arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 1707.03581cs.CEcs.NAcs.SYeess.SYmath.NA
收藏

迈向实时机器工具热变形有限元模拟

Toward transient finite element simulation of thermal deformation of machine tools in real-time

Technische Universität Dresden(德累斯顿工业大学);University of Leeds(利兹大学)

Andreas Naumann, Daniel Ruprecht, Joerg Wensch

AI总结:

本文提出一种高阶隐式-显式多速率时间步进方法,用于实时模拟机器工具的热变形,以克服传统有限元方法在实时计算中的计算成本限制。

摘要:

没有简化假设的有限元模型可以准确描述机床中热量的时空分布以及由此产生的变形。原则上,这允许校正工具中心点的位移,从而实现高精度制造。然而,FEM模型的计算成本以及商业工具如ANSYS中通用算法的限制,阻碍了其实际应用,因为模拟必须比实时快。对于热扩散速度远低于机器运动速度的情况,我们引入了一种基于谱延迟校正的高阶隐式-显式多速率时间步进方法。使用开源有限元库DUNE,我们证明了对于由滑动工件在轨道上上下滑动并固定在支架上的机器,可以实现温度场的完全耦合实时模拟。

英文摘要:

Finite element models without simplifying assumptions can accurately describe the spatial and temporal distribution of heat in machine tools as well as the resulting deformation. In principle, this allows to correct for displacements of the Tool Centre Point and enables high precision manufacturing. However, the computational cost of FEM models and restriction to generic algorithms in commercial tools like ANSYS prevents their operational use since simulations have to run faster than real-time. For the case where heat diffusion is slow compared to machine movement, we introduce a tailored implicit-explicit multi-rate time stepping method of higher order based on spectral deferred corrections. Using the open-source FEM library DUNE, we show that fully coupled simulations of the temperature field are possible in real-time for a machine consisting of a stock sliding up and down on rails attached to a stand.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑