In this paper, a dual heuristic programming controller is proposed to control a boost converter. Conventional controllers such as proportional integral derivative (PID) or proportional integral (PI) are designed based on the linearized small-signal model near the operating point. Therefore, the performance of the controller during start up, load change, or input voltage variation is not optimal since the system model changes by varying the operating point. The dual heuristic programming controller optimally controls the boost converter by following the approximate dynamic programming. The advantage of the DHP is that the neural network based characteristic of the proposed controller enables boost converters to easily cope with large disturbances. A DHP with a well trained critic and action networks can perform as an optimal controller for the boost converter. To compare the effectiveness of the traditional PI based and the DHP boost converter, the simulation results are provided.
This paper proposes a new single input multiple output power supply by integrating a flyback converter and several buck converters. The flyback converter works as the main regulator, and the buck converters provide series voltage compensation with the aim of tight regulation. A time multiplexing switching scheme is proposed to deliver multiple output voltage levels via a two winding transformer and to eliminate the cross regulation between output channels. This configuration reduces the size of flyback transformer and filter capacitors, and consequently improves the overall form factor. A deta…
In this paper, a neural network predictive controller (NNPC) is proposed to control a buck converter. Conventional controllers such as proportional integral (PI) or proportional integral derivative (PID) are designed based on the linearized small signal model near the operating point. Therefore, the performance of the controller in the start up, load change, or reference change is not optimal since the system model changes by changing the operating point. The neural network predictive controller optimally controls the buck converter by following the concept of the traditional model predictive …
The progressive displacing of conventional generation in favour of renewable energy sources requires restoring an adequate capacity of regulating power to ensure reliable operation of power systems. Battery Energy Storage Systems (BESSs) are considered to be promising assets to restore suitable frequency regulation capacity levels. BESSs are typically connected to the grid with power-converters, able to operate in either grid-forming or grid-following modes. This paper quantitatively assesses the impact on the local distribution grid of BESSs providing frequency regulation to bulk power system…
In this paper we consider the problem of voltage regulation of a proton exchange membrane fuel cell connected to an uncertain load through a boost converter. We show that, in spite of the inherent nonlinearities in the current-voltage behaviour of the fuel cell, the voltage of a fuel cell/boost converter system can be regulated with a simple proportional-integral (PI) action designed following the {Passivity-based Control (PBC) approach. The system under consideration consists of a DC-DC converter interfacing a fuel cell with a resistive load. We show that the output voltage of the converter c…
A common configuration for a stand-alone PV power system may consist of three converters: a buck converter for the PV panelto charge the battery, a boost converter for the battery to discharge to the load and one for the load voltage regulation. Such a systemrequires a coordinated control scheme for three converters which can be complicated. A simple structure for a stand-alone PV plantconsists of a PV array, a battery unit, and its associated bidirectional converter which is a combination of a buck and boost converter.When controlled properly the system can provide uninterrupted power to the …
In this study, a heuristic dynamic programming controller is proposed to control a boost converter. Conventional controllers such as proportional integral-derivative (PID) or proportional integral (PI) are designed based on the linearized small-signal model near the operating point. Therefore, the performance of the controller during the start-up, the load change, or the input voltage variation is not optimal since the system model changes by varying the operating point. The heuristic dynamic programming controller optimally controls the boost converter by following the approximate dynamic pro…
Rapid developments in power distribution systems and renewable energy have widened the applications of dc--dc buck--boost converters in dc voltage regulation. Applications include vehicular power systems, renewable energy sources that generate power at a low voltage, and dc microgrids. It is noted that the cascade--connection of converters in these applications may cause instability due to the fact that converters acting as loads have a constant power load (CPL) behavior. In this paper, the output voltage regulation problem of a buck--boost converter feeding a CPL is addressed. The constructio…
In the paper, a nonlinear inversion technique for the steady-state model of the active dual-bridge series resonant converter is presented. The obtained control strategy allows cycle averaged output current regulation and performs waveform alignment for the controllable achievement of ZVS and synchronous rectification. The control is valid both for voltage buck and boost operating modes, as well as for low-power operation at a fixed frequency. Robustness of the control is studied by simulations with external linear control loops.
The weighted voltage mode control represents a method for control of multiple outputs DC-DC converters. Accordingly, the weighted control redistributes the error among the outputs of these converters, and the regulation error can be reduced by adjusting the weighting factors. But the problem is that most designs are performed on the trial-and-error basis, and the results were rather inconsistent. Also, in conventional mathematical approaches, this factor is designed for converters by given parameters. In this paper, three optimization algorithms namely Imperialist Competitive Algorithm (ICA), …
Proximal Policy Optimization-Based Reinforcement Learning Approach for DC-DC Boost Converter Control: A Comparative Evaluation Against Traditional Control Techniques
A backstepping controller is designed for a system of parallel buck converters sharing load. Controller objective is to ensure proper current sharing and output voltage regulation. The designed controller is successfully tested for both constant load and sudden change in loading conditions.
Recent advances in data sensing and processing technologies enable data-driven control of high-voltage direct-current (HVDC) systems for improving the operational stability of interfacing power grids. This paper proposes an optimal data-driven control strategy for an HVDC system with line-commutated converters (LCCs), wherein the dc-link voltage and current are optimally regulated at distinct HVDC terminals to improve frequency regulation (FR) in both rectifier- and inverter-side grids. Each HVDC converter is integrated with feedback loops for regulation of grid frequency and dc-link voltage i…
In this paper, parallel interconnection of DC/DC converters is considered. For this topology of converters feeding a common load, it has been recently shown that dynamics related to voltage regulation can be completely separated from the current distribution without considering frequency separation arguments, which inevitably limits achievable performance. Within the Hamiltonian framework, this paper shows that this separation between current distribution and voltage regulation is linked to the energy conservative quantities: the Casimir functions. Furthermore, a robust control law is given in…
This paper presents design and control of dual-switch non-inverting buck-boost converter (CBB). This converter is designed to simplify the compatibility of electronic ballast with simple and low cost LED drivers. The converter provides starting voltage and current limitation of electronic ballasts, which operates at continuous conduction mode (CCM). The voltage of load terminal is controlled by adjusting the duty cycle of the PWM regulator. Although both converter switches are controlled separately, one feedback control loop is needed to obtain the desired compensator level. Appropriate contro…
In this work, the problem of switching control design for DC-DC boost converter is considered, in the case of operation under uncertain equilibrium condition arising due to perturbations in the input and load parameters. Assuming that these uncertain parameters are generated via a known linear exo-system, a parameter estimator is designed to update the equilibrium point for the switching controller in real-time. In order to mitigate the noise amplification problem associated with the designed parameter estimator, the estimation error injection term is filtered via a set of first-order filters …
Global Tracking Passivity--based PI Control of Bilinear Systems and its Application to the Boost and Modular Multilevel Converters
Laboratoire de Signaux et Systémes, Supélec（信号与系统实验室，苏佩莱克高等学院）；Dipartimento Ingegneria dell’Informazione, Università Politecnica delle Marche（信息技术工程学院，马尔凯理工学院）；Norwegian University of Science and Technology（挪威科技大学）
High-voltage direct-current (HVDC) systems for constant or intermittent power delivery have recently been developed further to support grid frequency regulation (GFR). This paper proposes a new control strategy for a line-commutated converter-based (LCC) HVDC system, wherein the DC-link voltage and current are optimally regulated to improve real-time GFR in both rectifier- and inverter-side AC networks. A dynamic model of an LCC HVDC system is developed using the DC voltage and current as input variables, and is integrated with feedback loops for inertia emulation and droop control. A linear q…
Mitigation of fossil fuel dependency is becoming a major concern in most of the countries around the globe. In that context, this research article presents the single phase two stage boost inverter system for wave energy conversion. The proposed wave energy based power conditioning system includes wave energy based functional block, permanent magnet synchronous generator, zeta converter, single phase H-bridge inverter and a resistive load. The boost inverter is used to boost up the voltage availed from the permanent magnet generator powered by a wave energy converter system using zeta converte…
In this manuscript, the performance of an ultracapacitor fuel cell in grid connected mode is investigated. Voltage regulation to the ultracapacitor was achieved with a three level bidirectional DC-DC converter while also achieving power flow from the grid to the ultra-capacitor via the bidirectional converter. The choice of a bidirectional three level converter for voltage regulation is based on its inherently high efficiency, low harmonic profile and compact size. Using the model equations of the converter and grid connected inverter derived using the switching function approach, the grid's d…
A sensitivity conditioning control strategy is analyzed in this paper and it is applied to power electronic converters. The term is used to improve closed loop systems, such as power converters with cascaded inner and outer loop controllers. The impact of the sensitivity term is analyzed using singular perturbation theory. In addition, the implementation of the control term is addressed for practical systems, where the number of inputs is generally not sufficient for exact sensitivity conditioning. Simulation results are presented for a buck converter with output capacitor voltage regulation a…
This article presents the characterization of analog and digital control loops using PID and PIDN control algorithms for bidirectional buck and boost converter (BBC). Control loops of BBC are designed and implemented in MATLAB code using transfer functions in time domain with unit step response and in frequency domain with bode plots and pole-zero plots. These transfer functions are obtained by average large signal modeling of BBC. Actions of analog and digital control loops are characterized in order to ensure stability and dynamic response of BBC which is a bottleneck in renewable energy app…
The use of charge controllers in photovoltaic generation systems increases the energy harvested significantly. The most efficient type of charge controller is the Maximum Power Point Tracking (MPPT) controller. The commercially available MPPT controller is limited to the input voltage of the solar panel and to the charging voltage of the battery making it inefficient to very low irradiance weather condition. In this paper, it is proposed to increase the efficiency of commercially available MPPT controllers by adding Power Management System that has boost converter and switching circuit that wi…
In this paper we propose a PI passivity-based controller, applicable to a large class of switched power converters, that ensures global state regulation to a desired equilibrium point. A solution to this problem was reported in \cite{HERetal} but it requires full state-feedback, which makes it practically unfeasible. To overcome this limitation we construct a state observer that is implementable with measurements that are available in practical applications. The observer reconstructs the state in finite-time, ensuring global convergence of the PI. The excitation requirement for the observer is…
With the increasing adoption of renewable energy sources by domestic users, decentralisation of the grid is fast becoming a reality. Distributed generation is an important part of a decentralised grid. This approach employs several small-scale technologies to produce electrical energy close to the end users or consumers. The higher reliability of these systems proves to be of advantage when compared to traditional generation systems. Multi-Input Converters (MICs) perform a decisive function in Distributed Energy Resources (DERs). Making use of such MICs prove to be beneficial in terms of size,…
Switched-capacitor (SC) DC-DC voltage converters are widely used in power delivery and management of modern integrated circuits. Connected to a common supply voltage, SC converters exhibit cross-regulation/coupling effects among loads connected to different SC converter stages due to the shared components such as switches, capacitors, and parasitic elements. The coupling effects between SC converter stages can potentially be used in covert communication, where two or more entities (e.g., loads) illegitimately establish a communication channel to exchange malicious information stealthily. To qu…
This paper investigates a new method to model and control variable-frequency power converters in a switching-synchronized sampled-state space for cycle-by-cycle digital control. There are a number of significant benefits in comparison to other methods including fast dynamic performance together with ease of design and implementation. Theoretical results are presented and verified through hardware, and simulations of a current-mode buck converter with constant on-time and a current-mode boost converter with constant off-time. Dynamic voltage scaling for microprocessors and LiDAR are among the a…
Data-driven control that circumvents the process of system identification by providing optimal control inputs directly from system data has attracted renewed attention in recent years. In this paper, we focus on understanding the effects of the regularization on the data-enabled predictive control (DeePC) algorithm. We provide theoretical motivation and interpretation for including a quadratic regularization term. Our analysis shows that the quadratic regularization term leads to robust and optimal solutions with regards to disturbances affecting the data. Moreover, when the input/output const…
