连续光照下的SiPM行为
SiPM behaviour under continuous light
摘要:
本文报道了硅光电倍增器(SiPM)探测器在连续光下的性能。通常,SiPM的偏置电路有一个串联的电阻器,它可以保护传感器免受过高电流的影响。当SiPM在恒定光照下产生恒定电流时,该电阻会引入电压降。这降低了实际的SiPM偏置,然后降低了其对光的灵敏度。事实上,这种效应改变了所有相关的SiPM特征,包括电学(即击穿电压、增益、脉冲幅度、暗计数率和光学串扰)和光学(即光子检测效率)。为了正确地操作这样的设备,那么在各种照明水平下校准它们是基本的。在这项工作中,我们专注于大面积($\sim$ 1~cm $^{2}$)六角SiPM S10943-2832(X)的滨松HPK生产的γ射线望远镜的相机与4米直径的镜子,称为SST-1 M。在室温下(T = 25 $^{\circ}$ C),每个传感器的光子数从3~MHz到5~GHz,我们对这种器件进行了表征。从这些研究中,一个模型的开发,以获得所需的参数,以纠正电压降的影响。该模型可以应用于例如分析由相机获取的数据以校正效果。实验结果还比较了玩具蒙特卡罗模拟,最后,提出了一种解决方案,以补偿电压降。
英文摘要:
This paper reports on the behaviour of Silicon Photomultiplier (SiPM) detectors under continuous light. Usually, the bias circuit of a SiPM has a resistor connected in series to it, which protects the sensor from drawing too high current. This resistor introduces a voltage drop when a SiPM draws a steady current, when illuminated by constant light. This reduces the actual SiPM bias and then its sensitivity to light. As a matter of fact, this effect changes all relevant SiPM features, both electrical (i.e. breakdown voltage, gain, pulse amplitude, dark count rate and optical crosstalk) and optical (i.e. photon detection efficiency). To correctly operate such devices, it is then fundamental to calibrate them under various illumination levels. In this work, we focus on the large area ($\sim$1~cm$^{2}$) hexagonal SiPM S10943-2832(X) produced by Hamamatsu HPK for the camera of a gamma-ray telescope with 4 m-diameter mirror, called the SST-1M. We characterize this device under light rates raging from 3~MHz up to 5~GHz of photons per sensor at room temperature (T = 25 $^{\circ}$C). From these studies, a model is developed in order to derive the parameters needed to correct for the voltage drop effect. This model can be applied for instance in the analysis of the data acquired by the camera to correct for the effect. The experimental results are also compared with a toy Monte Carlo simulation and finally, a solution is proposed to compensate for the voltage drop.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。