Beginning in Fall 2018, the VERITAS high energy gamma-ray observatory (Amado, AZ) was upgraded to enable Stellar Intensity Interferometry (SII) observations during bright moon conditions. The system potentially allows VERITAS to spatially characterize stellar objects at visible wavelengths with sub-milliarcsecond angular resolution. This research project was on the construction of a high voltage power supply for the photomultiplier tubes (PMTs) used in the SII camera. The high voltage supply was designed to be electrically isolated from all other electronics (except for the PMT) to reduce noise pickup. The HV supply operates on a Li-Ion battery, and the high voltage level is remotely programmed using a pulse width modulation (PWM) signal that is generated by an Arduino Yun microcontroller and distributed through a fiber optic cable. The electrical isolation of the fiber optic control system suppresses the pickup of radio frequency interference through ground loops. A separate fiber optic transceiver pair is used for the on-off control of the high voltage power supply. Tests were performed that show the high voltage level is reproducible to within one volt for a given duty cycle of the PWM signal. Furthermore, the high voltage output level was shown to be stable with respect to variations in the input battery voltage used to power the high voltage supply. The high voltage system is currently being used in regular SII observations at VERITAS. This poster will describe the detailed design and performance of the system.
The number of terrestrial exoplanets accessible to high-contrast coronagraphic imaging with large telescopes is limited by the smallest angular offset from bright stars at which coronagraphs can observe. However, it is possible to reach inside a telescopes coronagraphic regime by employing nulling interferometry across a telescopes pupil. Indeed, cross-aperture nulling interferometry can observe significantly closer to stars than typical coronagraphs, enabling observations even within the stellar diffraction core. Identifying an optimal nulling coronagraph, i.e., one with both a very small IWA…
More than sixty years after the first intensity correlation experiments by Hanbury Brown and Twiss, there is renewed interest for intensity interferometry techniques for high angular resolution studies of celestial sources. We report on a successful attempt to measure the bunching peak in the intensity correlation function for bright stellar sources with 1 meter telescopes (I2C project). We propose further improvements of our preliminary experiments of spatial interferometry between two 1 m telescopes, and discuss the possibility to export our method to existing large arrays of telescopes.
Understanding the atmospheres of exoplanets is a milestone to decipher their formation history and potential habitability. High-contrast imaging and spectroscopy of exoplanets is the major pathway towards the goal. Directly imaging of an exoplanet requires high spatial resolution. Interferometry has proven to be an effective way of improving spatial resolution. However, means of combining interferometry, high-contrast imaging, and high-resolution spectroscopy have been rarely explored. To fill in the gap, we present the dual-aperture fiber nuller (FN) for current-generation 8-10 meter telescop…
During some thirty years, 1980-2010, technical studies of optical interferometry from instruments in space were pursued as promising for higher spatial resolution and for higher astrometric accuracy. Nulling interferometry was studied for both high spatial resolution and high contrast. These studies were great dreams deserving further historical attention. ESA's interest in interferometry began in the early 1980s. The studies of optical interferometry for the global astrometry mission GAIA began in 1993 and ended in 1998 when interferometry was dropped as unsuited for the purpose, and the Gaia…
It has been recently demonstrated that integrated optics could enhance accuracy, stability, and ease of use of stellar interferometry techniques. The subject of this thesis is the study of an optical component based on singlemode waveguides for the coherent recombining of optical beams coming from four telescopes. Proposed architecture provides a simultaneous an instantaneous measurement of complex visibility of interferometric signals of the six possible pairs of telescopes. The component is optimized for achromatic behaviour over the H spectral transparency band of atmosphere and integrates …
We present a concept of a millimeter wavefront sensor that allows real-time sensing of the surface of a ground-based millimeter/submillimeter telescope. It is becoming important for ground-based millimeter/submillimeter astronomy to make telescopes larger with keeping their surface accurate. To establish `millimetric adaptive optics (MAO)' that instantaneously corrects the wavefront degradation induced by deformation of telescope optics, our wavefront sensor based on radio interferometry measures changes in excess path lengths from characteristic positions on the primary mirror surface to the …
Intensity interferometry permits very long optical baselines and the observation of sub-milliarcsecond structures. Using planned kilometric arrays of air Cherenkov telescopes at short wavelengths, intensity interferometry may increase the spatial resolution achieved in optical astronomy by an order of magnitude, inviting detailed studies of the shapes of rapidly rotating hot stars with structures in their circumstellar disks and winds, or mapping out patterns of nonradial pulsations across stellar surfaces. Signal-to-noise in intensity interferometry favors high-temperature sources and emissio…
Integrated optic beam combiners offer many advantages over conventional bulk optic implementations for astronomical imaging. To date, integrated optic beam combiners have only been demonstrated at operating wavelengths below 4 microns. Operation in mid-infrared wavelength region, however, is highly desirable. In this paper, a theoretical design technique based on three coupled waveguides is developed to achieve fully achromatic, broadband, polarization-insensitive, lossless beam combining. This design may make it possible to achieve the very deep broadband nulls needed for exoplanet searching.
Integrated-optic, astronomical, two-beam and three-beam, interferometric combiners have been designed and fabricated for operation in the L band (3 - 4 microns) for the first time. The devices have been realized in titanium-indiffused, x-cut lithium niobate substrates, and on-chip electro-optic fringe scanning has been demonstrated. White light fringes were produced in the laboratory using the two-beam combiner integrated with an on-chip Y-splitter.
High resolution imaging is achieved using increasingly larger apertures and successively shorter wavelengths. Optical aperture synthesis is an important high-resolution imaging technology used in astronomy. Conventional long baseline amplitude interferometry is susceptible to uncontrollable phase fluctuations, and the technical difficulty increases rapidly as the wavelength decreases. The intensity interferometry inspired by HBT experiment is essentially insensitive to phase fluctuations, but suffers from a narrow spectral bandwidth which results in a lack of detection sensitivity. In this stu…
Conventional ground-based astronomical observations suffer from image distortion due to atmospheric turbulence. This can be minimized by choosing suitable geographic locations or adaptive optical techniques, and avoided altogether by using orbital platforms outside the atmosphere. One of the promises of optical intensity interferometry is its independence from atmospherically induced phase fluctuations. By performing narrowband spectral filtering on sunlight and conducting temporal intensity interferometry using actively quenched avalanche photon detectors (APDs), the Solar $g^{(2)}(τ)$ signat…
Imaging Atmospheric Cherenkov Telescopes (IACTs) currently in operation feature large mirrors and order of 1 ns time response to signals of a few photo-electrons produced by optical photons. This means that they are ideally suited for optical interferometry observations. Thanks to their sensitivity to visible wavelengths and long baselines optical intensity interferometry with IACTs allows reaching angular resolutions of tens to microarcsec. We have installed a simple optical setup on top of the cameras of the two 17 m diameter MAGIC IACTs and observed coherent fluctuations in the photon inten…
Optical imaging with microarcsecond resolution will reveal details across and outside stellar surfaces but requires kilometer-scale interferometers, challenging to realize either on the ground or in space. Intensity interferometry, electronically connecting independent telescopes, has a noise budget that relates to the electronic time resolution, circumventing issues of atmospheric turbulence. Extents up to a few km are becoming realistic with arrays of optical air Cherenkov telescopes (primarily erected for gamma-ray studies), enabling an optical equivalent of radio interferometer arrays. Pio…
We review the potential of Astrophotonics, a relatively young field at the interface between photonics and astronomical instrumentation, for spectro-interferometry. We review some fundamental aspects of photonic science that drove the emer- gence of astrophotonics, and highlight the achievements in observational astrophysics. We analyze the prospects for further technological development also considering the potential synergies with other fields of physics (e.g. non-linear optics in condensed matter physics). We also stress the central role of fiber optics in routing and transporting light, de…
High-resolution observations by visible and near-infrared interferometers of both single stars and binaries have made significant contributions to the foundations that underpin many aspects of our knowledge of stellar structure and evolution for cool stars. The CS16 splinter on this topic reviewed contributions of optical interferometry to date, examined highlights of current research, and identified areas for contributions with new observational constraints in the near future.
The closest examples of high-mass star birth occurs in deeply embedded environments at kiloparsec distances. Although much progress has been made, an observationally validated picture of the dominant processes which allows the central hydrostatic object to grow in mass has yet to be established. The observational technique of optical interferometry has demonstrated its potential in the field of high-mass star formation by delivering a milli-arcsecond infrared view on the complex accretion environment. We provide an overview of the scientific results obtained with multi-aperture telescope array…
In this paper are reviewed various designs of advanced, multi-aperture optical systems dedicated to high angular resolution imaging or to the detection of exo-planets by nulling interferometry. A simple Fourier optics formalism applicable to both imaging arrays and nulling interferometers is presented, allowing to derive their basic theoretical relationships as convolution or cross correlation products suitable for fast and accurate computation. Several unusual designs, such as a super-resolving telescope utilizing a mosaicking observation procedure or a free-flying, axially recombined interfe…
We report on observations of the extended environment of the bright Be star $γ$-Cas performed using intensity interferometry measurements within its H$α$ emission line. These observations were performed using a modified version of the I2C intensity interferometry instrument installed onto the 1.54 meter MéO optical metrology telescope and a portable 1-meter telescope (T1M). In order to better constrain the extent of the H$α$ envelope, observations were performed for two different positions of the T1M telescope, corresponding to an intermediate and long baselines in which the extended region wa…
Using kilometric arrays of air Cherenkov telescopes, intensity interferometry may increase the spatial resolution in optical astronomy by an order of magnitude, enabling images of rapidly rotating stars with structures in their circumstellar disks and winds, or mapping out patterns of nonradial pulsations across stellar surfaces. Intensity interferometry (pioneered by Hanbury Brown and Twiss) connects telescopes only electronically, and is practically insensitive to atmospheric turbulence and optical imperfections, permitting observations over long baselines and through large airmasses, also a…
