In this work, we demonstrate the use of frequency-tunable superconducting NbTiN coplanar waveguide microresonators for multi-frequency pulsed electron spin resonance (ESR) experiments. By applying a bias current to the center pin, the resonance frequency ($\sim$7.6 GHz) can be continuously tuned by as much as 95 MHz in 270 ns without a change in the quality factor of 3000 at 2K. We demonstrate the ESR performance of our resonators by measuring donor spin ensembles in silicon and show that adiabatic pulses can be used to overcome magnetic field inhomogeneities and microwave power limitations due to the applied bias current. We take advantage of the rapid tunability of these resonators to manipulate both phosphorus and arsenic spins in a single pulse sequence, demonstrating pulsed double electron-electron resonance (DEER). Our NbTiN resonator design is useful for multi-frequency pulsed ESR and should also have applications in experiments where spin ensembles are used as quantum memories.
We show that pairs of atoms optically excited to the Rydberg states can strongly interact with each other via effective long-range dipole-dipole or van der Waals interactions mediated by their non-resonant coupling to a common microwave field mode of a superconducting coplanar waveguide cavity. These cavity mediated interactions can be employed to generate single photons and to realize in a scalable configuration a universal phase gate between pairs of single photon pulses propagating or stored in atomic ensembles in the regime of electromagnetically induced transparency.
We study a tripartite quantum system consisting of a coplanar-waveguide (CPW) resonator and a nanomechanical resonator (NAMR) connected by a flux qubit, where the flux qubit has a large detuning from both resonators. By a unitray transformation and a second-order approximation, we obtain a strong and controllable (i.e., magnetic-field-dependent) effective coupling between the NAMR and the CPW resonator. Due to the strong coupling, vacuum Rabi splitting can be observed from the voltage-fluctuation spectrum of the CPW resonator. We further study the properties of single photon transport as infer…
We investigate the dynamical Casimir effect in a coplanar waveguide (CPW) terminated by a superconducting quantum interference device (SQUID). Changing the magnetic flux through the SQUID parametrically modulates the boundary condition of the CPW, and thereby, its effective length. Effective boundary velocities comparable to the speed of light in the CPW result in broadband photon generation which is identical to the one calculated in the dynamical Casimir effect for a single oscillating mirror. We estimate the power of the radiation for realistic parameters and show that it is experimentally …
We study a flux qubit in a coplanar waveguide resonator by measuring transmission through the system. In our system with the flux qubit decoupled galvanically from the resonator, the intermediate coupling regime is achieved. In this regime dispersive readout is possible with weak backaction on the qubit. The detailed theoretical analysis and simulations give a good agreement with the experimental data and allow to make the qubit characterization.
Watching a Superconducting Coplanar Waveguide Heat Up with a Single Color Center
Karlsruhe Institute of Technology (KIT)（卡尔斯鲁厄理工学院）；Physikalisches Institut (PHI)（物理研究所）；Institute for Quantum Materials and Technologies (IQMT)（量子材料与技术研究所）
Superconducting quantum computing architectures comprise resonators and qubits that experience energy loss due to two-level systems (TLS) in bulk and interfacial dielectrics. Understanding these losses is critical to improving performance in superconducting circuits. In this work, we present a method for quantifying the TLS losses of different bulk and interfacial dielectrics present in superconducting coplanar waveguide (CPW) resonators. By combining statistical characterization of sets of specifically designed CPW resonators on isotropically etched silicon substrates with detailed electromag…
We characterize low-loss electron-beam evaporated niobium thin films deposited under ultra-high vacuum conditions. Slow deposition yields films with a high superconducting transition temperature ($9.20 \pm 0.06 \rm ~K$) as well as a residual resistivity ratio of $4.8$. We fabricate the films into coplanar waveguide resonators to extract the intrinsic loss due to the presence of two-level-system fluctuators using microwave measurements. For a coplanar waveguide resonator gap of $2~μ\rm m$, the films exhibit filling-factor-adjusted two-level-system loss tangents as low as $1.5 \times 10^{-7}$ wi…
Entanglement between atoms and microwave photons in a superconducting coplanar waveguide~(SCW) can enable hybrid quantum devices and interface static and flying qubits. We study a one-step controlled-Z~(C$_{\text{Z}}$) gate between a neutral atom trapped near a SCW and a microwave mode in the SCW, which is an extension of the gate proposed in [J. D. Pritchard, et.al., Phys. Rev. A 89, 010301(R) (2014)]. The gate protocol is simple and requires one laser pulse for exciting a transition between the ground and Rydberg states of the neutral atom.
We design and fabricate two types of superconducting niobium coplanar waveguide microwave resonators with different coupling capacitors on high purity Si substrates. Their microwave transmissions are measured at the temperatures of 20 mK. It is found that these two types of resonators possess significantly-different loaded quality factors; one is $5.6\times{10}^{3}$, and the other is $4.0\times{10}^{4}$. The measured data are fitted well by classical ABCD matrix approach. We found that the transmission peak deviates from the standard Lorentizian with a frequency broadening.
Rydberg helium atoms traveling in pulsed supersonic beams have been coupled to microwave fields in a superconducting coplanar waveguide (CPW) resonator. The atoms were initially prepared in the 1s55s $^3$S$_1$ Rydberg level by two-color two-photon laser excitation from the metastable 1s2s $^3$S$_1$ level. Two-photon microwave transitions between the 1s55s $^3$S$_1$ and 1s56s $^3$S$_1$ levels were then driven by the 19.556 GHz third-harmonic microwave field in a quarter-wave CPW resonator. This superconducting microwave resonator was fabricated from niobium nitride on a silicon substrate and op…
We report on the design, fabrication and characterization of superconducting coplanar waveguide resonators with nanoscopic constrictions. By reducing the size of the center line down to 50 nm, the radio frequency currents are concentrated and the magnetic field in its vicinity is increased. The device characteristics are only slightly modified by the constrictions, with changes in resonance frequency lower than 1% and internal quality factors of the same order of magnitude as the original ones. These devices could enable the achievement of higher couplings to small magnetic samples or even to …
Improving the performance of superconducting qubits and resonators generally results from a combination of materials and fabrication process improvements and design modifications that reduce device sensitivity to residual losses. One instance of this approach is to use trenching into the device substrate in combination with superconductors and dielectrics with low intrinsic losses to improve quality factors and coherence times. Here we demonstrate titanium nitride coplanar waveguide resonators with mean quality factors exceeding two million and controlled trenching reaching 2.2 $μ$m into the s…
This white paper presents a single-layer mask, found at https://github.com/Boulder-Cryogenic-Quantum-Testbed/simple-resonator-mask. It is designed for fabrication of superconducting microwave resonators towards 1:1 comparisons of dielectric losses from the metal-substrate interface. Finite-element electromagnetic simulations are used to determine participation ratios of the four major regions of the on-chip devices, as well as to confirm lack of crosstalk between neighboring devices and demonstrate coupling tunability over three orders of magnitude. This mask is intended as an open-source comm…
Recent experiments on the coupling of the in-plane motional state of electrons floating on the surface of liquid helium to a microwave resonator have revealed the importance of helium surface fluctuations to the coherence of this motion. Here we investigate these surface fluctuations by studying the resonance properties of a superconducting coplanar waveguide (CPW) resonator filled with superfluid helium, where a significant fraction of the resonator's electromagnetic mode volume is coupled to the surface dynamics of the liquid. We present preliminary results on real-time CPW resonator frequen…
We demonstrate the use of high-Q superconducting coplanar waveguide (CPW) microresonators to perform rapid manipulations on a randomly distributed spin ensemble using very low microwave power (400 nW). This power is compatible with dilution refrigerators, making microwave manipulation of spin ensembles feasible for quantum computing applications. We also describe the use of adiabatic microwave pulses to overcome microwave magnetic field ($B_{1}$) inhomogeneities inherent to CPW resonators. This allows for uniform control over a randomly distributed spin ensemble. Sensitivity data are reported …
Ultimate sensitivity for quantum magnetometry using nitrogen-vacancy (NV) centers in diamond is limited by number of NV centers and coherence time. Microwave irradiation with a high and homogeneous power density for a large detection volume is necessary to achieve highly sensitive magnetometer. Here, we demonstrate a microwave resonator to enhance the power density of the microwave field and an optical system with a detection volume of 1.4e-3 mm$^3$. The strong microwave field enables us to achieve 48 ns Rabi oscillation which is sufficiently faster than the phase relaxation time of NV centers…
Superconducting coplanar-waveguide (CPW) resonators are one of the key devices in circuit quantum electrodynamics (cQED). Their performance can be limited by dielectric losses in the substrate and in the material interfaces. Reliable modeling is required to aid in the design of low-loss CPW structures for cQED. We analyze the geometric dependence of the dielectric losses in CPW structures using finite-element modeling of the participation ratios of the lossy regions. In a practical scenario, uncertainties in the the dielectric constants and loss tangents of these regions introduce uncertaintie…
We propose a scheme of a universal block of broadband quantum memory consisting of three ring microresonators forming a controllable frequency comb and interacting with each other and with a common waveguide. We find the optimal parameters of the microresonators showing the possibility of highly efficient storage of light fields on this memory block and we demonstrate the procedure for gluing several memory blocks for increasing spectral range of the composite quantum memory while maintaining high efficiency.
Superconducting qubits are sensitive to a variety of loss mechanisms which include dielectric loss from interfaces. The calculation of participation near the key interfaces of planar designs can be accomplished through an analytical description of the electric field density based on conformal mapping. In this way, a two-dimensional approximation to coplanar waveguide and capacitor designs produces values of the participation as a function of depth from the top metallization layer as well as the volume participation within a given thickness from this surface by reducing the problem to a surface…
This thesis explores the coupling of magnetic systems to quantum circuits in the context of quantum computing applications. In particular we study the coupling of superconducting coplanar waveguide resonators to Single Molecule Magnets (SMMs) . The combination of approaches from the fields of Cavity Quantum electrodynamics (QED) and Circuit QED with those from the field of molecular magnetism con provide unique opportunities for quantum computing. We investigate the necessary conditions for coupling single spins and spin ensembles to resonators and what characteristics SMMs should have in orde…
We report on cryogenic coupling of organic molecules to ring microresonators obtained by looping sub-wavelength waveguides (nanoguides). We discuss fabrication and characterization of the chip-based nanophotonic elements which yield resonator finesse in the order of 20 when covered by molecular crystals. Our observed extinction dips from single molecules reach 22%, consistent with the expected Purcell enhancements up to 11 folds. Future efforts will aim at efficient coupling of a handful of molecules via their interaction with a ring microresonator mode, setting the ground for the realization …
We propose a scheme able to entangle at the steady state a nanomechanical resonator with a microwave cavity mode of a driven superconducting coplanar waveguide. The nanomechanical resonator is capacitively coupled with the central conductor of the waveguide and stationary entanglement is achievable up to temperatures of tens of milliKelvin.
The propagation of short lightpulses in waveguiding structures with optical feedback, in our case optical microresonators, has been studied theoretically and experimentally. It appears that, dependent on the measurement set-up, ballistic transport or interference in the time domain of fs and ps laser pulses can be observed. The experiments are analyzed in terms of characteristic time scales of the source, the waveguide device and the detector arrangement and are related to Heisenberg's uncertainty principle. Based on this analysis a criterion is given for the upper bitrate for error free data …
We report a notch-shaped coplanar microwave waveguide antenna on a glass plate designed for on-chip detection of optically detected magnetic resonance (ODMR) of fluorescent nanodiamonds (NDs). A lithographically patterned thin wire at the center of the notch area in the coplanar waveguide realizes a millimeter-scale ODMR detection area (1.5 x 2.0 mm^2) and gigahertz-broadband characteristics with low reflection (about 8%). The ODMR signal intensity in the detection area is quantitatively predictable by numerical simulation. Using this chip device, we demonstrate a uniform ODMR signal intensity…
We propose a novel hybrid quantum gate between an atom and a microwave photon in a superconducting coplanar waveguide cavity by exploiting the strong resonant microwave coupling between adjacent Rydberg states. Using experimentally achievable parameters gate fidelities $> 0.99$ are possible on sub-$μ$s timescales for waveguide temperatures below 40 mK. This provides a mechanism for generating entanglement between two disparate quantum systems and represents an important step in the creation of a hybrid quantum interface applicable for both quantum simulation and quantum information processing.
We propose and analyze a hybrid device by integrating a microscale diamond beam with a single built-in nitrogen-vacancy (NV) center spin to a superconducting coplanar waveguide (CPW) cavity. We find that under an ac electric field the quantized motion of the diamond beam can strongly couple to the single cavity photons via dielectric interaction. Together with the strong spin-motion interaction via a large magnetic field gradient, it provides a hybrid quantum device where the dia- mond resonator can strongly couple both to the single microwave cavity photons and to the single NV center spin. T…
A strategy aimed at decreasing dielectric loss in coplanar waveguides (CPW) and qubits involves the creation of trenches in the underlying substrate within the gaps of the overlying metallization. Participation of contamination layers residing on surfaces and interfaces in these designs can be reduced due to the change in the effective dielectric properties between the groundplane and conductor metallization. Although finite element method approaches have been previously applied to quantify this decrease, an analytical method is presented that can uniquely address geometries possessing small t…
