arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 1804.04848physics.ins-det
收藏

用于固体和液体样品双向3 Ω热表征的带玻璃通孔的微加工传感器平台

Microfabricated sensor platform with through-glass vias for bidirectional 3-omega thermal characterization of solid and liquid samples

Corinna Grosse, Mohamad Abo Ras, Aapo Varpula, Kestutis Grigoras, Daniel May, Bernhard Wunderle, Pierre-Olivier Chapuis, Séverine Gomès, Mika Prunnila

摘要:

提出了一种新型的微加工全电测量平台,用于直接、准确和快速地测量液体和固体材料的热导率和扩散率。测量方法基于双向3 Ω方法。该平台是由玻璃基板上的传感器结构和一个非常薄的介电纳米层压钝化层制造。使用玻璃通孔从芯片背面接触传感器,使平台的顶面在3 Ω测量期间不受样品沉积、操作和光学检查的影响。通过原子层沉积在平台表面上的薄钝化层提供了优异的耐化学性,并允许测量导电样品,同时保持简单热分析的条件。我们演示了硼硅酸盐玻璃,纯水,甘油,2-丙醇,PDMS,固化环氧树脂和散热器化合物的热导率的测量。结果与文献值和稳态分杆法获得的值相当。小的样品体积(~0.02 mm $^2$)足以使用该平台进行精确测量,允许快速测量热特性的温度依赖性,这对于许多材料(如液体、凝胶、糊状物和固体)的开发、优化和质量测试非常有用。

英文摘要:

A novel microfabricated, all-electrical measurement platform is presented for a direct, accurate and rapid determination of the thermal conductivity and diffusivity of liquid and solid materials. The measurement approach is based on the bidirectional 3-omega method. The platform is composed of glass substrates on which sensor structures and a very thin dielectric nanolaminate passivation layer are fabricated. Using through-glass vias for contacting the sensors from the chip back side leaves the top side of the platform free for deposition, manipulation and optical inspection of the sample during 3-omega measurements. The thin passivation layer, which is deposited by atomic layer deposition on the platform surface, provides superior chemical resistance and allows for the measurement of electrically conductive samples, while maintaining the conditions for a simple thermal analysis. We demonstrate the measurement of thermal conductivities of borosilicate glass, pure water, glycerol, 2-propanol, PDMS, cured epoxy, and heat-sink compounds. The results compare well with both literature values and values obtained with the steady-state divided bar method. Small sample volumes (~0.02 mm$^2$) suffice for accurate measurements using the platform, allowing rapid temperature-dependent measurements of thermal properties, which can be useful for the development, optimization and quality testing of many materials, such as liquids, gels, pastes and solids.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑