Urban traffic congestion is a chronic problem faced by many cities. It is essentially inefficient infrastructure use which results in increased vehicle fuel consumption and emissions. This in turn adds extra costs to commuters and businesses. Addressing this issue is therefore of paramount interest due to the perceived dual benefit. Many technologies were and are being developed. These include adaptive traffic signals, dedicated lanes, etc. This paper presents a simple platooning algorithm that maintains relatively small distances (pre-specified time gap) between consecutive vehicles to enhance mobility, increase transportation capacity and ultimately reduce travel costs. Several dynamic and kinematic constraints governing the motion of vehicles are also accounted for. These include acceleration, velocity, and distance constraints. This developed logic was tested on highways that traverse the downtown area of Los Angeles. Depending on the market penetration rate of connected automated vehicles versus non-connected automated vehicles, a reduction in travel time, delay and fuel consumed across the city can be observed. Vehicles are expected to reach their destination in less travel time, delay and consumed fuel. The reduction percentages range from 0 to 5 percent, 0 to 9.4 percent, and 2.58 to 8.17 percent, respectively.
Cooperative driving, enabled by communication between automated vehicle systems, is expected to significantly contribute to transportation safety and efficiency. Cooperative Adaptive Cruise Control (CACC) and platooning are two of the main cooperative driving applications that are currently under study. These applications offer significant improvements over current advanced driver assistant systems such as adaptive cruise control (ACC). The primary motivation of CACC and Platooning is to reduce traffic congestion and improve traffic flow, traffic throughput, and highway capacity. These applica…
The unknown sharp changes of vehicle acceleration rates, also called the unknown jerk dynamics, may significantly affect the driving performance of the leader vehicle in a platoon, resulting in more drastic car-following movements in platooning tracking control, which could cause safety and traffic capacity concerns. To address these issues, in this paper, we investigate cooperative platooning tracking control and intermittent optimization problems for connected automated vehicles (CAVs) with a nonlinear car-following model. We assume that the external inputs of the leader CAV contain unknown …
Cooperative formation and control of autonomous vehicles (AVs) promise increased efficiency and safety on public roads. In mixed traffic flow consisting of AVs and human-driven vehicles (HDVs), the prevailing platooning of multiple AVs is not the only choice for cooperative formation. In this paper, we investigate how different formations of AVs impact traffic performance from a set-function optimization perspective. We first reveal a stability invariance property and a diminishing improvement property of noncooperative formation when AVs adopt typical Adaptive Cruise Control (ACC) strategies.…
Connectivity-enabled automation of distributed control systems allow for better anticipation of system disturbances and better prediction of the effects of actuator limitations on individual agents when incorporating a model. Automated convoy of heavy-duty trucks in the form of platooning is one such application designed to maintain close gaps between trucks to exploit drafting benefits and improve fuel economy, and has traditionally been handled with classically-designed connected and adaptive cruise control (CACC). This paper is motivated by demonstrated limitations of such a control strateg…
Safety is the foremost concern for autonomous platooning. The vehicle-to-vehicle (V2V) communication delay and the sudden appearance of obstacles will trigger the safety of the intended functionality (SOTIF) issues for autonomous platooning. This research proposes a holistic robust motion controller framework (MCF) for an intelligent and connected vehicle platoon system. The MCF utilizes a hierarchical structure to resolve the longitudinal string stability and the lateral control problem under the complex driving environment and time-varying communication delay. Firstly, the H-infinity feedbac…
In this paper, we study how to secure the platooning of autonomous vehicles when an unknown vehicle is under attack and bounded system uncertainties exist. For the attacked vehicle, its position and speed measurements from GPS can be manipulated arbitrarily by a malicious attacker. First, to find out which vehicle is under attack, two detectors are proposed by using the relative measurements (by camera or radar) and the local innovation obtained through measurements from neighboring vehicles. Then, based on the results of the detectors, we design a local state observer for each vehicle by appl…
We study how to design a secure observer-based distributed controller such that a group of vehicles can achieve accurate state estimates and formation control even if the measurements of a subset of vehicle sensors are compromised by a malicious attacker. We propose an architecture consisting of a resilient observer, an attack detector, and an observer-based distributed controller. The distributed detector is able to update three sets of vehicle sensors: the ones surely under attack, surely attack-free, and suspected to be under attack. The adaptive observer saturates the measurement innovatio…
Optimal distributed control for platooning via sparse coprime factorizations
Stevens Institute of Technology（史蒂文斯理工学院）；University “Politehnica” Bucharest（布加勒斯特理工大学）；Brigham Young University（杨百翰大学）；University of Pennsylvannia（宾夕法尼亚大学）
Experimentally-Driven Analysis of Stability in Connected Vehicle Platooning: Insights and Control Strategies
Department of Electrical Engineering and Automation, School of Electrical Engineering, Aalto University（艾尔沃大学电气工程与自动化系）；Department of Electrical and Computer Engineering, School of Engineering, University of Cyprus（塞浦路斯大学电气与计算机工程系）；FinEst Centre for Smart Cities, Tallinn, Estonia（爱沙尼亚塔林智能城市中心）
We study the strategic interaction among vehicles in a non-cooperative platoon coordination game. Vehicles have predefined routes in a transportation network with a set of hubs where vehicles can wait for other vehicles to form platoons. Vehicles decide on their waiting times at hubs and the utility function of each vehicle includes both the benefit from platooning and the cost of waiting. We show that the platoon coordination game is a potential game when the travel times are either deterministic or stochastic, and the vehicles decide on their waiting times at the beginning of their journeys.…
The scope of automotive functions has grown from a single-vehicle as an entity to multiple vehicles working together as an entity, referred to as cooperative driving. The current automotive safety standard, ISO 26262, is designed for single vehicles. With the increasing number of cooperative driving capable vehicles on the road, it is now imperative to systematically assess the functional safety of architectures of these vehicles. Many methods are proposed to assess architectures with respect to different quality attributes in the software architecture domain, but to the best of our knowledge,…
Cooperative Adaptive Cruise Control (CACC) is a fundamental connected vehicle application that extends Adaptive Cruise Control by exploiting vehicle-to-vehicle (V2V) communication. CACC is a crucial ingredient for numerous autonomous vehicle functionalities including platooning, distributed route management, etc. Unfortunately, malicious V2V communications can subvert CACC, leading to string instability and road accidents. In this paper, we develop a novel resiliency infrastructure, RACCON, for detecting and mitigating V2V attacks on CACC. RACCON uses machine learning to develop an on-board pr…
The problem of self-tuning control of cooperative manipulators forming a closed kinematic chain in the presence of an inaccurate kinematics model is addressed using adaptive machine learning. The kinematic parameters pertaining to the relative position/orientation uncertainties of the interconnected manipulators are updated online by two cascaded estimators in order to tune a cooperative controller for achieving accurate motion tracking with minimum-norm actuation force. This technique permits accurate calibration of the relative kinematics of the involved manipulators without needing high pre…
This paper presents a method for controlling the voltage of inverter-based Microgrids by proposing a new scale-free distributed cooperative controller. The communication network is modeled by a general time-varying graph which enhances the resilience of the proposed protocol against communication link failure, data packet loss, and fast plug and play operation in the presence of arbitrarily communication delays. The proposed scale-free distributed cooperative controller is independent of any information about the communication system and the size of the network (i.e., the number of distributed…
We consider the platoon matching problem for a set of trucks with the same origin, but different destinations. It is assumed that the vehicles benefit from traveling in a platoon for instance through reduced fuel consumption. The vehicles belong to different fleet owners and their strategic interaction is modeled as a non-cooperative game where the vehicle actions are their departure times. Each truck has a preferred departure time and its utility function is defined as the difference between its benefit from platooning and the cost of deviating from its preferred departure time. We show that …
