Magneli phases of titanium dioxide (such as Ti4O7, Ti5O9, etc.) provide electronic properties, namely a stable metallic behavior at room temperature. In this manuscript, we demonstrate that nanoscopic Magneli phases, formed intrinsically in anatase during a thermal aerosol synthesis, can enable significant photocatalytic H2 generation. This without the use of any extrinsic co-catalyst in anatase. Under optimized conditions, mixed phase particles of 30 percent anatase, 25 percent Ti4O7 and 20 percent Ti5O9 are obtained that can provide, under solar light, direct photocatalytic H2 evolution at a rate of 145 micromol h-1 g-1. These anatase particles contain 5-10 nm size inter-grown phases of Ti4O7 and Ti5O9. Key is the metallic band of Ti4O7 that induces a particle internal charge separation and transfer cascade with suitable energetics and favorable dimensions that are highly effective for H2 generation.
Defined substoichiometric titanium oxides (Ti$_x$O$_{2x-1}$ with $3 < x < 10$) called Magneli phases have been investigated mostly for their unusual high conductivity and metal-like behavior. In photocatalysis, Magneli phase containing titania particles have been reported to provide favorable charge separation resulting in enhanced reaction efficiency. In the current work we describe a one-step synthesis of Magneli-containing mixed phase nanoparticles that carry directly integrated minute amounts of Pt. Phase optimized nanoparticles that contain only a few hundred ppm Pt are very effective pho…
Magneli phase Ti5O9 ceramics with 200-nm grain-size were fabricated by hot-pressing nanopowders of titanium and anatase TiO2 at 1223 K. The thermoelectric properties of these ceramics were investigated from room temperature to 1076 K. We show that the experimental variation of the electrical conductivity with temperature follows a small-polaron model and that the Seebeck coefficient can be explained by a temperature-dependent Heikes-Chaikin-Beni model. The thermoelectric figure-of-merit ZT of this nanoceramic material reaches 0.3 at 1076 K.
Band alignment effects of anatase and rutile nanocrystals in TiO$_2$ powders lead to an electron hole separation, increasing the photo catalytic efficiency of these powders. While size effects and types of possible alignments have been extensively studied, the effect of interface geometries of bonded nanocrystal structures on the alignment is poorly understood. In order to allow conclusive studies of a vast variety of bonded systems in different orientations, we have developed a new density functional tight binding parameter set to properly describe quantum confinement in nanocrystals. Applyin…
Here we investigate the band-level energetics of "black" hydrogenated titania in different polymorphs using in-situ photoelectrochemical measurements and XPS valence band measurements. We find that the conduction band of black rutile is higher in energy than in black anatase by 0.4 eV. For photocatalytic hydrogen generation, in a polymorph hetero-junction such as in black Degussa P25, thus black rutile can act as a photosensitizer while black anatase provides charge-mediation catalysis onto H2O to generate H2. By optimizing the thermal reduction conditions of black anatase/rutile junctions the…
In this work, we demonstrate that a well-established and facile ball milling approach using mixtures of commercial anatase nanoparticles and TiH2 introduces noble-metal-free photocatalytic H2 activity to titania. We characterize this synergistic effect in view of the nature of defects, state of hydroxylation, and investigate the effect on the energetics and kinetics of electronic states and the resulting H2 evolution performance.
Knowledge of the molecular frontier levels' alignment in the ground state can be used to predict the photocatalytic activity of an interface. The position of the adsorbate's highest occupied molecular orbital (HOMO) levels relative to the substrate's valence band maximum (VBM) in the interface describes the favorability of photogenerated hole transfer from the VBM to the adsorbed molecule. This is a key quantity for assessing and comparing H$_2$O photooxidation activities on two prototypical photocatalytic TiO$_2$ surfaces: anatase (A)-TiO$_2$(101) and rutile (R)-TiO$_2$(110). Using the projec…
The efforts in the optimization of the physical and chemical properties related to the photocatalytic efficiency of TiO2 nanoparticles relies mainly on defect engineering strategies, been the structural and the doping the most common ones. The doping of the anatase TiO2 structure with lanthanides elements potentially can turns the TiO2 optical absorption into the visible range increasing drastically its photocatalytic efficiency. Here we show that the processing of TiO2 nanoparticles in oxygen atmosphere and the La doping stabilizes the anatase phase. The La incorporation takes place mainly in…
Copper dopants are varyingly reported to enhance photocatalytic activity at titanium dioxide surfaces through uncertain mechanisms. In order to interpret how copper doping might alter the performance of titanium dioxide photocatalysts in aqueous media we applied density functional theory methods to simulate surface units of doped anatase (101) planes. By including van der Waals interactions, we consider the energetics of adsorbed water at anatase surfaces in pristine and copper doped systems. Simulation results indicate that copper dopant at anatase (101) surfaces is most stable in a 2+ oxidat…
"Black" TiO2 has gained increasing interest because of its outstanding properties and promising applications in a wide range of fields. Among the outstanding features of the material is that certain synthesis processes lead to the formation of an intrinsic co-catalytic center and thus enable noble-metal free photocatalytic H2 generation. In this work, we report "grey TiO2" by an appropriate hydrogenation treatment exhibits excellent photocatalytic hydrogen. In this case, by the employment of thermally stable and high-surface-area TiO2 nanoparticles as well as mesoporous particles as the hydrog…
TiO$_2$ and SrTiO$_3$ are well known materials in the field of photocatalysis due to their exceptional electronic structure, high chemical stability, non-toxicity and low cost. However, owing to the wide band gap, these can be utilized only in the UV region. Thus, it's necessary to expand their optical response in visible region by reducing their band gap through doping with metals, nonmetals or the combination of different elements, while retaining intact the photocatalytic efficiency. We report here, the codoping of a metal and a nonmetal in anatase TiO$_2$ and SrTiO$_3$ for efficient photoc…
In the present work, a simple strategy is used to thermally oxidize TiN nanopowder (ca. 20 nm) to an anatase phase of a TiO2:Ti3+:N compound. In contrast to the rutile phase of such a compound this photocatalyst provides photocatalytic activity for hydrogen evolution under AM1.5 conditions - this without the use of any noble metal co-catalyst. Moreover the photocatalyst is active and stable over extended periods of time (tested for 4 months). Importantly, to achieve successful conversion to the active anatase polymorph, sufficiently small starting particles of TiN are needed. The key factor fo…
In the present work we use TiO2 nanotube arrays, carrying a Pt coating that is optimally dewetted, as a photocatalyst to generate H2. In order to achieve a maximum H2-generation efficiency, on the one hand an ideal thermal dewetting of the Pt layer into nanoparticles is needed that requires an oxygen free heat treatment, and on the other hand an optimal crystallization of the TiO2 nanotubes into anatase with reduced defect density is achieved only by annealing in O2 containing environment. To overcome this issue, we combine adequate reducing and oxidizing conditions in a multiple annealing tre…
Thin TiO2 films on quartz substrates were prepared by spin coating of undoped and metal-ion-doped Sol Gel precursors. These films were characterised by Scanning Electron Microscopy, Laser Raman Microspectroscopy, Xray Diffraction and UV Vis Transmission. The photocatalytic performances of the films were assessed by the photo-degradation of methylene-blue in aqueous solution under UV irradiation. Films exhibited a high degree of orientation and a thermal stabilization of the anatase phase as a result of substrate effects. In the absence of dopants, the rutile phase formed as parallel bands in t…
Titanium dioxide materials have been studied intensively and extensively due to photocatalytic applications. A long-standing open question is the energy band alignment of rutile and anatase TiO2 phases, which can affect the photocatalytic process in the composite system. There are basically two contradictory viewpoints about the alignment of these two TiO2 phases supported by respective experiments: 1) straddling type and 2) staggered type. In this work, our DFT plus U calculations find that the perfect rutile (110) and anatase (101) surfaces have the straddling type band alignment, whereas th…
In the present work, extended Argon ion bombardment was used to modify anatase TiO2 nanotube (NTs) layers. In situ X-ray photoelectron spectroscopy revealed a high content of sub-oxide formed (Ti3+, Ti2+ states) in the nanotube layers. These samples were tested for their ability to show open-circuit photocatalytic hydrogen evolution. We found for UV (cw laser 325nm) illumination as well as for AM1.5 conditions, a strongly enhanced H2 evolution activity in absence of the usual noble metal-nanoparticle decoration. We conclude therefore that these sub-oxide states can play an important role in th…
Reduced titanium dioxide has recently attracted large attention, particularly for its unique co-catalyst-free H$_2$ heterogeneous photocatalytic application. The enhanced photocatalytic activity of the reduced TiO$_2$ was previously ascribed to the introduction of point crystal defects (mainly Ti$_3^+$ centers), which result in the formation of intrinsic co-catalytic centers and enhanced visible light absorption. In this work, we systematically investigate the effect of different defects in the TiO$_{2-x}$ lattice on photocatalytic H$_2$ evolution. To introduce different types of defects, ther…
We use density functional theory (DFT) calculations to investigate structural models consisting of anatase TiO2(101) slabs covered by reduced overlayers formed by (101) crystallographic shear planes (CSPs). Ab initio thermodynamics supports the stability of these structures under a wide range of experimental conditions. The overlayers are found to have Ti2O3 stoichiometry with a crystal structure different from the known corundum-like Ti2O3 (here denoted α-Ti2O3) phase. DFT calculations predict this new "csp-Ti2O3" phase to be energetically close to α-Ti2O3 and to have also a similar band gap.…
In this study, we investigate noble metal free photocatalytic water splitting on natural anatase single crystal facets and on wafer slices of the [001] plane before and after these surfaces have been modified by high pressure hydrogenation (HPH) and hydrogen ion-implantation. We find that on the natural, intact low index planes photocatalytic H$_2$ evolution (in absence of noble metal co-catalyst) can only be achieved when the hydrogenation treatment is accompanied by the introduction of crystal damage, such as simple scratching, miscut in the wafer or by implantation damage. X-ray reflectivit…
Nanotubed titanic acid (H2Ti2O4(OH)2) was prepared from nanotubed sodium titanate (Na2Ti2O4(OH)2) by an ion exchange reaction in a pH=1 HCl solution. The effect of annealing temperature on the morphology, structure and photocatalytic behavior of nanotubed H2Ti2O4(OH)2 was studied by means of TEM, XRD, DTG, DSC, BET and ESR. The results showed that nanotubed H2Ti2O4(OH)2 is thermally unstable. Its dehydration consists of two steps. In the first-step dehydration, single-electron-trapped oxygen vacancies (SETOVs) were generated. Accompanying the second-step dehydration, the transition of crystal …
Brookite TiO2 as an active photocatalyst for photoconversion of plastic wastes to acetic acid and simultaneous hydrogen production: Comparison with anatase and rutile
A literature-grounded scientific reasoning framework for defect-engineered TiO$_{2}$ photocatalysts
National Centre for Nuclear Research, NOMATEN CoE（国家核研究中心，NOMATEN中心）；Military University of Technology, Institute of Applied Physics, Solid State Physics Department（军事科技大学，应用物理研究所，固体物理系）
