arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2006.07156physics.flu-dynphysics.ao-ph
收藏

城市高密度冠层上的边界层

Urban boundary layers over dense and tall canopies

Alexandros Makedonas, Matteo Carpentieri, Marco Placidi

摘要:

风洞实验进行了四个城市形态:两个高檐统一的高度和两个超高檐的元素高度变化很大(其中最大元素高度是两倍以上的平均檐高度,$h_{max}$ =2.5 $h_{avg}$)。{The平均冠层高度和堆积密度分别固定为$h_{avg} = 80$ mm和$λ_{p} = 0.44$。激光多普勒风速仪和直接阻力测量的组合被用来计算和标定平均速度剖面{在边界层深度内,$δ$ }。在均匀高度的实验中,高填充密度导致了一个“掠流”制度,很少有流量渗透到树冠。这导致了一个令人惊讶的浅粗糙子层($z\approx1.15h_{avg}$),以及在其上的一个定义明确的惯性子层。{在高度不均匀的冠层中,尽管堆积密度和平均高度相同,流动特征却明显不同。} {The高度的不均匀性增强了混合,从而促进了深层气流渗透到林冠中。发现存在更深的粗糙子层,并延伸至最高元件高度(对应于$z/h_{avg} = 2.85$)的正上方,发现其是控制流动行为的主要长度尺度。{结果表明,尽管表面粗糙度($δ/h_{avg} = 3 - 6.25$)严重,但本文考虑的所有表面均存在惯性子层}。这与以前的文献不同。

英文摘要:

Wind tunnel experiments were carried out on four urban morphologies: two tall canopies with uniform-height and two super-tall canopies with a large variation in element heights (where the maximum element height is more than double the average canopy height, $h_{max}$=2.5 $h_{avg}$). {The average canopy height and packing density were fixed across the surfaces to $h_{avg} = 80$ mm, and $λ_{p} = 0.44$, respectively.} A combination of laser doppler anemometry and direct drag measurements were used to calculate and scale the mean velocity profiles {within the boundary layer depth, $δ$}. In the uniform-height experiment, the high packing density resulted in a `skimming flow' regime with very little flow penetration into the canopy. This led to a surprisingly shallow roughness sublayer ($z\approx1.15h_{avg}$), and a well-defined inertial sublayer above it. {In the heterogeneous-height canopies, despite the same packing density and average height, the flow features were significantly different.} {The height heterogeneity enhanced mixing thus encouraging deep flow penetration into the canopy. A deeper roughness sublayer was found to exist and extend up to just above the tallest element height (corresponding to $z/h_{avg} = 2.85$)}, which was found to be the dominant lengthscale controlling the flow behaviour. {Results points toward the existence of an inertial sublayer for all surfaces considered herein despite the severity of the surface roughness ($δ/h_{avg} = 3 - 6.25$)}. This contrasts with previous literature.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑