arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1709.08808physics.app-phcond-mat.supr-con
收藏

锥形阻抗Transformer的变分理论

Variational theory of the tapered impedance transformer

R P Erickson

摘要:

超导放大器是现代量子信息电路的关键部件。为了最大限度地减少信息丢失和减少振荡,需要在输入/输出处使用新设计的锥形阻抗Transformer,以符合其他50个$Ω$组件的要求。我们表明,一个最佳的锥形Transformer的长度$\ell$,加入放大器的输入线,可以构造使用变分原理应用到线性化Riccati方程描述的电压反射系数的锥度。对于频率为$ω_o$的入射信号,变分解导致等效最佳Transformers的无限集合,每个具有相同形式的反射系数,每个能够消除输入线反射。对于最佳无损Transformers的特殊情况下,群速度$v_g$被证明是恒定的,与频率依赖的特性阻抗$ω_c=πv_g / \ell$。虽然这些解决方案仅针对频率$ω_o$抑制输入线反射,但是具有与$ω_c$显著失谐的$ω_o$的最佳无损Transformers的子集确实表现出宽带通。具体地说,通过选择$ω_o\rightarrow 0$($ω_o\rightarrow\infty$),我们获得了一个子集的最佳低通(高通)无损锥与带宽$(0,\simω_c)$($(\simω_c,\infty)$)。从解决方案的子集,我们得到的宽带低通和高通Transformers,我们讨论了在何种程度上可以实现给定的制造限制。特别是,我们证明了我们的高通Transformer与其他锥形设计相比具有出色的反射响应。我们的结果有应用放大器,收发器,和其他元件的阻抗失配敏感。

英文摘要:

Superconducting amplifiers are key components of modern quantum information circuits. To minimize information loss and reduce oscillations a tapered impedance transformer of new design is needed at the input/output for compliance with other 50 $Ω$ components. We show that an optimal tapered transformer of length $\ell$, joining amplifier to input line, can be constructed using a variational principle applied to the linearized Riccati equation describing the voltage reflection coefficient of the taper. For an incident signal of frequency $ω_o$ the variational solution results in an infinite set of equivalent optimal transformers, each with the same form for the reflection coefficient, each able to eliminate input-line reflections. For the special case of optimal lossless transformers, the group velocity $v_g$ is shown to be constant, with characteristic impedance dependent on frequency $ω_c=πv_g / \ell$. While these solutions inhibit input-line reflections only for frequency $ω_o$, a subset of optimal lossless transformers with $ω_o$ significantly detuned from $ω_c$ does exhibit a wide bandpass. Specifically, by choosing $ω_o\rightarrow 0$ ($ω_o\rightarrow\infty$), we obtain a subset of optimal low-pass (high-pass) lossless tapers with bandwidth $(0,\simω_c)$ ($(\simω_c,\infty)$). From the subset of solutions we derive both the wide-band low-pass and high-pass transformers, and we discuss the extent to which they can be realized given fabrication constraints. In particular, we demonstrate the superior reflection response of our high-pass transformer when compared to other taper designs. Our results have application to amplifier, transceiver, and other components sensitive to impedance mismatch.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑