arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 1708.08038astro-ph.EP
收藏

风化层模拟物压缩特性的试验研究

Experimental study on compression property of regolith analogues

Tomomi Omura, Akiko M. Nakamura

摘要:

风化层的压缩性反映了小天体上风化层的强度和孔隙度及其在层内的变化,对天体的碰撞和热演化有重要影响。我们进行了压缩实验,并研究了孔隙率和压缩之间的关系,使用蓬松的颗粒样品。我们专注于低压和高孔隙度的制度。我们用几十μ m大小的不规则和球形粉末作为多孔风化层的模拟物。样品的初始孔隙度范围为0.80至0.53。施加到样品上的单轴压力在30至4x10^5 Pa的范围内。样品的孔隙率在低于阈值压力时保持在其初始值,然后当压力超过阈值时减小。我们将阈值处的单轴压力定义为“屈服强度”。屈服强度随着试样初始孔隙率的降低而增加。当试样具有相同的初始孔隙率时,由不规则颗粒组成的试样的屈服强度并不显著地依赖于它们的尺寸分布。我们比较了我们的实验结果与以前提出的理论模型。我们计算的平均颗粒间的力作用于接触点的组成颗粒的单轴压力下的屈服强度的理论模型,并将其与理论估计的力滚动或滑动的颗粒。计算的颗粒间力大于滚动摩擦力,小于滑动摩擦力。风化层的屈服强度可能受到这些力的制约。我们的研究结果可能是有用的行星科学家估计的深度以上的风化层的孔隙度几乎等于的风化层表面和解释的压缩性能的小行星表面获得的着陆器。

英文摘要:

The compression property of regolith reflects the strength and porosity of the regolith layer on small bodies and their variations in the layer that largely influence the collisional and thermal evolution of the bodies. We conducted compression experiments and investigated the relationship between the porosity and the compression using fluffy granular samples. We focused on a low-pressure and high-porosity regime. We used tens of μm-sized irregular and spherical powders as analogs of porous regolith. The initial porosity of the samples ranged from 0.80 to 0.53. The uniaxial pressure applied to the samples lays in the range from 30 to 4x10^5 Pa. The porosity of the samples remained at their initial values below a threshold pressure and then decreased when the pressure exceeded the threshold. We defined this uniaxial pressure at the threshold as "yield strength". The yield strength increased as the initial porosity of a sample decreased. The yield strengths of samples consisting of irregular particles did not significantly depend on their size distributions when the samples had the same initial porosity. We compared the results of our experiments with a previously proposed theoretical model. We calculated the average interparticle force acting on contact points of constituent particles under the uniaxial pressure of yield strength using the theoretical model and compared it with theoretically estimated forces required to roll or slide the particles. The calculated interparticle force was larger than the rolling friction force and smaller than the sliding friction force. The yield strength of regolith may be constrained by these forces. Our results may be useful for planetary scientists to estimate the depth above which the porosity of a regolith layer is almost equal to that of the regolith surface and to interpret the compression property of an asteroid surface obtained by a lander.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑