亚毫米级$^3$超声自浮式多点神经记录植入体
A Sub-mm$^3$ Ultrasonic Free-floating Implant for Multi-mote Neural Recording
摘要:
介绍了一种0.8 mm $^3$无线、超声供电、自由浮动神经记录植入物。该器件仅由0.25 mm $^2$记录IC和用于功率收集和数据传输的单个压电陶瓷谐振器组成。上行链路数据传输通过超声回波的模拟幅度调制来执行。使用1.78MHz的主载波,实现了>35 kbps/mote的等效上行链路数据速率。介绍了一种使回波幅度调制线性化的技术,在$\pm$ 10 mV输入范围内,接收信号的静态非线性小于1.2%.该IC功耗为37.7 $μ$ W,而神经记录前端功耗为4 $μ$ W,在5 kHz带宽下实现5.3 $μ$ V $_{rms}$的本底噪声。这项工作提高了亚毫米记录尘埃深度> 2.5倍,导致最高的测量深度/体积比为$\sim$ 3倍。正交子载波调制使多个植入物的同时操作,使用单元件超声外部换能器。在50 mm的深度上以7 kS/s的速率演示了双微粒同时上电和数据传输。
英文摘要:
A 0.8 mm$^3$ wireless, ultrasonically powered, free-floating neural recording implant is presented. The device is comprised only of a 0.25 mm$^2$ recording IC and a single piezoceramic resonator that is used for both power harvesting and data transmission. Uplink data transmission is performed by analog amplitude modulation of the ultrasound echo. Using a 1.78 MHz main carrier, >35 kbps/mote equivalent uplink data rate is achieved. A technique to linearize the echo amplitude modulation is introduced, resulting in <1.2\% static nonlinearity of the received signal over a $\pm$10 mV input range. The IC dissipates 37.7 $μ$W, while the neural recording front-end consumes 4 $μ$W and achieves a noise floor of 5.3 $μ$V$_{rms}$ in a 5 kHz bandwidth. This work improves sub-mm recording mote depth by >2.5x, resulting in the highest measured depth/volume ratio by $\sim$3x. Orthogonal subcarrier modulation enables simultaneous operation of multiple implants, using a single-element ultrasound external transducer. Dual-mote simultaneous power up and data transmission is demonstrated at a rate of 7 kS/s at the depth of 50 mm.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。