In order to meet its cutting-edge scientific objectives, the Square Kilometre Array (SKA) telescope requires high-precision frequency references to be distributed to each of its antennas. The frequency references are distributed via fiber-optic links and must be actively stabilized to compensate for phase-noise imposed on the signals by environmental perturbations on the links. SKA engineering requirements demand that any proposed frequency reference distribution system be proved in "astronomical verification" tests. We present results of the astronomical verification of a stabilized frequency reference transfer system proposed for SKA-mid. The dual-receiver architecture of the Australia Telescope Compact Array was exploited to subtract the phase-noise of the sky signal from the data, allowing the phase-noise of observations performed using a standard frequency reference, as well as the stabilized frequency reference transfer system transmitting over 77 km of fiber-optic cable, to be directly compared. Results are presented for the fractional frequency stability and phase-drift of the stabilized frequency reference transfer system for celestial calibrator observations at 5 GHz and 25 GHz. These observations plus additional laboratory results for the transferred signal stability over a 166 km metropolitan fiber-optic link are used to show that the stabilized transfer system under test exceeds all SKA phase-stability requirements under a broad range of observing conditions. Furthermore, we have shown that alternative reference dissemination systems that use multiple synthesizers to supply reference signals to sub-sections of an array may limit the imaging capability of the telescope.
We present a stabilized microwave-frequency transfer technique that is based on optical phase-sensing and optical phase-actuation. This technique shares several attributes with optical-frequency transfer and therefore exhibits several advantages over other microwave-frequency transfer techniques. We demonstrated stabilized transfer of an 8,000 MHz microwave-frequency signal over a 166 km metropolitan optical fiber network, achieving a fractional frequency stability of 6.8x10^-14 Hz/Hz at 1 s integration, and 5.0x10^-16 Hz/Hz at 1.6x10^4 s. This technique is being considered for use on the Squa…
We review the current status of the Square Kilometre Array (SKA) by outlining the science drivers for its Phase-1 (SKA1) and setting out the timeline for the key decisions and milestones on the way to the planned start of its construction in 2016. We explain how Phase-2 SKA (SKA2) will transform the research scope of the SKA infrastructure, placing it amongst the great astronomical observatories and survey instruments of the future, and opening up new areas of discovery, many beyond the confines of conventional astronomy.
We describe and experimentally evaluate a stabilized radio-frequency transfer technique that employs optical phase sensing and optical phase actuation. This technique can be achieved by modifying existing stabilized optical frequency equipment and also exhibits advantages over previous stabilized radio-frequency transfer techniques in terms of size and complexity. We demonstrate the stabilized transfer of a 160 MHz signal over an 166 km fiber optical link, achieving an Allan deviation of 9.7x10^-12 Hz/Hz at 1 s of integration, and 3.9x10^-1414 Hz/Hz at 1000 s. This technique is being considere…
SKA (Square Kilometer Array), currently under design, will be a huge radio-astronomical facility, whose management will be performed by a suite of software applications called Telescope Manager (SKA TM) via the TANGO framework. In order to ensure the proper and uninterrupted operation of TM, a local monitoring and control system (TM.LMC) is being developed, with the goal to perform monitoring, lifecycle control and fault management of TM. For the monitoring activity, central in TM.LMC, Nagios (automated by the lifecycle management tool Chef) has been proposed as main toolkit to check resources…
Next generation radio telescopes, such as the Square Kilometre Array (SKA) and Next Generation Very Large Array (ngVLA), require precise microwave frequency reference signals to be transmitted over fiber links to each dish to coherently sample astronomical signals. Such telescopes employ phase stabilization systems to suppress the phase noise imparted on the reference signals by environmental perturbations on the links; however, the stabilization systems are bandwidth limited by the round-trip time of light travelling on the fiber links. A phase-locked Receiver Module (RM) is employed on each …
With the establishment of the AUT University 12m radio telescope at Warkworth, New Zealand has now become a part of the international Very Long Baseline Interferometry (VLBI) community. A major product of VLBI observations are images in the radio domain of astronomical objects such as Active Galactic Nuclei (AGN). Using large geographical separations between radio antennas, very high angular resolution can be achieved. Detailed images can be created using the technique of VLBI Earth Rotation Aperture Synthesis. We review the current process of VLBI radio imaging. In addition we model VLBI conf…
We demonstrate a compact 29.3 GHz visible astro-comb covering the spectrum from 560nm to 700nm. A 837 MHz Yb:fiber laser frequency comb phase locked to a Rb clock served as the seed comb to ensure the frequency stability and high side mode suppression ratio. After the visible super-continuum generation, a cavity-length-fixed Fabry-Perot cavity made by ultra-low expansion glass was utilized to filter the comb teeth for eliminating the rapid active dithering. The mirrors were home-made complementary chirped mirrors pair with zero dispersion and high reflection to guarantee no mode skipping. Thes…
In this decade astronomy is undergoing a paradigm shift to handle data from next generation observatories such as the Square Kilometre Array (SKA) or the Vera C. Rubin Observatory (LSST). Producing real time data streams of up to 10 TB/s and data products of the order of 600 Pbytes/year, the SKA will be the biggest civil data producing machine of the world that demands novel solutions on how these data volumes can be stored and analysed. Through the use of complex, automated pipelines the provenance of this real time data processing is key to establish confidence within the system, its final d…
A new generation of observational science instruments is dramatically increasing collected data volumes in a range of fields. These instruments include the Square Kilometre Array (SKA), Large Synoptic Survey Telescope (LSST), terrestrial sensor networks, and NASA satellites participating in "decadal survey" missions. Their unprecedented coverage and sensitivity will likely reveal wholly new categories of unexpected and transient events. Commensal methods passively analyze these data streams, recognizing anomalous events of scientific interest and reacting in real time. We report on a case exam…
We have measured the aperture-array noise temperature of the first Mk. II phased array feed that CSIRO has built for the Australian Square Kilometre Array Pathfinder telescope. As an aperture array, the Mk. II phased array feed achieves a beam equivalent noise temperature less than 40 K from 0.78 GHz to 1.7 GHz and less than 50 K from 0.7 GHz to 1.8 GHz for a boresight beam directed at the zenith. We believe these are the lowest reported noise temperatures over these frequency ranges for ambient-temperature phased arrays. The measured noise temperature includes receiver electronics noise, ohmi…
We describe the performance of the Boolardy Engineering Test Array (BETA), the prototype for the Australian Square Kilometre Array Pathfinder telescope ASKAP. BETA is the first aperture synthesis radio telescope to use phased array feed technology, giving it the ability to electronically form up to nine dual-polarization beams. We report the methods developed for forming and measuring the beams, and the adaptations that have been made to the traditional calibration and imaging procedures in order to allow BETA to function as a multi-beam aperture synthesis telescope. We describe the commission…
Coronal magnetic fields are well known to be one of the crucial parameters defining coronal physics and space weather. However, measuring the global coronal magnetic fields remains challenging. The polarization properties of coronal radio emissions are sensitive to coronal magnetic fields. While they can prove to be useful probes of coronal and heliospheric magnetic fields, their usage has been limited by technical and algorithmic challenges. We present a robust algorithm for precise polarization calibration and imaging of low-radio frequency solar observations and demonstrate it on data from …
We describe and characterize a 25 GHz laser frequency comb based on a cavity-filtered erbium fiber mode-locked laser. The comb provides a uniform array of optical frequencies spanning 1450 nm to 1700 nm, and is stabilized by use of a global positioning system referenced atomic clock. This comb was deployed at the 9.2 m Hobby-Eberly telescope at the McDonald Observatory where it was used as a radial velocity calibration source for the fiber-fed Pathfinder near-infrared spectrograph. Stellar targets were observed in three echelle orders over four nights, and radial velocity precision of \sim10 m…
FIP-TOI: Fast Imaging Pipeline for Pulsar Localisation with a Transient-Oriented Radio Astronomical Imager
University of Oxford（牛津大学）；Silesian University in Opava（奥帕瓦西里西亚大学）；Mila - Québec Artificial Intelligence Institute（米拉-魁北克人工智能研究所）；University of Cambridge（剑桥大学）；Special Astrophysical Observatory of the Russian Academy of Sciences（俄罗斯科学院特别天体物理观测站）
The Square Kilometre Array (SKA) is called to revolutionise essentially all areas of Astrophysics. With a collecting area of about a square kilometre, the SKA will be a transformational instrument, and its scientific potential will go beyond the interests of astronomers. Its technological challenges and huge cost requires a multinational effort, and Europe has recognised this by putting the SKA on the roadmap of the European Strategy Forum for Research Infrastructures (ESFRI). The Spanish SKA White Book is the result of the coordinated effort of 120 astronomers from 40 different research cente…
A new method of polarimetric calibration is presented in which the instrumental response is derived from regular observations of PSR J0437-4715 based on the assumption that the mean polarized emission from this millisecond pulsar remains constant over time. The technique is applicable to any experiment in which high-fidelity polarimetry is required over long time scales; it is demonstrated by calibrating 7.2 years of high-precision timing observations of PSR J1022+1001 made at the Parkes Observatory. Application of the new technique followed by arrival time estimation using matrix template mat…
This paper presents the measured sensitivity of CSIRO's first Mk. II phased array feed (PAF) on an ASKAP antenna. The Mk. II achieves a minimum system-temperature-over-efficiency $T_\mathrm{sys}/η$ of 78 K at 1.23 GHz and is 95 K or better from 835 MHz to 1.8 GHz. This PAF was designed for the Australian SKA Pathfinder telescope to demonstrate fast astronomical surveys with a wide field of view for the Square Kilometre Array (SKA).
The Square Kilometre Array (SKA) is an integral part of the next-generation observatories that will survey the Universe across the electromagnetic spectrum, and beyond, revolutionizing our view of fundamental physics, astrophysics and cosmology. Owing to their extreme nature and clock-like properties, pulsars discovered and monitored by SKA will enable a broad range of scientific endeavour and play a key role in this quest. This chapter summarizes the pulsar-related science goals that will be reached with coordinated efforts among SKA and other next-generation astronomical facilities.
Optical frequency comb integration in radio telescopes: advancing signal generation and phase calibration
Korea Advanced Institute of Science and Technology (KAIST)（韩国科学技术院）；Korea Astronomy and Space Science Institute (KASI)（韩国天文学与空间科学研究所）；University of Science and Technology (UST)（科学技术联合大学院大学）；Max-Planck Institute for Radio Astronomy（马克斯·普朗克射电天文研究所）；Korea Research Institute of Standards and Science (KRISS)（韩国标准与科学研究院）
The "Square Kilometre Array" (SKA) is a large international radio telescope project characterised, as suggested by its name, by a total collecting area of approximately one square kilometre, and consisting of several interferometric arrays to observe at metric and centimetric wavelengths. The deployment of the SKA will take place in two sites, in South Africa and Australia, and in two successive phases. From its Phase 1, the SKA will be one of the most formidable scientific machines ever deployed by mankind, and by far the most impressive in terms of data throughput and required computing powe…
As of 2023, the low-frequency part of the Square Kilometre Array will go online in Australia. It will constitute the largest and most powerful low-frequency radio-astronomical observatory to date, and will facilitate a rich science programme in astronomy and astrophysics. With modest engineering changes, it will also be able to measure cosmic rays via the radio emission from extensive air showers. The extreme antenna density and the homogeneous coverage provided by more than 60,000 antennas within an area of one km$^2$ will push radio detection of cosmic rays in the energy range around 10$^{17…
This paper presents a framework to compute the receiver noise temperature (Trcv) of two low-frequency radio telescopes, the Murchison Widefield Array (MWA) and the Engineering Development Array (EDA). The MWA was selected because it is the only operational low-frequency Square Kilometre Array (SKA) precursor at the Murchison Radio-astronomy Observatory, while the EDA was selected because it mimics the proposed SKA-Low station size and configuration. It will demonstrated that the use of an existing power wave based framework for noise characterization of multiport amplifiers is sufficiently gen…
We report characterization results for an engineering prototype of a next-generation low-frequency radio astronomy array. This prototype, which we refer to as the Aperture Array Verification System 0.5 (AAVS0.5), is a sparse pseudo-random array of 16 log-periodic antennas designed for 70-450 MHz. It is co-located with the Murchison Widefield Array (MWA) at the Murchison Radioastronomy Observatory (MRO) near the Australian Square Kilometre Array (SKA) core site. We characterize the AAVS0.5 using two methods: in-situ radio interferometry with astronomical sources and an engineering approach base…
Apertif (APERture Tile In Focus) is one of the Square Kilometre Array (SKA) pathfinder facilities. The Apertif project is an upgrade to the 50-year-old Westerbork Synthesis Radio Telescope (WSRT) using phased-array feed technology. The new receivers create 40 individual beams on the sky, achieving an instantaneous sky coverage of 6.5 square degrees. The primary goal of the Apertif Imaging Survey is to perform a wide survey of 3500 square degrees (AWES) and a medium deep survey of 350 square degrees (AMES) of neutral atomic hydrogen (up to a redshift of 0.26), radio continuum emission and polar…
LOFAR, the LOw-Frequency ARray, is a new-generation radio interferometer constructed in the north of the Netherlands and across europe. Utilizing a novel phased-array design, LOFAR covers the largely unexplored low-frequency range from 10-240 MHz and provides a number of unique observing capabilities. Spreading out from a core located near the village of Exloo in the northeast of the Netherlands, a total of 40 LOFAR stations are nearing completion. A further five stations have been deployed throughout Germany, and one station has been built in each of France, Sweden, and the UK. Digital beam-f…
