arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1709.01783physics.flu-dyn
收藏

两相沸腾流动模型在OpenFOAM中的实现与验证

Implementation and validation of two-phase boiling flow models in OpenFOAM

Kai Fu, Henryk Anglart

摘要:

使用计算流体动力学(CFD)方法预测两相沸腾流动是非常具有挑战性的,因为在这种流动中的界面质量、动量和能量传递的几个子模型仍然没有很好地建立,需要进一步的开发和验证。一旦验证了一个特定的模型,重要的是要仔细验证模型中涉及的所有关键参数。这种验证通常通过单独的效果测试来执行,其中每次将一个参数与测量值或以其他方式已知的值进行比较。不用说,对于复杂的模型,这是典型的两相流CFD应用,需要验证的独立参数的数量可能相当高。这个特殊的功能使得复杂CFD模型的验证过程在开源代码中非常有吸引力,因为可以完全访问实现细节。本文关注的是使用OpenFOAM,开源环境中的两相沸腾泡状流模型的实施和验证。该模型采用双流体的守恒方程与湍流项的平均处理。该模型由六个守恒方程的液体和蒸汽相,允许的热力学非平衡和压缩性的两相。此外,该模型还包括两个湍流动能和能量耗散的输运方程和一个界面浓度的输运方程。新的壁面热分配模型以及核态沸腾中的相变项已经实现。敏感性研究以及验证的模型对测量数据在公开文献中已经进行,它已被证明,预测和实验之间的合理协议已经实现。

英文摘要:

Prediction of two-phase boiling flows using the computational fluid dynamics (CFD) approach is very challenging since several sub-models for interfacial mass, momentum and energy transfer in such flows are still not well established and require further development and validation. Once validating a particular model, it is important that all key parameter involved in the model are carefully verified. Such verification is typically performed by separate effect tests, where one parameter at a time is compared to a measured or otherwise known value. Needless to say that for complex models, which are typical for CFD applications to two-phase flow, the number of independent parameters that need to be verified can be quite high. This particular feature makes the validation process of complex CFD models in open source codes very attractive, since full access to the implementation details is possible. This paper is concerned with implementation and validation of two-phase boiling bubbly flow models using the OpenFOAM, open source environment. The model employs the two-fluid formulation of the conservation equations with the Reynolds-averaged treatment of the turbulent terms. The model consists of six conservation equations for the liquid and the vapor phase, allowing for the thermodynamic non-equilibrium and compressibility of both phases. In addition, the model includes two transport equations for the turbulence kinetic energy and energy dissipation and one transport equation for the interfacial area concentration. New models for wall heat partitioning as well as for the phase change terms in nucleate boiling have been implemented. Sensitivity studies as well as validation of the model against measured data available in the open literature have been performed and it has been shown that a reasonable agreement between predictions and experiments has been achieved.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑