利用高速阴影成像技术,研究了球形大颗粒在静止高粘流体中的沉降过程和壁面碰撞。本研究中包含的颗粒在尺寸和材料特性上各不相同:钢、聚四氟乙烯(PTFE)、聚甲醛(POM)或橡胶。相应的终端雷诺数范围从333到4012,原则上涵盖了阻力的过渡区和牛顿区。对于碰撞研究,撞击前的斯托克斯数也是相关的,其范围为50 < St < 2250。实验得到的沉降曲线与数值和解析解进行了比较。后者是根据斯托克斯和牛顿体系的标称终极速度和弛豫时间推导出来的。在终端雷诺数大于300小于1100的所有情况下,实验结果和解析解之间的偏差观察。在这种流动状态下,球体的沉降过程在离撞击物体很远的地方就已经受到影响,导致早期但显著的减速。此外,对于具有最低末端雷诺数的PTFE颗粒,沿整个轨迹观察到沉降速度降低。所有经过处理的数据集都可以通过Mendeley数据库获得。在本研究中还观察到两个额外的影响。首先,在所有PTFE球周围检测到明亮区域。最后发现这是由于球体周围的全光反射,但据我们所知,这种特性以前从未报道过。由于是纯光学的,这不会影响PTFE的沉降行为。另一方面,部分吸收的液体在颗粒表面观察橡胶,导致降低沉降速度。
英文摘要:
The settling process and wall impact of large spherical particles in a stagnant, highly viscous fluid has been observed by means of high-speed shadow imaging. The particles included in this study vary in size and material properties: steel, polytetrafluorethylen (PTFE), polyoxymethylen (POM), or rubber. The corresponding terminal Reynolds numbers range from 333 to 4012, covering in principle the transitional and Newton regime for drag forces. For collision studies, the Stokes number just before impact is also relevant, and lies in the range 50 < St < 2250. The settling curves obtained experimentally are compared with numerical and analytical solutions. The latter has been derived on the basis of nominal terminal velocity and relaxation time for the Stokes and Newton regimes. A deviation between experimental results and analytical solution was observed in all cases where the terminal Reynolds number is larger than 300 and smaller than 1100. In this flow regime, the settling process of the spheres is already affected at a long distance from the impact object, leading to an early but significant deceleration. Moreover, a reduced settling velocity was observed along the whole trajectory for the PTFE particles with the lowest terminal Reynolds number. All processed datasets are available via the Mendeley Data repository. Two additional effects have been observed during this study. First, a bright region was detected around all PTFE spheres. It finally was found to be due to total light reflection around the sphere, but, to the best of our knowledge, this peculiarity has never been reported before. Being purely optical, this does not effect the settling behavior for PTFE. On the other hand, partial absorption of liquid at the particle surface was observed for rubber, leading to a reduced sedimentation velocity.
A Scalable OpenLB LAMMPS Framework for Fully Resolved Simulations of Hindered Settling of Arbitrary Non-Spherical Particles
State University of New York(纽约州立大学);Karlsruhe Institute of Technology(卡尔斯鲁厄理工学院);Jawaharlal Nehru Centre for Advanced Scientific Research(贾瓦哈拉尔·尼赫鲁高级科学研究中心)
Spatial and temporal scales of force and torque acting on wall-mounted spherical particles in open channel flow
来自在2900的整体雷诺数下几何粗糙壁上的明渠流的直接数值模拟的数据,由Chan-Braun等人[“Force and torque acting on particles in a transitionally rough open-channel flow”,J. Fluid Mech.684,441- 474(2011),10.1017/jfm.2011.311]中所述的方法,进一步分析了作用在壁装球体上的力和扭矩的时间和长度尺度。对于正方形布置的两种尺寸的球体(直径为11和49个壁单元,分别产生水力平滑和过渡粗糙流),研究了阻力、升力和展向扭矩的空间结构。给出了时间上的自相关和谱,以及时空相关和对流速度,并进行了讨论。发现展向质点扭矩的统计特性与光滑壁面处剪应力的统计特性相似。粒子阻力和升力被证明不同于展向粒子扭矩,表现出相当小的时间和长度尺度;阻力和升力的对流速度略大于展向扭矩。此外,流场和颗粒相关的量之间的相关性。流向速度和阻力/展向扭矩之间的相关性的空间结构的特征细长的形状,让人想起缓冲层条纹。压力场和颗粒阻力之间的相关性表现出两个相反的符号凸起的上游和下游侧的颗粒。
Coupled Metaball Discrete Element Lattice Boltzmann Method for Fluid-Particle Systems with non-spherical particle shapes: A sharp interface coupling scheme