arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2002.07626eess.SPmath.OC
收藏

光相干传输系统中的发射功率优化:分析、模拟和实验结果

Transmit Power Optimization in Optical Coherent Transmission Systems: Analytical, Simulation, and Experimental Results

Ramin Hashemi, Mehdi Habibi, Hamzeh Beyranvand, Ali Emami, Mahdi Hashemi, Davood Ranjbar Rafie

摘要:

在本文中,我们建议使用所谓的增强高斯噪声(EGN)模型的离散化版本来估计光纤的非线性效应的光相干和无补偿传输(CUT)系统的性能。通过计算非线性干扰噪声的功率,并考虑光放大器噪声,得到了CUT的信噪比和可达速率。为了分配每个CUT信道的功率,我们考虑了两个优化问题,其目标是最大化最小SNR裕度和可达速率。我们表明,通过使用离散EGN模型,引入的优化问题的复杂性降低了现有的优化问题的基础上开发的所谓的离散高斯噪声(GN)模型。此外,基于离散EGN模型的优化导致更好的信噪比和可达速率。我们验证我们的分析结果与模拟和实验结果。我们模拟了一个五通道相干系统的OptiSystem软件,其中观察到的优化和模拟之间的密切协议。在此基础上,分别对单信道和三信道相干光系统,在300 km单模光纤(SMF)和非零色散位移光纤(NZDSF)上,对商用100 Gbps相干光发射机的信噪比进行了测量。我们观察到实验和分析结果之间存在性能差距,这主要是由于其他噪声源,如发射机缺陷噪声,热噪声和散粒噪声,在实验中。通过将这些噪声源包括在分析模型中,减少了分析结果和实验结果之间的差距。

英文摘要:

In this paper, we propose to use the discretized version of the so-called Enhanced Gaussian Noise (EGN) model to estimate the non-linearity effects of fiber on the performance of optical coherent and uncompensated transmission (CUT) systems. By computing the power of non-linear interference noise and considering optical amplifier noise, we obtain the signal-to-noise (SNR) ratio and achievable rate of CUT. To allocate the power of each CUT channel, we consider two optimization problems with the objectives of maximizing minimum SNR margin and achievable rate. We show that by using the discretized EGN model, the complexity of the introduced optimization problems is reduced compared with the existing optimization problems developed based on the so-called discretized Gaussian Noise (GN) model. In addition, the optimization based on the discretized EGN model leads to a better SNR and achievable rate. We validate our analytical results with simulations and experimental results. We simulate a five-channel coherent system on OptiSystem software, where a close agreement is observed between optimizations and simulations. Furthermore, we measured SNR of commercial 100Gbps coherent transmitter over 300 km single-mode fiber (SMF) and non-zero dispersion-shifted fiber (NZDSF), by considering single-channel and three-channel coherent systems. We observe there are performance gaps between experimental and analytical results, which is mainly due to other sources of noise such as transmitter imperfection noise, thermal noise, and shot noise, in experiments. By including these sources of noise in the analytical model, the gaps between analytical and experimental results are reduced.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑