基于电容的可穿戴IoTs运动传感器
Capacitor Based Activity Sensing for Kinetic Powered Wearable IoTs
摘要:
我们提出了传统能量存储组件的新用途,即,电容器,在动力可穿戴物联网中作为传感器来检测人类活动。由于不同的活动以不同的速率在电容器中积累能量,因此可以通过观察电容器的充电速率来直接检测这些活动。所提出的基于电容器的活动感测机制(称为CapSense)的关键优点在于,它消除了在活动检测时段期间对运动信号进行采样的需要,从而显著地节省了可穿戴设备的功耗。我们面临的一个挑战是,电容器本质上是非线性能量存储器,即使对于相同的活动,也会导致不同时间的充电速率发生显著变化,具体取决于电容器的当前充电水平。我们通过联合配置电容器和相关能量收集电路的参数来解决这个问题,这使我们能够在近似线性的充电周期上操作。我们设计并实现了一个动力鞋底,并进行了实验与10个科目。我们的研究结果表明,CapSense可以以95%的准确率对五种不同的日常活动进行分类,同时与传统的基于运动信号的活动检测相比,系统功耗降低了73%。
英文摘要:
We propose a novel use of the conventional energy storage component, i.e., capacitor, in kinetic-powered wearable IoTs as a sensor to detect human activities. Since different activities accumulate energies in the capacitor at different rates, these activities can be detected directly by observing the charging rate of the capacitor. The key advantage of the proposed capacitor based activity sensing mechanism, called CapSense, is that it obviates the need for sampling the motion signal during the activity detection period thus significantly saving power consumption of the wearable device. A challenge we face is that capacitors are inherently non-linear energy accumulators, which, even for the same activity, leads to significant variations in charging rates at different times depending on the current charge level of the capacitor. We solve this problem by jointly configuring the parameters of the capacitor and the associated energy harvesting circuits, which allows us to operate on charging cycles that are approximately linear. We design and implement a kinetic-powered shoe sole and conduct experiments with 10 subjects. Our results show that CapSense can classify five different daily activities with 95% accuracy while consuming 73% less system power compared to conventional motion signal based activity detection.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。