arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 1810.01004physics.plasm-ph
收藏

入射角在平面ICF靶的laser烧蚀中的作用

The role of incidence angle in the laser ablation of planar ICF targets

Brett Scheiner, Mark Schmitt

摘要:

采用理想化模型研究了激光入射角对平面惯性约束聚变(ICF)靶质量烧蚀率和烧蚀压力的影响。国家点火装置(NIF)上的极向直接驱动(PDD)要求将其192个波束重新指向50度极点内,以最大限度地减少目标的极性变化有效载荷动能。由于这种重新指向,在任何PDD设计中都会遇到光束中心线的非垂直入射角。最大限度地减少不均匀性的PDD方案的制定是一个重大挑战,需要了解消融中引起的差异,包括入射角的差异。在这项工作中,使用激光烧蚀的教科书模型的修改版本[Manheimer等人,Phys. Fluids 25,1644(1982)]来证明在激光烧蚀的开始部分期间,对于平面情况,质量烧蚀速率和烧蚀压力与激光射线入射角的余弦的4/3和2/3幂成比例。这个结果被认为是一个理想化的1-D两段平面模型,使用射线在不同的入射角为每个部分。在模型中,如果不为每个段定制射线的时间依赖强度,则段不能同时具有相等的质量和速度。然而,与正确的段到段的时间无关的射线强度,相等的速度和动态压力可以实现近似没有剪裁。此外,提供了作为入射角的函数的传导区宽度的解析预测。据预测,该宽度随入射角增加,导致激光压印减少,这是先前在实验中观察到的效果。这些结果,当推广到球面几何,可能会提供洞察内爆动力学中遇到的PDD。

英文摘要:

The effect of the laser ray incidence angle on the mass ablation rate and ablation pressure of planar inertial confinement fusion (ICF) targets is explored using an idealized model. Polar direct drive (PDD) on the National Ignition Facility (NIF) requires the repointing of its 192 beams clustered within 50 degrees of the poles to minimize the imparted polar varying payload kinetic energy of the target. Due to this repointing, non-normal incidence angles of the beam centerlines are encountered in any PDD design. The formulation of a PDD scheme that minimizes non-uniformity is a significant challenge that requires an understanding of the induced differences in ablation including those of incidence angle. In this work, a modified version of the textbook model of laser ablation [Manheimer et al. Phys. Fluids 25, 1644 (1982)] is used to demonstrate that the mass ablation rate and ablation pressure scale with the 4/3 and 2/3 power of the cosine of the laser ray incidence angle for the planar case during the beginning portion of the laser ablation. This result is considered with an idealized 1-D two segment planar model using rays at different incidence angles for each segment. Within the model, the segments cannot have equal mass and velocity simultaneously without tailoring the ray's time-dependent intensity for each segment. However, with the correct segment-to-segment time-independent ray intensities, equal velocity and dynamic pressure can be achieved approximately without tailoring. Additionally, an analytic prediction for the conduction zone width as a function of incidence angle is provided. It is predicted that this width increases with incidence angle, resulting in a decrease in laser imprint, an effect which has been previously observed in experiments. These results, when generalized to spherical geometry, may provide insight into the implosion dynamics encountered in PDD.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑