用于超导屏蔽(SuShi)隔膜的NbTi/Nb/Cu多层屏蔽
NbTi/Nb/Cu multilayer shield for the superconducting shield (SuShi) septum
摘要:
一个被动的超导屏蔽被提出来实现未来圆形对撞机的高场(3-4 T)隔膜磁铁。本文介绍了一种有潜力的屏蔽材料--NbTi/Nb/Cu多层板的实验结果。圆柱形屏蔽由两半组成,每半由4层组成,总厚度为3.2 mm,并插入备用LHC偶极校正器磁体(MCBY)的孔中。在4.2K,屏蔽体表面至3.1T的温度范围内,屏蔽体内仅测得12.5mT的漏磁场。这可以归因于两个半圆柱体的未对准,如通过有限元模拟所证实的。在更好的配置下,我们估计屏蔽的衰减优于$\mathbf{4\times 10^{-5}}$,对于预期应用是可接受的。在3.1~T以上,磁场穿透平稳。低于该极限,即使在屏蔽表面超过50 mT/s的最高可实现斜坡率下也没有观察到通量跳跃。一个“消磁”周期被用来消除被困在屏蔽的厚壁中的场的影响,否则它会扭曲提取光束位置处的均匀场图案。在1.9K时屏蔽性能优于4.2K时的屏蔽性能,但存在通量跳变现象。
英文摘要:
A passive superconducting shield was proposed earlier to realize a high-field (3-4 T) septum magnet for the Future Circular Collider. This paper presents the experimental results of a potential shield material, a NbTi/Nb/Cu multilayer sheet. A cylindrical shield was constructed from two halves, each consisting of 4 layers with a total thickness of 3.2~mm, and inserted into the bore of a spare LHC dipole corrector magnet (MCBY). At 4.2~K, up to about 3.1~T at the shield's surface only a leakage field of 12.5~mT was measured inside the shield. This can be attributed to the mis-alignment of the two half cylinders, as confirmed by finite element simulations. With a better configuration we estimate the shield's attenuation to be better than $\mathbf{4\times 10^{-5}}$, acceptable for the intended application. Above 3.1~T the field penetrated smoothly. Below that limit no flux jumps were observed even at the highest achievable ramp rate of more than 50~mT/s at the shield's surface. A 'degaussing' cycle was used to eliminate the effects of the field trapped in the thick wall of the shield, which could otherwise distort the homogeneous field pattern at the extracted beam's position. At 1.9~K the shield's performance was superior to that at 4.2~K, but it suffered from flux jumps.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。