复杂几何体中时间周期流动模拟的可扩展谱Stokes解算器
A scalable spectral Stokes solver for simulation of time-periodic flows in complex geometries
摘要:
复杂几何形状的非定常蠕动流的模拟传统上需要使用时间步进程序,这通常是昂贵的和不可扩展的。为了降低成本,并允许在更大的尺度上的计算,我们提出了一种替代方法,该方法是基于非稳态斯托克斯方程在时间谱域中表示。这种变换会产生一个具有与计算模式成比例的虚源项的边值问题,该问题在复值有限元求解器中使用Bubnov-Galerkin公式进行离散和求解。这种变换后的空间-光谱公式提出了几个优势,传统的时空技术。首先,对于边界条件随时间平滑变化的情况,它提供了显着的计算成本节省,因为它可以使用几个模式而不是数千个时间步长来解决解的时变。其次,与传统的有限阶精度的时间积分方法相比,该方法具有超收敛性。第三,与流体的稳定化有限元法相比,在我们的公式中没有使用稳定化项,从而产生一致且更精确的解。第四,由于求解模式的独立性,所提出的方法是可并行的,从而使可扩展的计算在一个更大的处理器数量。所提出的技术对一个标准的稳定的有限元求解器的比较使用二维和三维规范和复杂的几何形状。结果表明,所提出的方法可以产生更准确的结果,在1%至11%的标准技术的研究情况下。
英文摘要:
Simulation of unsteady creeping flows in complex geometries has traditionally required the use of a time-stepping procedure, which is typically costly and unscalable. To reduce the cost and allow for computations at much larger scales, we propose an alternative approach that is formulated based on the unsteady Stokes equation expressed in the time-spectral domain. This transformation results in a boundary value problem with an imaginary source term proportional to the computed mode that is discretized and solved in a complex-valued finite element solver using Bubnov-Galerkin formulation. This transformed spatio-spectral formulation presents several advantages over the traditional spatio-temporal techniques. Firstly, for cases with boundary conditions varying smoothly in time, it provides a significant saving in computational cost as it can resolve time-variation of the solution using a few modes rather than thousands of time steps. Secondly, in contrast to the traditional time integration scheme with a finite order of accuracy, this method exhibits a super convergence behavior versus the number of computed modes. Thirdly, in contrast to the stabilized finite element methods for fluid, no stabilization term is employed in our formulation, producing a solution that is consistent and more accurate. Fourthly, the proposed approach is embarrassingly parallelizable owing to the independence of the solution modes, thus enabling scalable calculations at a much larger number of processors. The comparison of the proposed technique against a standard stabilized finite element solver is performed using two- and three-dimensional canonical and complex geometries. The results show that the proposed method can produce more accurate results at 1% to 11% of the cost of the standard technique for the studied cases.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。