导电SiC-Si/C和Ru表面Casimir力和静电的比较
Comparison of Casimir forces and electrostatics from conductive SiC-Si/C and Ru surfaces
摘要:
从导电SiC和Ru表面的卡西米尔力和相关静电的全面知识可以是必不可少的,在不同的领域,从微/纳米器件在恶劣环境中的操作,以先进的光刻技术的多层涂层。因此,Casimir力之间的Au-涂覆的微球和N-掺杂的SiC样品与Si-和C-终止面进行测量,并将结果与使用相同的微球和金属钌表面的测量进行比较。静电校准表明,Si面和C面表现不同,接触电位V0 Si/C相差约0.6-0.7 V。我们将此归因于在近表面区域中的C-终止面上的N的更高并入,导致NOx的形成和与X-射线光电子能谱学数据一致的Si-终止表面相比的功函数增加。值得注意的是,SiC-C面的接触电位更接近于金属Ru-Au系统。然而,用椭圆偏振法测得的SiC-Si/C终止表面的光学性质没有显示出任何实质性差异,表明Si/C终止表面层的有效深度显著小于光子穿透深度,不会导致通过Lifshitz理论计算的力的任何差异。尽管如此,测量的卡西米尔力,静电贡献的补偿后,显示Si/C面之间的差异,而与Lifshitz理论预测的比较显示更好的协议的SiC-Si面。最后,在SiC-Si/C和Ru表面之间低于40 nm间距的Casimir力的比较表明,短程粗糙度对Casimir力的影响随着板表面的金属行为的增加而增加。
英文摘要:
Comprehensive knowledge of Casimir forces and associated electrostatics from conductive SiC and Ru surfaces can be essential in diverse areas ranging from micro/nanodevice operation in harsh environments to multilayer coatings in advanced lithography technologies. Hence, the Casimir force was measured between an Au-coated microsphere and N-doped SiC samples with Si- and C-terminated faces, and the results were compared with the measurements using the same microsphere and a metallic Ruthenium surface. Electrostatic calibration showed that the Si- and C-faces behave differently with a nearly ~0.6-0.7 V difference in the contact potentials V0Si/C. We attribute this to a higher incorporation of N on the C-terminated face in the near surface region resulting in the formation of NOx and an increased work function compared to the Si-terminated surface which is in agreement with x-ray photoelectron spectroscopy data. Notably, the contact potential of the SiC-C face was closer to the metallic Ru-Au system. However, the measured optical properties of the SiC-Si/C terminated surfaces with ellipsometry did not show any substantial differences indicating that the effective depth of the Si/C terminating surface layers are significantly smaller than the photon penetration depth not leading to any differences in the calculated forces via Lifshitz theory. Nonetheless, the measured Casimir forces, after compensation of the electrostatics contributions, showed differences between the Si/C faces, whereas the comparison with the Lifshitz theory prediction shows better agreement for the SiC-Si face. Finally, comparison of the Casimir forces below 40 nm separations between the SiC-Si/C and Ru surfaces indicated that the short-range roughness effects on the Casimir force increase in magnitude with increasing metallic behavior of the plate surface.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。