Vehicular networks will play an important role in enhancing road safety, improving transportation efficiency, and providing seamless Internet service for users on the road. Reaping the benefit of vehicular networks is contingent upon meeting stringent wireless communication performance requirements, particularly in terms of delay and reliability. In this paper, a dependence control mechanism is proposed to improve the overall reliability of vehicular networks. In particular, the dependence between the communication delays of different vehicle-to-vehicle (V2V) links is first modeled. Then, the concept of a concordance order, stemming from stochastic ordering theory, is introduced to show that a higher dependence can lead to a better reliability. Using this insight, a power allocation problem is formulated to maximize the concordance, thereby optimizing the overall communication reliability of the V2V system. To obtain an efficient solution to the power allocation problem, a dual update method is introduced. Simulation results verify the effectiveness of performing dependence control for reliability optimization in a vehicular network, and show that the proposed mechanism can achieve up to 25% reliability gain compared to a baseline system that uses a random power allocation.
We investigate the effect of channel aging on multi-cell massive multiple-input multiple-output (MIMO) vehicular networks in a generic non-isotropic scattering environment. Based on the single cluster scattering assumption and the von Mises distribution assumptions of the scatterers' angles, an aging channel model is established to capture the joint effect of spatial and temporal correlations resulting from different angular spread conditions in various application scenarios. Expressions of the user uplink transmission spectral efficiency (SE) are derived for maximum ratio (MR) and minimum mea…
To deal with the explosive growth of mobile traffic, millimeter-wave (mmWave) communications with abundant bandwidth resources have been applied to vehicular networks. As mmWave signal is sensitive to blockage, we introduce the unmanned aerial vehicle (UAV)-aided two-way relaying system for vehicular connection enhancement and coverage expansion. How to improve transmission efficiency and to reduce latency time in such a dynamic scenario is a challenging problem. In this paper, we formulate the joint optimization problem of relay selection and transmission scheduling, aiming to reduce transmis…
Vehicle-to-vehicle (V2V) communication appeals to increasing research interest as a result of its applications to provide safety information as well as infotainment services. The increasing demand of transmit rates and various requirements of quality of services (QoS) in vehicular communication scenarios call for the integration of V2V communication systems and potential techniques in the future wireless communications, such as full duplex (FD) and non-orthogonal multiple access (NOMA) which enhance spectral efficiency and provide massive connectivity. However, the large amount of data transmi…
Future vehicular communication networks call for new solutions to support their capacity demands, by leveraging the potential of the millimeter-wave (mm-wave) spectrum. Mobility, in particular, poses severe challenges in their design, and as such shall be accounted for. A key question in mm-wave vehicular networks is how to optimize the trade-off between directive Data Transmission (DT) and directional Beam Training (BT), which enables it. In this paper, learning tools are investigated to optimize this trade-off. In the proposed scenario, a Base Station (BS) uses BT to establish a mm-wave dire…
How to enhance the communication efficiency and quality on vehicular networks is one critical important issue. While with the larger and larger scale of vehicular networks in dense cities, the real-world datasets show that the vehicular networks essentially belong to the complex network model. Meanwhile, the extensive research on complex networks has shown that the complex network theory can both provide an accurate network illustration model and further make great contributions to the network design, optimization and management. In this paper, we start with analyzing characteristics of a taxi…
The increasing demand for rich multimedia services and the emergence of the Internet-of-Things (IoT) pose challenging requirements for the next generation vehicular networks. Such challenges are largely related to high spectral efficiency and low latency requirements in the context of massive content delivery and increased connectivity. In this respect, caching and non-orthogonal multiple access (NOMA) paradigms have been recently proposed as potential solutions to effectively address some of these key challenges. In the present contribution, we introduce cache-aided NOMA as an enabling techno…
Intelligent reflecting surface (IRS) has recently received much attention from the research community due to its potential to achieve high spectral and power efficiency cost-effectively. In addition to traditional cellular networks, the use of IRS in vehicular networks is also considered. Prior works on IRS-aided vehicle-to-everything communications focus on deploying reflection surfaces on the facades of buildings along the road for sidelink performance enhancement. This paper goes beyond the state of the art by presenting a novel paradigm coined Intelligent Reflecting Vehicle Surface (IRVS).…
This paper investigates the downlink scheduling for relay-aided high-mobility vehicular networks, where the vehicles with good vehicle-to-infrastructure (V2I) links are employed as cooperative relay nodes to help the ones with poor V2I links forward information via vehicle-to-vehicle (V2V) links. In existing works, instantaneous achievable information rate was widely adopted to perform the link scheduling, but it is not efficient for vehicular networks, especially for high-mobility scenarios. Different from them, in this paper, we introduce the mobile service to describe the mobile link capaci…
Optical camera communications (OCC) has emerged as a key enabling technology for the seamless operation of future autonomous vehicles. In this paper, we introduce a spectral efficiency optimization approach in vehicular OCC. Specifically, we aim at optimally adapting the modulation order and the relative speed while respecting bit error rate and latency constraints. As the optimization problem is NP-hard problem, we model the optimization problem as a Markov decision process (MDP) to enable the use of solutions that can be applied online. We then relaxed the constrained problem by employing La…
Intel Labs（英特尔实验室）；Georgia Institute of Technology（佐治亚理工学院）；Zhejiang University（浙江大学）
It has been a long-held belief that judicious resource allocation is critical to mitigating interference, improving network efficiency, and ultimately optimizing wireless communication performance. The traditional wisdom is to explicitly formulate resource allocation as an optimization problem and then exploit mathematical programming to solve the problem to a certain level of optimality. Nonetheless, as wireless networks become increasingly diverse and complex, e.g., in the high-mobility vehicular networks, the current design methodologies face significant challenges and thus call for rethink…
The demand for real-time cloud applications has seen an unprecedented growth over the past decade. These applications require rapidly data transfer and fast computations. This paper considers a scenario where multiple IoT devices update information on the cloud, and request a computation from the cloud at certain times. The time required to complete the request for computation includes the time to wait for computation to start on busy virtual machines, performing the computation, waiting and service in the networking stage for delivering the output to the end user. In this context, the freshne…
Delivery of broadcast messages among vehicles for safety purposes, which is known as one of the key ingredients of Intelligent Transportation Systems (ITS), requires an efficient Medium Access Control (MAC) that provides low average delay and high reliability. To this end, a Geo-Location Based Access (GLOC) for vehicles has been proposed for Vehicle-to-Vehicle (V2V) communications, aiming at maximizing the distance of co-channel transmitters while preserving a low latency when accessing the resources. In this paper we analyze, with the aid of stochastic geometry, the delivery of periodic and n…
With the explosive growth of vehicle applications, vehicular networks based on millimeter wave (mmWave) bands have attracted interests from both academia and industry. mmWave communications are able to utilize the huge available bandwidth to provide multiple Gbps transmission rates among vehicles. In this paper, we address the content distribution scheduling problem in mmWave vehicular networks. It has been challenging for all vehicles in the same network to complete content downloading due to the limited communication resources of roadside units (RSUs) and the high mobility of vehicles. We pr…
As wireless networks evolve towards high mobility and providing better support for connected vehicles, a number of new challenges arise due to the resulting high dynamics in vehicular environments and thus motive rethinking of traditional wireless design methodologies. Future intelligent vehicles, which are at the heart of high mobility networks, are increasingly equipped with multiple advanced onboard sensors and keep generating large volumes of data. Machine learning, as an effective approach to artificial intelligence, can provide a rich set of tools to exploit such data for the benefit of …
Mobility may degrade the performance of next-generation vehicular networks operating at the millimeter-wave spectrum: frequent mis-alignment and blockages require repeated beam training and handover, and incur enormous overhead. Nevertheless, mobility induces temporal correlations in the communication beams and in blockage events. In this paper, an adaptive design of beam training, data transmission and handover is proposed, that learns and exploits these temporal correlations to reduce the beam training overhead and optimally trade-off throughput and power consumption. At each time-slot, the …
In this paper, the problem of joint power and resource allocation (JPRA) for ultra-reliable low-latency communication (URLLC) in vehicular networks is studied. Therein, the network-wide power consumption of vehicular users (VUEs) is minimized subject to high reliability in terms of probabilistic queuing delays. Using extreme value theory, a new reliability measure is defined to characterize extreme events pertaining to vehicles' queue lengths exceeding a predefined threshold. To learn these extreme events, assuming they are independently and identically distributed over VUEs, a novel distribut…
