) exfoliated flakes with the help of Langmuir-Blodgett (LB) technique at the liquid/air interface. The MoS2 flakes are chemically exfoliated in various solvents but their stable sheet like assembly on substrate is achieved only in case of the flakes exfoliated in dimethylformamide. The density of the monolayer sheets is finely controlled by the surface pressure while the stabilization of MoS2 LB film onto the water subphase results in its self assembly into diffusion limited cluster aggregate…
We study the phonon modes in single-walled MoS$_{2}$ nanotubes via the lattice dynamics calculation and molecular dynamics simulation. The phonon spectra for tubes of arbitrary chiralities are calculated from the dynamical matrix constructed by the combination of an empirical potential with the conserved helical quantum numbers $(κ, n)$. In particular, we show that the frequency ($ω$) of the radial breathing mode is inversely proportional to the tube diameter ($d$) as $ω=665.3/d$ {cm$^{-1}$}. The eigen vectors of the first twenty lowest-frequency phonon modes are illustrated. Based on these ei…
Here, the synthesis of Molybdenum Disulphide (MoS2) flakes by means of anodic atmospheric arc discharge is reported for the first time. The vertical electrode configuration consisted of a compound anode (hollow graphite anode filled with MoS2 powder) and a solid graphite cathode placed just above of the compound anode. Arc processes were operated in pulsed mode to preferentially evaporate the powder component from the anode and to minimize Carbon ablation. Pulsed anodic arc discharges were conducted at 2 Hz and 10% duty cycle in 300 Torr of Helium with a peak current of 250-300 A and peak volt…
Transition metal dichalcogenides exhibit rich phase diagrams dominated by the interplay of superconductivity and charge density waves, which often result in anomalies in the electric transport properties. Here, we employ the ionic gating technique to realize a tunable, non-volatile organic ion intercalation in bulk single crystals of molybdenum disulphide (MoS$_{2}$). We demonstrate that this gate-driven organic ion intercalation induces a strong electron doping in the system without changing the pristine $2H$ crystal symmetry and triggers the emergence of a re-entrant insulator-to-metal trans…
The two-dimensional transition-metal dichalcogenides (2D TMDCs) are an intriguing platform for studying light-matter interactions because they combine the electronic properties of conventional semiconductors with the optical resonances found in organic systems. However, the coupling strengths demonstrated in strong exciton-polariton coupling remain much lower than those found in organic systems. In this paper, we take on a new approach by utilizing the large oscillator strength of the above-band gap C exciton in few-layer molybdenum disulphide ($\text{FL-MoS}_2$). We show a k-space Rabi splitt…
We present a parameterization of the Stillinger-Weber potential to describe the interatomic interactions within single-layer MoS2 (SLMoS2). The potential parameters are fitted to an experimentally-obtained phonon spectrum, and the resulting empirical potential provides a good description for the energy gap and the crossover in the phonon spectrum. Using this potential, we perform classical molecular dynamics simulations to study chirality, size, and strain effects on the Young's modulus and the thermal conductivity of SLMoS2. We demonstrate the importance of the free edges on the mechanical an…
Molybdenum Disulphide (MoS2) is an interesting material which exists in atomically thin multilayers and can be exfoliated into monolayer or a few layers for multiple applications. It has emerged as a promising material for development of such efficient sensors. Here, we have exfoliated and decorated MoS2 flakes with novel, single phase High Entropy Alloy (HEA) nanoparticles using facile and scalable cryomilling technique, followed by sonochemical method. It is found that the decoration of HEA nanoparticles impart surface enhanced Raman scattering effect and reduction in the work function of th…
We derive, from an empirical interaction potential, an analytic formula for the elastic bending modulus of single-layer MoS2 (SLMoS2). By using this approach, we do not need to define or estimate a thickness value for SLMoS2, which is important due to the substantial controversy in defining this value for two-dimensional or ultrathin nanostructures such as graphene and nanotubes. The obtained elastic bending modulus of 9.61 eV in SLMoS2 is significantly higher than the bending modulus of 1.4 eV in graphene, and is found to be within the range of values that are obtained using thin shell theory…
We investigate the valley related carrier dynamics in monolayer MoS2 using helicity resolved non-degenerate ultrafast pump-probe spectroscopy at the vicinity of the high-symmetry K point under the temperature down to 78 K. Monolayer MoS2 shows remarkable transient reflection signals, in stark contrast to bilayer and bulk MoS2 due to the enhancement of many-body effect at reduced dimensionality. The helicity resolved ultrafast time-resolved result shows that the valley polarization is preserved for only several ps before scattering process makes it undistinguishable. We suggest that the dynamic…
Atomically thin two-dimensional (2D) semiconductors such as molybdenum disulphide (MoS2) hold great promise in electrical, optical, and mechanical devices and display novel physical phenomena such as coupled spin-valley physics and the valley Hall effect. However, the electron mobility of mono- and few-layer MoS2 has so far been substantially below theoretically predicted limits, particularly at low temperature (T), which has hampered efforts to observe its intrinsic quantum transport behaviors. Potential sources of disorder and scattering include both defects such as sulfur vacancies in the M…
Organohalide perovskite with a variety of surface structures and morphologies have shown promising potential owing to the choice of the type of heterostructure dependent stability. We systematically investigate and discuss the impact of 2-dimensional molybdenum-disulphide (MoS2), molybdenum-diselenide (MoSe2), tungsten-disulphide (WS2), tungsten-diselenide (WSe2), boron- nitiride (BN) and graphene monolayers on band-gap and energy stability of organic-inorganic halide perovskites. We found that MAPbI3ML deposited on BN-ML shows room temperature stability (-25 meV~300K) with an optimal bandgap …
We use liquid phase exfoliation to produce dispersions of molybdenum disulphide (MoS2) nanoflakes in aqueous surfactant solutions. The chemical structures of the bile salt surfactants play a crucial role in the exfoliation and stabilization of MoS2. The resultant MoS2 dispersions are heavily enriched in single and few (<6) layer flakes with large edge to surface area ratio. We use the dispersions to fabricate free-standing polymer composite wide-band saturable absorbers to develop mode-locked and Q- switched fibre lasers, tunable from 1535-1565 and 1030-1070 nm, respectively. We attribute this…
We have decoupled the intrinsic optical and electrostatic effects arising in monolayer and few-layer molybdenum disulphide from those influenced by the flake-substrate interaction.
Precise manipulation of electronic band structures of two-dimensional (2D) transition metal dichalcogenides and oxides (TMD&Os) via localised strain engineering is an exciting avenue for exploiting their unique characteristics for electronics, optoelectronics, and nanoelectromechanical systems (NEMS) applications. This work experimentally demonstrates that mechanically-induced electrical transitions can be engineered in quasi-2D molybdenum disulphide (MoS2) and molybdenum trioxide (MoO3) using an in situ electrical nanoindentation technique. It is shown that localised strains on such quasi-2D …
We detect electroluminescence in single layer molybdenum disulphide (MoS2) field-effect transistors built on transparent glass substrates. By comparing absorption, photoluminescence, and electroluminescence of the same MoS2 layer, we find that they all involve the same excited state at 1.8eV. The electroluminescence has pronounced threshold behavior and is localized at the contacts. The results show that single layer MoS2, a direct band gap semiconductor, is promising for novel optoelectronic devices, such as 2-dimensional light detectors and emitters.
Molybdenum disulphide, a diamagnetic layered dichalcogenide solid, is found to show magnetic ordering at room temperature when exposed to a 2 MeV proton beam. The temperature dependence of magnetization displays ferrimagnetic behavior with a Curie temperature of 895 K. A disorder mode corresponding to a zone-edge phonon and a Mo valence higher than +4, have been detected in the irradiated samples using Raman and X-ray photoelectron spectroscopy, respectively. The possible origins of long-range magnetic ordering in irradiated MoS2 samples are discussed.
We report on the integration of monolayer molybdenum disulphide with silicon nitride microresonators assembled by visco-elastic layer transfer techniques. Evanescent coupling from the resonator mode to the monolayer is confirmed through measurements of cavity transmission. The absorption of the monolayer semiconductor flakes in this geometry is determined to be 850 dB/cm, which is larger than that of graphene and black phosphorus with the same thickness. This technique can be applied to diverse monolayer semiconductors for assembling hybrid optoelectronic devices such as photodetectors and mod…
We provide a simple and intuitive explanation for the interlayer sliding energy landscape of metal dichalcogenides. Based on the recently introduced registry index (RI) concept, we define a purely geometrical parameter which quantifies the degree of interlayer commensurability in the layered phase of molybdenum disulphide (2HMoS2). A direct relation between the sliding energy landscape and the corresponding interlayer registry surface of 2H-MoS2 is discovered thus marking the registry index as a computationally efficient means for studying the tribology of complex nanoscale material interfaces…
Research on graphene and other two-dimensional (2D) materials, such as silicene, germanene, phosphorene, hexagonal boron nitride (h-BN), graphitic carbon nitride (g-C3N4), graphitic zinc oxide (g-ZnO) and molybdenum disulphide (MoS2), has recently received considerable interest owing to their outstanding properties and wide applications. Looking beyond this field, combining the electronic structures of 2D materials in ultrathin van der Waals heterojunctions has also emerged to widely study theoretically and experimentally to explore some new properties and potential applications beyond their s…
Monolayer molybdenum disulphide (MoS$_2$) is a promising two-dimensional (2D) material for nanoelectronic and optoelectronic applications. The large-area growth of MoS$_2$ has been demonstrated using chemical vapor deposition (CVD) in a wide range of deposition temperatures from 600 °C to 1000 °C. However, a direct comparison of growth parameters and resulting material properties has not been made so far. Here, we present a systematic experimental and theoretical investigation of optical properties of monolayer MoS$_2$ grown at different temperatures. Micro-Raman and photoluminescence (PL) stu…
Hexagonal boron nitride is the only substrate that has so far allowed graphene devices exhibiting micron-scale ballistic transport. Can other atomically flat crystals be used as substrates for making quality graphene heterostructures? Here we report on our search for alternative substrates. The devices fabricated by encapsulating graphene with molybdenum or tungsten disulphides and hBN are found to exhibit consistently high carrier mobilities of about 60,000 cm$^{2}$V$^{-1}$s$^{-1}$. In contrast, encapsulation with atomically flat layered oxides such as mica, bismuth strontium calcium copper o…
