Santosh V. Vadawale, A. R. Rao, Dipankar Bhattacharya, Varun B. Bhalerao, Gulab Chand Dewangan, Ajay M. Vibute, Mithun N. P. S., Tanmoy Chattopadhyay, S. Sreekumar
备注：
11 pages, 9 figures in Proc. SPIE. 9905, Space Telescopes and Instrumentation 2016: Ultraviolet to Gamma Ray, 99051G. (July 18, 2016)
Cadmium-Zinc-Telluride Imager (CZTI) is one of the five payloads on-board recently launched Indian astronomy satellite AstroSat. CZTI is primarily designed for simultaneous hard X-ray imaging and spectroscopy of celestial X-ray sources. It employs the technique of coded mask imaging for measuring spectra in the energy range of 20 - 150 keV. It was the first scientific payload of AstroSat to be switched on after one week of the launch and was made operational during the subsequent week. Here we present preliminary results from the performance verification phase observations and discuss the in-orbit performance of CZTI.
The Cadmium Zinc Telluride Imager (CZTI) is an imaging instrument onboard AstroSat. This instrument operates as a nearly open all-sky detector above ~60 keV, making possible long integrations irrespective of the spacecraft pointing. We present a technique based on the AstroSat-CZTI data to explore the hard X-ray characteristics of the $γ$-ray pulsar population. We report highly significant ($\sim 30σ$) detection of hard X-ray (60--380 keV) pulse profile of the Crab pulsar using $\sim$5000 ks of CZTI observations within 5 to 70 degrees of Crab position in the sky, using a custom algorithm devel…
The Cadmium Zinc Telluride Imager (CZTI) onboard AstroSat is designed for hard X-ray imaging and spectroscopy in the energy range of 20 - 100 keV. The CZT detectors are of 5 mm thickness and hence have good efficiency for Compton interactions beyond 100 keV. The polarisation analysis using CZTI relies on such Compton events and have been verified experimentally. The same Compton events can also be used to extend the spectroscopy up to 380 keV. Further, it has been observed that about 20% pixels of the CZTI detector plane have low gain, and they are excluded from the primary spectroscopy. If th…
The Cadmium Zinc Telluride Imager (CZTI) on AstroSat is a hard X-ray coded-aperture mask instrument with a primary field of view of 4.6 x 4.6 degrees (FWHM). The instrument collimators become increasingly transparent at energies above $\sim$100 keV, making CZTI sensitive to radiation from the entire sky. While this has enabled CZTI to detect a large number of off-axis transient sources, calculating the source flux or spectrum requires knowledge of the direction and energy dependent attenuation of the radiation incident upon the detector. Here, we present a GEANT4-based mass model of CZTI and A…
AstroSat is India's first space-based astronomical observatory, launched on September 28, 2015. One of the payloads aboard AstroSat is the Cadmium Zinc Telluride Imager (CZTI), operating at hard X-rays. CZTI employs a two-dimensional coded aperture mask for the purpose of imaging. In this paper, we discuss various image reconstruction algorithms adopted for the test and calibration of the imaging capability of CZTI and present results from CZTI on-ground as well as in-orbit image calibration.
The CZTI (Cadmium Zinc Telluride Imager) onboard AstroSat is a high energy coded mask imager and spectrometer in the energy range of 20 - 100 keV. Above 100 keV, the dominance of Compton scattering cross-section in CZTI results in a significant number of 2-pixel Compton events and these have been successfully utilized for polarization analysis of Crab pulsar and nebula (and transients like Gamma-ray bursts) in 100 - 380 keV. These 2-pixel Compton events can also be used to extend the spectroscopic energy range of CZTI up to 380 keV for bright sources. However, unlike the spectroscopy in primar…
The radio as well as the high energy emission mechanism in pulsars is yet not understood properly. A multi-wavelength study is likely to help in better understanding of such processes. The first Indian space-based observatory, ASTROSAT, has five instruments aboard, which cover the electromagnetic spectrum from infra-red (1300 $Å$) to hard X-ray (380 KeV). Cadmium Zinc Telluride Imager (CZTI), one of the five instruments is a hard X-ray telescope functional over an energy range of 20-380 KeV. We aim to estimate the timing offset introduced in the data acquisition pipeline of the instrument, whi…
The Cadmium Zinc Telluride Imager (CZTI) onboard AstroSat, an open detector above $\sim$100 keV, is a promising tool for the investigation of hard X-ray characteristics of $γ$-ray pulsars. A custom algorithm has been developed to detect pulsars from long integration ($\sim$years) of archival data, as reported by us earlier. Here we extend this method to include in the analysis an additional $\sim$20% of the CZTI pixels that were earlier ignored due to their lower gain values. Recent efforts have provided better and more secure calibration of these pixels, demonstrating their higher thresholds …
The Cadmium Zinc Telluride Imager (CZTI) onboard AstroSat consists of an array of a large number of pixellated CZT detectors capable of measuring the polarization of incident hard X-rays. The polarization measurement capability of CZTI for on-axis sources was experimentally confirmed before the launch. CZTI has yielded tantalizing results on the X-ray polarization of the Crab nebula and pulsar in the energy range of 100 - 380 keV. CZTI has also contributed to the measurement of prompt emission polarization for several Gamma-Ray Bursts (GRBs). However, polarization measurements of off-axis sour…
The Cadmium Zinc Telluride Imager (CZTI) is a high energy, wide-field imaging instrument on AstroSat. CZT's namesake Cadmium Zinc Telluride detectors cover an energy range from 20 keV to > 200 keV, with 11% energy resolution at 60 keV. The coded aperture mask attains an angular resolution of 17' over a 4.6 deg x 4.6 deg (FWHM) field of view. CZTI functions as an open detector above 100 keV, continuously sensitive to GRBs and other transients in about 30% of the sky. The pixellated detectors are sensitive to polarisation above ~100 keV, with exciting possibilities for polarisation studies of tr…
The AstroSat satellite is designed to make multi-waveband observations of astronomical sources and the Cadmium Zinc Telluride Imager (CZTI) instrument of AstroSat covers the hard X-ray band. CZTI has a large area position sensitive hard X-ray detector equipped with a Coded Aperture Mask, thus enabling simultaneous background measurement. Ability to record simultaneous detection of ionizing interactions in multiple detector elements is a special feature of the instrument and this is exploited to provide polarization information in the 100 - 380 keV region. CZTI provides sensitive spectroscopic …
Cadmium Zinc Telluride Imager (CZTI) onboard AstroSat has been a prolific Gamma-Ray Burst (GRB) monitor. While the 2-pixel Compton scattered events (100 - 300 keV) are used to extract sensitive spectroscopic information, the inclusion of the low-gain pixels (around 20% of the detector plane) after careful calibration extends the energy range of Compton energy spectra to 600 keV. The new feature also allows single-pixel spectroscopy of the GRBs to the sub-MeV range which is otherwise limited to 150 keV. We also introduced a new noise rejection algorithm in the analysis ('Compton noise'). These …
The Cadmium Zinc Telluride (CZT) Imager on board AstroSat is a hard X-ray imaging spectrometer operating in the energy range of 20 $-$ 100 keV. It also acts as an open hard X-ray monitor above 100 keV capable of detecting transient events like the Gamma-ray Bursts (GRBs). Additionally, the instrument has the sensitivity to measure hard X-ray polarization in the energy range of 100 $-$ 400 keV for bright on-axis sources like Crab and Cygnus X-1 and bright GRBs. As hard X-ray instruments like CZTI are sensitive to cosmic rays in addition to X-rays, it is required to identify and remove particle …
X-ray and Gamma-ray polarization measurements of the prompt emission of Gamma-ray bursts (GRBs) are believed to be extremely important for testing various models of GRBs. So far, the available measurements of hard X-ray polarization of GRB prompt emission have not significantly constrained the GRB models, particularly because of the difficulty of measuring polarization in these bands. The CZT Imager (CZTI) onboard {\em AstroSat} is primarily an X-ray spectroscopic instrument that also works as a wide angle GRB monitor due to the transparency of its support structure above 100 keV. It also has …
Cadmium Zinc Telluride Imager (CZTI) aboard AstroSat has been regularly detecting Gamma-Ray Bursts (GRBs) since its launch in 2015. Its sensitivity to polarization measurements at energies above 100 keV allows CZTI to attempt spectro-polarimetric studies of GRBs. Here, we present the first catalog of GRB polarization measurements made by CZTI during its first five years of operation. This presents the time integrated polarization measurements of the prompt emission of 20 GRBs in the energy range 100-600 keV. The sample includes the bright GRBs which were detected within an angle range of 0-60 …
We present a machine learning (ML) based method for automated detection of Gamma-Ray Burst (GRB) candidate events in the range 60 keV - 250 keV from the AstroSat Cadmium Zinc Telluride Imager data. We use density-based spatial clustering to detect excess power and carry out an unsupervised hierarchical clustering across all such events to identify the different light curves present in the data. This representation helps understand the instrument's sensitivity to the various GRB populations and identify the major non-astrophysical noise artefacts present in the data. We use Dynamic Time Warping…
All-sky monitors can measure the fluxes of astrophysical sources by measuring the changes in observed counts as the source is occulted by the Earth. Such measurements have typically been carried out by all-sky monitors like $\textit{CGRO}$-BATSE and $\textit{Fermi}$-GBM. We demonstrate for the first time the application of this technique to measure fluxes of sources using a collimated instrument: the Cadmium Zinc Telluride detector on $\textit{AstroSat}$. Reliable flux measurements are obtained for the Crab nebula and pulsar, and for Cyg X-1 by carefully selecting the best occultation data set…
Large Area X-ray Propositional Counter (LAXPC) instrument on AstroSat is aimed at providing high time resolution X-ray observations in 3 to 80 keV energy band with moderate energy resolution. To achieve large collecting area, a cluster of three co-aligned identical LAXPC detectors, is used to realize an effective area in access of about 6000 cm2 at 15 keV. The large detection volume of the LAXPC detectors, filled with xenon gas at about 2 atmosphere pressure, results in detection efficiency greater than 50%, above 30 keV. In this article, we present salient features of the LAXPC detectors, the…
We present an improved background model for the Large Area X-ray Proportional Counter (LAXPC) detectors on-board AstroSat. Because of the large collecting area and high pressure, the LAXPC instrument has a large background count rate, which varies during the orbit. Apart from the variation with latitude and longitude during the orbit there is a prominent quasi-diurnal variation which has not been modelled earlier. Using over 5 years of background observations, we determined the period of the quasi-diurnal variation to be 84495 s and using this period, it is possible to account for the variatio…
Results of the initial calibration of the Ultra-Violet Imaging Telescope (UVIT) were reported earlier by Tandon et al. (2017). The results reported earlier were based on the ground calibration as well as the first observations in orbit. Some additional data from the ground calibration and data from more in-orbit observations have been used to improve the results. In particular, extensive new data from in-orbit observations have been used to obtain (a) new photometric calibration which includes (i) zero-points (ii) flat fields (iii) saturation, (b) sensitivity variations (c) spectral calibratio…
We present the in-orbit performance and the first results from the ultra-violet Imaging telescope (UVIT) on ASTROSAT. UVIT consists of two identical 38cm coaligned telescopes, one for the FUV channel (130-180nm) and the other for the NUV (200-300nm) and VIS (320-550nm) channels, with a field of view of 28 $arcmin$. The FUV and the NUV detectors are operated in the high gain photon counting mode whereas the VIS detector is operated in the low gain integration mode. The FUV and NUV channels have filters and gratings, whereas the VIS channel has filters. The ASTROSAT was launched on 28th Septembe…
The impact of large-scale constellations of satellites, is a concern for ground-based astronomers. In recent years there has been a significant increase in the number of satellites in Low-Earth Orbit and this trend is set to continue. The large number of satellites increases the probability that one will enter the field of view of a ground-based telescope at the right solar angle to appear bright enough that it can corrupt delicate measurements. We present a new tool Astrosat that will project satellite orbits onto the RA/DEC coordinate system for a given observer location and time and field o…
The Large Area X-ray Proportional Counter (LAXPC) instrument on-board AstroSat has three nominally identical detectors for timing and spectral studies in the energy range of 3--80 keV. The performance of these detectors during the five years after the launch of AstroSat is described. Currently, only one of the detector is working nominally. The variation in pressure, energy resolution, gain and background with time are discussed. The capabilities and limitations of the instrument are described. A brief account of available analysis software is also provided.
The Ultra-Violet Imaging Telescope (UVIT) is one of the payloads in ASTROSAT, the first Indian Space Observatory. The UVIT instrument has two 375mm telescopes: one for the far-ultraviolet (FUV) channel (1300--1800Å), and the other for the near-ultraviolet (NUV) channel (2000--3000Å) and the visible (VIS) channel (3200--5500Å). UVIT is primarily designed for simultaneous imaging in the two ultraviolet channels with spatial resolution better than 1.8 arcsec, along with provision for slit-less spectroscopy in the NUV and FUV channels.The results of in-orbit calibrations of UVIT are presented in t…
