Iris AO分段MEMS变形镜的长期稳定性和温度变化性
Long-term stability and temperature variability of Iris AO segmented MEMS deformable mirrors
摘要:
变形镜的长期稳定性是需要开环校正的仪器的关键性能要求。DM性能中温度变化的影响对于此类仪器同样至关重要。本文研究了三种不同Iris AO PTT 111 DM的长期稳定性,这些DM在后续测试前的不同时间(13个月至近29个月)进行了校准。性能测试表明,从初始校准日期到测试日期,定位误差只略有增加。误差的增加范围从18个月后的1.38 nm rms到29个月后的5.68 nm rms。该论文还研究了小温度变化的影响,最高可达室温附近的6.2°C。对于三种不同的阵列,误差范围为0.62-1.42 nm rms/°C。消除封装影响后,误差为$\le$ 0.50 nm rms/°C。最后,测量数据表明,加热时,单个片段使$\le$变形0.11 nm rms/°C。
英文摘要:
Long-term stability of deformable mirrors (DM) is a critical performance requirement for instruments requiring open-loop corrections. The effects of temperature changes in the DM performance are equally critical for such instruments. This paper investigates the long-term stability of three different Iris AO PTT111 DMs that were calibrated at different times ranging from 13 months to nearly 29 months prior to subsequent testing. Performance testing showed that only a small increase in positioning errors occurred from the initial calibration date to the test dates. The increases in errors ranged from as little as 1.38 nm rms after 18 months to 5.68 nm rms after 29 months. The paper also studies the effects of small temperature changes, up to 6.2°C around room temperature. For three different arrays, the errors ranged from 0.62-1.42 nm rms/°C. Removing the effects of packaging shows that errors are $\le$0.50 nm rms/°C. Finally, measured data showed that individual segments deformed $\le$0.11 nm rms/°C when heated.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。