Compute-and-forward (CPF) strategy is one category of network coding in which a relay will compute and forward a linear combination of source messages according to the observed channel coefficients, based on the algebraic structure of lattice codes. Recently, based on the idea of CPF, integer forcing (IF) linear receiver architecture for MIMO system has been proposed to recover different integer combinations of lattice codewords for further original message detection. In this paper, we consider the problem of IF linear receiver design with respect to the channel conditions. Instead of exhaustive search, we present practical and efficient suboptimal algorithms to design the IF coefficient matrix with full rank such that the total achievable rate is maximized, based on the slowest descent method. Numerical results demonstrate the effectiveness of our proposed algorithms.
A multiple-input multiple-output wireless communication system is analytically studied, which operates with the aid of a large-scale reconfigurable intelligent surface (LRIS). LRIS is equipped with multiple passive elements with discrete phase adjustment capabilities, and independent Rician fading conditions are assumed for both the transmitter-to-LRIS and LRIS-to-receiver links. A direct transceiver link is also considered which is modeled by Rayleigh fading distribution. The system performance is analytically studied when the linear yet efficient zero-forcing detection is implemented at the …
In this letter, we propose three linear receivers including Bussgang-based Maximal Ratio Combining (BMRC), Bussgang-based Zero-Forcing (BZF), and Bussgang-based Minimum Mean Squared Error (BMMSE) for massive MIMO systems with one-bit analog-to-digital converters (ADCs). Closed-form expressions of the proposed receivers are obtained by using the Bussgang decomposition to cope with the non-linear effect of the one-bit ADCs. Simulation results show significantly lower bit error rate floors obtained by the proposed receivers than those of conventional linear receivers.
Orthogonal time-frequency space (OTFS) scheme, which transforms a time and frequency selective channel into an almost non-selective channel in the delay-Doppler domain, establishes reliable wireless communication for high-speed moving devices. This work designs and analyzes low-complexity zero-forcing (LZ) and minimum mean square error (LM) receivers for multiple-input multiple-output (MIMO)-OTFS systems with perfect and imperfect receive channel state information (CSI). The proposed receivers provide exactly the same solution as that of the conventional counterparts, and reduce the complexity…
Despite the extensive use of a centralized approach to design receivers at the base station for massive multiple-input multiple-output (M-MIMO) systems, their actual implementation is a major challenge due to several bottlenecks imposed by the large number of antennas. One way to deal with this problem is by fully decentralizing the classic zero-forcing receiver across multiple processing nodes based on the gradient descent method. In this paper, we first explicitly relate this decentralized receiver to a distributed version of the Kaczmarz algorithm and to the use of the successive interferen…
Massive multiple-input-multiple-output (M-MIMO) features a capability for spatial multiplexing of large number of users. This number becomes even more extreme in extra-large (XL-MIMO), a variant of M-MIMO where the antenna array is of very large size. Yet, the problem of signal processing complexity in M-MIMO is further exacerbated by the XL size of the array. The basic processing problem boils down to a sparse system of linear equations that can be addressed by the randomized Kaczmarz (RK) algorithm. This algorithm has recently been applied to devise low-complexity M-MIMO receivers; however, …
In this paper we consider the uplink of a massive MIMO communication system using 5G New Radio-compliant multiple access, which is to co-exist with a radar system using the same frequency band. We propose a system model taking into account the reverberation (clutter) produced by the radar system at the massive MIMO receiver. Then, we propose several linear receivers for uplink data-detection, ranging by the simple channel-matched beamformer to the zero-forcing and linear minimum mean square error receivers for clutter disturbance rejection. Our results show that the clutter may have a strong e…
We address the resilience of future 6G MIMO communications by considering an uplink scenario where multiple legitimate transmitters try to communicate with a base station in the presence of an adversarial jammer. The jammer possesses full knowledge about the system and the physical parameters of the legitimate link, while the base station only knows the UL-channels and the angle-of-arrival (AoA) of the jamming signals. Furthermore, the legitimate transmitters are oblivious to the fact that jamming takes place, thus the burden of guaranteeing resilience falls on the receiver. For this case we d…
The conventional receiver designs of generalized frequency division multiplexing (GFDM) consider a large scale multiple-input multiple-output (MIMO) system with a block circular matrix of combined channel and modulation. Exploiting this structure, several approaches have been proposed for low complexity joint linear minimum mean squared error (LMMSE) receiver. However, the joint design is complicated and inappropriate for hardware implementation. In this paper, we define the concept of GFDM-based linear receivers, which first performs channel equalization (CEq) and afterwards the equalized sig…
In a massive MIMO system with large arrays, the channel becomes spatially non-stationary. We study the impact of spatial non-stationarity characterized by visibility regions (VRs) where the channel energy is significant on a portion of the array. Relying on a channel model based on VRs, we provide expressions of the signal-to-interference-plus-noise ratio (SINR) of conjugate beamforming (CB) and zero-forcing (ZF) precoders. We also provide an approximate deterministic equivalent of the SINR of ZF precoders. We identify favorable and unfavorable multi-user configurations of the VRs and compare …
Multi-input multi-output orthogonal frequency division multiplexing (MIMO OFDM) is a key technology for mobile communication systems. However, due to the issue of high peak-to-average power ratio (PAPR), the OFDM symbols may suffer from nonlinear distortions of the power amplifier (PA) at the transmitters, which degrades the channel estimation and detection performances of the receivers. To mitigate the clipping distortions at the receivers end, we leverage deep learning (DL) and devise a DL based receiver which is aided by the traditional least square (LS) channel estimation and the zero-forc…
A Framework for Uplink ISAC Receiver Designs: Performance Analysis and Algorithm Development
National Mobile Communications Research Laboratory, Southeast University（东南大学移动通信国家重点实验室）；Purple Mountain Laboratories（紫金山实验室）；School of Electronic Information and Communication, Huazhong University of Science and Technology (HUST)（华中科技大学电子信息与通信学院）
We consider a massive MIMO system where the array at the access point reaches a dimension that is much larger than the array in current systems. Transitioning to an extremely large dimension and hence large number of antennas implies a need to scale up the multi-antenna processing while maintaining a reasonable computational complexity. In this paper, we study the receiver of such an extra-large scale MIMO (XL-MIMO) system. We propose to base the reception on Variational Message Passing (VMP). The motivation is that the complexity of VMP scales (almost) linearly with the number of antennas and…
Data-dependent superimposed training (DDST) scheme has shown the potential to achieve high bandwidth efficiency, while encounters symbol misidentification caused by hardware imperfection. To tackle these challenges, a joint model and data driven receiver scheme is proposed in this paper. Specifically, based on the conventional linear receiver model, the least squares (LS) estimation and zero forcing (ZF) equalization are first employed to extract the initial features for channel estimation and data detection. Then, shallow neural networks, named CE-Net and SD-Net, are developed to refine the c…
This paper aims to handle the joint transmitter and noncoherent receiver design for multiuser multiple-input multiple-output (MU-MIMO) systems through deep learning. Given the deep neural network (DNN) based noncoherent receiver, the novelty of this work mainly lies in the multiuser waveform design at the transmitter side. According to the signal format, the proposed deep learning solutions can be divided into two groups. One group is called pilot-aided waveform, where the information-bearing symbols are time-multiplexed with the pilot symbols. The other is called learning-based waveform, wher…
This paper considers the uplink of a massive MIMO communication system using 5G New Radio-compliant multiple access, which is to co-exist with a radar system using the same frequency band. A system model taking into account the reverberation (clutter) produced by the radar system onto the massive MIMO receiver is proposed. In this scenario, several receivers for uplink channel estimation and data detection are proposed, ranging from the simple channel-matched beamformer to the zero-forcing and linear minimum mean square error receivers for clutter disturbance rejection, under the two opposite …
This paper considers the application of widely linear (WL) receivers in an uplink multi-user system using real-valued modulation schemes, where the cellular base station (BS) with multiple antennas provides connectivity for randomly deployed single-antenna users. The targeted use case is massive machine type communication (mMTC) with grant-free access in the uplink, where the network is required to host a large number of low data rate devices transmitting in an uncoordinated fashion. Four types of WL receivers are investigated, namely the WL zero-forcing (ZF) and the WL minimum meansquared err…
We study the design of receivers in extra-large scale MIMO (XL-MIMO) systems, i.e. systems in which the base station is equipped with an antenna array of extremely large dimensions. While XL-MIMO can significantly increase the system's spectral efficiency, they present two important challenges. One is the increased computational cost of the multi-antenna processing. The second is the variations of user energy distribution over the antenna elements and therefore spatial non-stationarities in these energy distributions. Such non-stationarities limit the performance of the system. In this paper, …
This paper considers uplink massive multiple-input multiple-output (MIMO) systems with lowresolution analog-to-digital converters (ADCs) over Rician fading channels. Maximum-ratio-combining (MRC) and zero-forcing (ZF) receivers are considered under the assumption of perfect and imperfect channel state information (CSI). Low-resolution ADCs are considered for both data detection and channel estimation, and the resulting performance is analyzed. Asymptotic approximations of the spectrum efficiency (SE) for large systems are derived based on random matrix theory. With these results, we can provid…
A multiple antenna base station (BS) with an intelligent reflecting surface (IRS) platform, and several single antenna users are considered in the downlink mode. Simultaneous wireless information and power transfer (SWIPT) is utilized by the BS via transmit beamforming to convey information and power to all devices. Each device applies power splitting (PS) to dedicate separate parts of received power to information decoding and energy harvesting. We formulate a total transmit power minimization problem to jointly design the BS beamforming vectors, IRS phase shifts, and PS ratios at the receive…
In this paper, we focus on the joint impairments compensation and symbol detection problem in communication systems. First, we introduce a new multi-layer channel model that represents the underlying physics of multiple impairments in communication systems. This model is composed of widely linear parametric layers that describe the input-output relationship of the front-end impairments and channel effects. Using this particular model, we show that the joint compensation and zero-forcing detection problem can be solved by a particular feedforward network called PhyCOM. Because of the small numb…
In this paper, we propose a novel joint caching and massive multiple-input multiple-output (MIMO) transmission scheme, referred to as cache-aided massive MIMO, for advanced downlink cellular communications. In addition to reaping the conventional advantages of caching and massive MIMO, the proposed scheme also exploits the side information provided by cached files for interference cancellation at the receivers. This interference cancellation increases the degrees of freedom available for precoding design. In addition, the power freed by the cache-enabled offloading can benefit the transmission…
