Over the past several decades there has been a constant increase in the use of Unmanned Aerial Systems (UAS). Hence, there has also been a growth in the number of control algorithms to service the many applications embodied by these vehicles. Initially UAS were made popular by the military for Reconnaissance, Intelligence, Surveillance, and Target Acquisition (RISTA) applications. Now-a-days UAS are used for everything from crop surveys to tourism. Nowhere is this more evident than with multi-rotor Unmanned Aerial Vehicle (UAV). This paper presents a survey of control methods for multi-rotor systems, namely quadrotors. In doing so, we hope to visualize a clear path to what additional capabilities might be needed in the future. In our examination, we review many of the notable research organizations and their efforts to expand the utility of multirotor aircraft. We also summarize the basic literature definitions and control strategies for autonomous quadrotors.
King Fahd University of Petroleum and Minerals（法赫德石油和矿产大学）
In this work, the autonomous control of a quadrotor-manipulator unmanned aerial vehicle is treated using an extended dynamic model. Due to persistent aerodynamic disturbances and dynamic couplings, the control of a quadrotor-manipulator unit is cumbersome. Active disturbance rejection control (ADRC) is proposed for the cancellation of the undesirable dynamics while a PD controller is developed for set-point tracking. Parameters were tuned using Gradient Descent-Sequential Quadratic Programming in Simulink design optimization
School of Aeronautic Science and Engineering, Beihang University（北京航空航天大学航空科学与工程学院）；Research Institute for Frontier Science, Beihang University（北京航空航天大学前沿科学研究院）；School of Electronic and Information Engineering, Beihang University（北京航空航天大学电子信息工程学院）
The rapid development of unmanned aerial vehicles (UAV) puts forward a higher requirement for autonomous obstacle avoidance. Due to the limited payload and power supply, small UAVs such as quadrotors usually carry simple sensors and computation units, which makes traditional methods more challenging to implement. In this paper, a novel framework is demonstrated to control a quadrotor flying through crowded environments autonomously with monocular vision. The framework adopts a two-stage architecture, consisting of a sensing module and a decision module. The sensing module is based on an unsupe…
Autonomous landing on a moving platform presents unique challenges for multirotor vehicles, including the need to accurately localize the platform, fast trajectory planning, and precise/robust control. Previous works studied this problem but most lack explicit consideration of the wind disturbance, which typically leads to slow descents onto the platform. This work presents a fully autonomous vision-based system that addresses these limitations by tightly coupling the localization, planning, and control, thereby enabling fast and accurate landing on a moving platform. The platform's position, …
Many systems such as autonomous vehicles and quadrotors are subject to parametric uncertainties and external disturbances. These uncertainties can lead to undesired performance degradation and safety issues. Therefore, it is important to design robust control strategies to safely regulate the dynamics of a system. This paper presents a novel framework for chance-constrained stochastic model predictive control of dynamic systems with non-Gaussian correlated probabilistic uncertainties. We develop a new stochastic Galerkin method to propagate the uncertainties using a new type of basis functions…
Recently, Model Predictive Path Integral (MPPI) control algorithm has been extensively applied to autonomous navigation tasks, where the cost map is mostly assumed to be known and the 2D navigation tasks are only performed. In this paper, we propose a generic MPPI control framework that can be used for 2D or 3D autonomous navigation tasks in either fully or partially observable environments, which are the most prevalent in robotics applications. This framework exploits directly the 3D-voxel grid acquired from an on-board sensing system for performing collision-free navigation. We test the fram…
The controller for a quadrotor working in severe environment is developed in this study. Here, the severe environment indicates the temperature-varying air near the volcano. The controller overcomes the intensively changing temperature above the crater of the volcano which biases the nominal dynamics (25 Celcius). The target Volcano is picked as Satsuma-iojima located in a tiny insular South to the mainland of Japan. The temperature distribution is contributed from previous research by Geological Survey of Japan. To guarantee that the control signal is under the input saturation, a path planni…
This paper presents a novel trajectory tracker for autonomous quadrotor navigation in dynamic and complex environments. The proposed framework integrates a distributional Reinforcement Learning (RL) estimator for unknown aerodynamic effects into a Stochastic Model Predictive Controller (SMPC) for trajectory tracking. Aerodynamic effects derived from drag forces and moment variations are difficult to model directly and accurately. Most current quadrotor tracking systems therefore treat them as simple `disturbances' in conventional control approaches. We propose Quantile-approximation-based Dist…
On-ramp merging areas are typical bottlenecks in the freeway network, since merging on-ramp vehicles may cause intensive disturbances on the mainline traffic flow and lead to various negative impacts on traffic efficiency and safety. The connected and autonomous vehicles (CAVs), with their capabilities of real-time communication and precise motion control, hold a great potential to facilitate ramp merging operation through enhanced coordination strategies. This paper presents a comprehensive review of the existing ramp merging strategies leveraging CAVs, focusing on the latest trends and devel…
Real-time Neural-MPC: Deep Learning Model Predictive Control for Quadrotors and Agile Robotic Platforms
Munich Institute of Robotics and Machine Intelligence (MIRMI)（慕尼黑机器人与机器学习研究所（MIRMI））；Technical University of Munich（慕尼黑工业大学）；University of Zurich（苏黎世大学）；Stanford University（斯坦福大学）；NVIDIA Research（英伟达研究院）
Stability and safety are critical properties for successful deployment of automatic control systems. As a motivating example, consider autonomous mobile robot navigation in a complex environment. A control design that generalizes to different operational conditions requires a model of the system dynamics, robustness to modeling errors, and satisfaction of safety \NEWZL{constraints}, such as collision avoidance. This paper develops a neural ordinary differential equation network to learn the dynamics of a Hamiltonian system from trajectory data. The learned Hamiltonian model is used to synthesi…
In this paper, a comprehensive Eco-Driving strategy for CAVs is presented. In this setup, multiple driving modes calculate speed profiles ideal for their own set of constraints simultaneously to save fuel as much as possible, while a High Level (HL) controller ensures smooth transitions between the driving modes for Eco-Driving. This Eco-Driving deterministic controller for an ego CAV was equipped with Vehicle-to-Infrastructure (V2I) and Vehicle-to-Vehicle (V2V) algorithms. Simulation results are used to show that the HL controller ensures significant fuel economy improvement as compared to ba…
