Biological measurements are often contaminated with large amounts of non-stationary noise which require effective noise reduction techniques. We present a new real-time deep learning algorithm which produces adaptively a signal opposing the noise so that destructive interference occurs. As a proof of concept, we demonstrate the algorithm's performance by reducing electromyogram noise in electroencephalograms with the usage of a custom, flexible, 3D-printed, compound electrode. With this setup, an average of 4dB and a maximum of 10dB improvement of the signal-to-noise ratio of the EEG was achieved by removing wide band muscle noise. This concept has the potential to not only adaptively improve the signal-to-noise ratio of EEG but can be applied to a wide range of biological, industrial and consumer applications such as industrial sensing or noise cancelling headphones.
Noise cancellation is one of the important signal processing functions of any communication system, as noise affects data integrity. In existing systems, traditional filters are used to cancel the noise from the received signals. These filters use fixed hardware which is capable of filtering specific frequency or a range of frequencies. However, next generation communication technologies, such as cognitive radio, will require the use of adaptive filters that can dynamically reconfigure their filtering parameters for any frequency. To this end, a few noise cancellation techniques have been prop…
One of the fundamental challenges affecting the performance of communication systems is the undesired impact of noise on a signal. Noise distorts the signal and originates due to several sources including, system non-linearity and noise interference from adjacent environment. Conventional communication systems use filters to cancel noise in a received signal. In the case of cognitive radio systems, denoising a signal is important during the spectrum sensing period, and also during communication with other network nodes. Based on our findings, few surveys are found that only review particular d…
Noise originating from several sources in a RF environment degrades the performance of communication systems. In wideband systems, such as cognitive radios, noise at the receiver can originate from non-linearity present in the RF front end, time-varying thermal noise within the receiver radio system, and noise from adjacent network nodes. Several denoising techniques have been proposed for cognitive radios, some of which are applied during spectrum sensing and others to received noisy signal during communication. Examples of some of these techniques used for noise cancellation in received sign…
With the crowding of the electromagnetic spectrum and the shrinking cell size in wireless networks, crosstalk between base stations and users is a major problem. Although hand-crafted functional blocks and coding schemes are proven effective to guarantee reliable data transfer, currently deep learning-based approaches have drawn increasing attention in the communication system modeling. In this paper, we propose a Neural Network (NN) based signal processing technique that works with traditional DSP algorithms to overcome the interference problem in realtime. This technique doesn't require any …
As the spectrum under 6 GHz is being depleted, pushing wireless communications onto millimeter wave (mmWave) frequencies is a trend that promises multi-Gbps data rate. mmWave is therefore considered as a key technology for 5G wireless systems and has attracted tremendous research efforts. The booming research on mmWave necessitates a reconfigurable mmWave testbed that can be used to prototype and validate new research ideas in real wireless environments. In this paper, we develop an easy-to-use mmWave testbed using commercial off-the-shelf devices (USRP and 60 GHz Tx/Rx RF frontends) and open-…
This paper examines the separation of wireless communication and radar signals, thereby guaranteeing cohabitation and acting as a panacea to spectrum sensing. First, considering that the channel impulse response was known by the receivers (communication and radar), we showed that the optimizing beamforming weights mitigate the interference caused by signals and improve the physical layer security (PLS) of the system. Furthermore, when the channel responses were unknown, we designed an interference filter as a low-complex noise and interference cancellation autoencoder. By mitigating the interf…
Simultaneous transmit and receive (STAR) allows full-duplex operation of a radio, which leads to doubled capacity for a given bandwidth. A circulator with high-isolation between transmit and receive ports, and low-loss from the antenna to receive port is typically required for achieving STAR. Conventional circulators do not offer wideband performance. Although wideband circulators have been proposed using parametric, switched delay-line/capacitor, and N-path filter techniques using custom integrated circuits, these magnet-free devices have non-linearity, noise, aliasing, and switching noise in…
End-to-End deep learning has shown promising results for speech enhancement tasks, such as noise suppression, dereverberation, and speech separation. However, most state-of-the-art methods for echo cancellation are either classical DSP-based or hybrid DSP-ML algorithms. Components such as the delay estimator and adaptive linear filter are based on traditional signal processing concepts, and deep learning algorithms typically only serve to replace the non-linear residual echo suppressor. This paper introduces an end-to-end echo cancellation network with a streaming cross-attention alignment (SC…
Active noise cancellation on open-ear smart glasses
Department of Electrical and Computer Engineering, Carnegie Mellon University（卡内基梅隆大学电气与计算机工程系）；Department of Medical Physics and Acoustics, Carl von Ossietzky Universität Oldenburg（奥尔登堡大学医学物理与声学系）；College of Computer Science and Technology, Zhejiang University（浙江大学计算机科学与技术学院）
Deep Active Speech Cancellation with Mamba-Masking Network
Blavatnik School of Computer Science Tel Aviv University（塔尔医学院计算机科学学院）；School of Electrical and Computer Engineering Ben-Gurion University of the Negev（本·古里安大学电气与计算机工程学院）
Weizmann Institute of Science（魏茨曼科学研究所）；Tsinghua University（清华大学）
Digital receivers are required to recover the transmitted symbols from their observed channel output. In multiuser multiple-input multiple-output (MIMO) setups, where multiple symbols are simultaneously transmitted, accurate symbol detection is challenging. A family of algorithms capable of reliably recovering multiple symbols is based on interference cancellation. However, these methods assume that the channel is linear, a model which does not reflect many relevant channels, as well as require accurate channel state information (CSI), which may not be available. In this work we propose a mult…
Echo and noise suppression is an integral part of a full-duplex communication system. Many recent acoustic echo cancellation (AEC) systems rely on a separate adaptive filtering module for linear echo suppression and a neural module for residual echo suppression. However, not only do adaptive filtering modules require convergence and remain susceptible to changes in acoustic environments, but this two-stage framework also often introduces unnecessary delays to the AEC system when neural modules are already capable of both linear and nonlinear echo suppression. In this paper, we exploit the offs…
Non-orthogonal communications are expected to play a key role in future wireless systems. In downlink transmissions, the data symbols are broadcast from a base station to different users, which are superimposed with different power to facilitate high-integrity detection using successive interference cancellation (SIC). However, SIC requires accurate knowledge of both the channel model and channel state information (CSI), which may be difficult to acquire. We propose a deep learningaided SIC detector termed SICNet, which replaces the interference cancellation blocks of SIC by deep neural networ…
Advances in Intelligent Hearing Aids: Deep Learning Approaches to Selective Noise Cancellation
Department of Electrical Engineering, National University of Sciences and Technology (NUST), Center for Excellence in Manufacturing Engineering (CEME)（电子工程系，国立科学与技术大学（NUST），制造工程卓越中心）
The ability to cancel an OFDM signal is important to many wireless communication systems including Power-Domain Non-orthogonal Multiple Access (PD-NOMA), Rate-Splitting Multiple Access (RSMA), and spectrum underlay for dynamic spectrum access. In this paper, we show that estimating the windowing applied at the transmitter is important to that cancellation. Windowing at the transmitter is a popular means to control the bandwidth of an Orthogonal Frequency Division Multiplexed (OFDM) symbol and is overlooked in most literature on OFDM signal cancellation. We show the limitation to the amount of …
