基于电流局部化和再分布的NbOx中的不连续电流控制负微分电阻
Current localisation and redistribution as the basis of discontinuous current controlled negative differential resistance in NbOx
摘要:
原位热反射成像是用来表明,在NbOx基器件的电流控制的负微分电阻(CC-NDR)的不连续的,骤回模式是电流的本地化和重新分配的直接后果。电流局部化的结果是从创建一个导电细丝,无论是在电铸或电流分叉由于超线性温度依赖性的膜电导率。然后,由于在高电流密度区域内产生的电导率的快速增加,低电流密度区域和高电流密度区域之间的电流重新分布引起骤回响应。这种再分配进一步示出依赖于低电流密度区域的相对电阻,其中NbOx交叉点器件的特性在膜电导率、面积、厚度和温度的临界值处在连续和不连续的骤回模式之间转变,如所预测的。这些结果清楚地表明,骤回是一个通用的响应,而不是材料特定的相变,从而解决了长期存在的争议,从电流的本地化和重新分配的氧化膜。
英文摘要:
In-situ thermo-reflectance imaging is used to show that the discontinuous, snap-back mode of current-controlled negative differential resistance (CC-NDR) in NbOx-based devices is a direct consequence of current localization and redistribution. Current localisation is shown to result from the creation of a conductive filament either during electroforming or from current bifurcation due to the super-linear temperature dependence of the film conductivity. The snap-back response then arises from current redistribution between regions of low and high current-density due to the rapid increase in conductivity created within the high current density region. This redistribution is further shown to depend on the relative resistance of the low current-density region with the characteristics of NbOx cross-point devices transitioning between continuous and discontinuous snap-back modes at critical values of film conductivity, area, thickness and temperature, as predicted. These results clearly demonstrate that snap-back is a generic response that arises from current localization and redistribution within the oxide film rather than a material-specific phase transition, thus resolving a long-standing controversy.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。