用于光伏和光电化学装置的$Mg_xZn_{1-x}O$与$CuGa_3Se_5$吸收体的接触
$Mg_xZn_{1-x}O$ contact to $CuGa_3Se_5$ absorber for photovoltaic and photoelectrochemical devices
摘要:
$CuGa_3Se_5$是一种很有前途的宽带隙材料,可用于串联光伏(PV)和光电化学(PEC)器件的顶电池。然而,与其他黄铜矿吸收剂一起使用的传统CdS接触层由于其导带最小值的较高位置而不适合于$CuGa_3Se_5$。$Mg_xZn_{1-x}O$是一种透明氧化物,其带隙和导带位置随镁组成而变化,但其直接应用受到$CuGa_3Se_5$表面氧化的阻碍。在此,研究了$Mg_xZn_{1-x}O$作为接触(n型缓冲或窗口)材料与在$Cd^{2+}$溶液中预处理的$CuGa_3Se_5$吸收剂的接触,并证明了在10 mM六氨氯化钌(III)电解质中相对于RHE接近1 V的起始电位。正如光电子能谱学测量所证明的那样,$Cd^{2+}$表面处理改变了$CuGa_3Se_5$表面的化学组成和电子结构。固态测试结构中具有经$Cd^{2+}$处理的表面的$CuGa_3Se_5$吸收体的性能取决于$Mg_xZn_{1-x}O$层中的Zn/Mg比。测量的接近1V的开路电压对于具有$CuGa_3Se_5$ / $Mg_xZn_{1-x}O$顶电池的串联PEC水裂解是有希望的。
英文摘要:
$CuGa_3Se_5$ is a promising candidate material with wide band gap for top cells in tandem photovoltaic (PV) and photoelectrochemical (PEC) devices. However, traditional CdS contact layers used with other chalcopyrite absorbers are not suitable for $CuGa_3Se_5$ due to the higher position of its conduction band minimum. $Mg_xZn_{1-x}O$ is a transparent oxide with adjustable band gap and conduction band position as a function of magnesium composition, but its direct application is hindered by $CuGa_3Se_5$ surface oxidation. Here, $Mg_xZn_{1-x}O$ is investigated as a contact (n-type buffer or window) material to $CuGa_3Se_5$ absorbers pretreated in $Cd^{2+}$ solution, and an onset potential close to 1 V vs RHE in 10 mM hexaammineruthenium (III) chloride electrolyte is demonstrated. The $Cd^{2+}$ surface treatment changes the chemical composition and electronic structure of the $CuGa_3Se_5$ surface, as demonstrated by photoelectron spectroscopy measurements. The performance of $CuGa_3Se_5$ absorber with $Cd^{2+}$ treated surface in the solid-state test structure depends on the Zn/Mg ratio in the $Mg_xZn_{1-x}O$ layer. The measured open circuit voltage close to 1 V is promising for tandem PEC water splitting with $CuGa_3Se_5$/$Mg_xZn_{1-x}O$ top cells.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。