arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1903.08574cond-mat.mtrl-sciphysics.geo-ph
收藏

冷却速率对考古粘土热释磁的影响:现代砖的实验研究

Cooling rate effect on thermoremanent magnetization in archaeological baked clays: an experimental study on modern bricks

Gwenaël Hervé, Annick Chauvin, Philippe Lanos, Pierre Rochette, Mireille Perrin, Michel Perron d'arc

摘要:

冷却速率对热释光磁化强度(TRM)的影响以及为这种影响校正古/古强度的必要性早已被认识到。然而,该修正的可靠性仍然受到质疑。我们研究了在已知实验条件下在两个现代窑炉(SK和BK)中烧制的35块砖,并测量了现场地磁场的方向和强度。最小的窑(SK,0.2立方米)在大约12小时内冷却,最大的窑(BK,8立方米)在大约40小时内冷却。热磁曲线、磁滞曲线和背场曲线表明,主要的磁性载体是贫钛磁铁矿和贫钛赤铁矿。贫Ti的钛赤铁矿所携带的TRM的分数是两组砖之间的主要区别。这一部分在BK窑的砖中约为5-10%,在SK窑的砖中高达40%。地球磁场的强度是使用原始的Thellier-Thellier协议与TRM各向异性校正确定的。平均场强分别高估了5%(SK)和6%(BK)。这一结果强调了冷却速率修正的必要性。为了详细评价冷却速率效应,我们采用了几种慢冷却速率:0.8、0.4、0.2和0.1{ \textdegree }C/min。用0.8{ \textdegree }C/min冷却获得的校正因子在-2%至21%之间,与贫钛赤铁矿携带的TRM分数成正比。SK窑砖中这些颗粒的比例较高,导致校正因子高估,强度低估7%。然而,当温度阶跃高于580{ \textdegree }C(即在贫Ti的钛赤铁矿解块温度范围内)时,从古强度和冷却速率校正的计算中排除时,恢复了预期的强度。在BK窑砖的情况下,贫Ti的钛赤铁矿对TRM没有显著贡献,所有测试的冷却速率给出的平均强度接近预期值。因此,不正确地估计考古冷却的持续时间对这些材料的考古强度数据的准确性影响很小。

英文摘要:

The influence of cooling rate on the intensity of thermoremanent magnetization (TRM) and the necessity to correct archaeo/palaeointensities for this effect have long been recognized. However the reliability of the correction is still questioned. We studied 35 bricks baked in two modern kilns (SK and BK) in known experimental conditions and with measurements of the direction and intensity of the geomagnetic field at the site. The smallest kiln (SK, 0.2 m 3) cooled in around 12 hours and the biggest kiln (BK, 8 m 3) in around 40 hours. Thermomagnetic, hysteresis and backfield curves indicated that the main magnetic carriers were Ti-poor titanomagnetites and Tipoortitanohematites. The fraction of the TRM carried by Ti-poor titanohematites is the maindifference between the two sets of bricks. This fraction is around 5-10% in bricks from BK kilnand up to 40% in those from SK kiln. Intensities of the Earth's magnetic field were determinedusing the original Thellier-Thellier protocol with correction of TRM anisotropy. The averageintensities overestimate the expected field intensity by 5% (SK) and 6% (BK). This resultemphasizes the necessity of the cooling rate correction. In order to have a detailed evaluation ofthe cooling rate effect, we used several slow cooling rates: 0.8, 0.4, 0.2 and 0.1{\textdegree}C/min. Thecorrection factors obtained with the 0.8{\textdegree}C/min cooling ranged between -2% and 21% and wereproportional to the TRM fraction carried by Ti-poor titanohematite. The higher proportion ofthese grains in bricks from SK kiln led to an overestimate of the correction factor and anunderestimate of the intensity by 7%. However, the expected intensity is recovered whentemperature steps higher than 580{\textdegree}C (i.e. in the range of Ti-poor titanohematites unblockingtemperatures) were excluded from the calculation of archaeointensity and cooling rate correction.In the case of the BK kiln bricks, for which Ti-poor titanohematites does not contributesignificantly to the TRM, all tested cooling rates give average intensities close to the expectedvalue. Incorrectly estimating the duration of the archaeological cooling has therefore a lowimpact on the accuracy of the archaeointensity data on these kinds of material.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑