近红外连续波源过渡边缘传感器信号的多脉冲拟合
Multi-pulse fitting of Transition Edge Sensor signals from a near-infrared continuous-wave source
摘要:
过渡边传感器(TES)是一种具有近单位效率的光子数分辨量热光谱仪。它们的恢复时间,这是在微秒的数量级,限制了在高光子通量条件下的数量分辨能力和定时精度。这通常通过脉冲光源或丢弃重叠信号来解决,从而限制了其适用性。我们提出了一种方法来分配检测时间重叠的检测事件在低信噪比的制度,在TES检测近红外辐射的情况下。我们使用一个两级的时间戳,固有的鲁棒性对噪声,粗略定位脉冲的时间,并通过拟合一个启发式模型的时间戳个人的光事件。作为一个例子,我们测量的二阶时间相关的相干源在一个单一的空间模式使用一个单一的TES检测器。
英文摘要:
Transition-edge sensors (TES) are photon-number resolving calorimetric spectrometers with near unit efficiency. Their recovery time, which is on the order of microseconds, limits the number resolving ability and timing accuracy in high photon-flux conditions. This is usually addressed by pulsing the light source or discarding overlapping signals, thereby limiting its applicability. We present an approach to assign detection times to overlapping detection events in the regime of low signal-to-noise ratio, as in the case of TES detection of near-infrared radiation. We use a two-level discriminator, inherently robust against noise, to coarsely locate pulses in time, and timestamp individual photoevents by fitting to a heuristic model. As an example, we measure the second-order time correlation of a coherent source in a single spatial mode using a single TES detector.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。