一种改进的几何约束相位展开方法
Improved phase-unwrapping method using geometric constraints
摘要:
传统的双频条纹投影算法在高、低频条纹的频率比过大时,往往会出现相位解缠失败的问题。Zhang等人提出了一种增强的双频相移方法,利用数字条纹投影(DFP)的几何约束来降低由于大频率比而造成的噪声影响。然而,该方法需要对DFP系统进行标定,并计算距离摄像机最近位置处的最小相位图,这些过程相对复杂且耗时较多。本文提出了一种改进的方法,该方法省去了张氏方法中的系统标定和确定,同时也不需要使用低频条纹图。在该方法中,我们只需要一组高频条纹图案测量后,高频直接由实验估计的对象。该方法简化了计算过程,提高了计算速度.最后通过实验验证了该方法的有效性,实验结果表明,该方法能够克服Zhang方法的主要缺点。
英文摘要:
Conventional dual-frequency fringe projection algorithm often suffers from phase unwrapping failure when the frequency ratio between the high frequency and the low one is too large. Zhang et.al. proposed an enhanced two-frequency phase-shifting method to use geometric constraints of digital fringe projection(DFP) to reduce the noise impact due to the large frequency ratio. However, this method needs to calibrate the DFP system and calculate the minimum phase map at the nearest position from the camera perspective, these procedures are are relatively complex and more time-cosuming. In this paper, we proposed an improved method, which eliminates the system calibration and determination in Zhang's method,meanwhile does not need to use the low frequency fringe pattern. In the proposed method,we only need a set of high frequency fringe patterns to measure the object after the high frequency is directly estimated by the experiment. Thus the proposed method can simplify the procedure and improve the speed. Finally, the experimental evaluation is conducted to prove the validity of the proposed method.The results demonstrate that the proposed method can overcome the main disadvantages encountered by Zhang's method.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。