arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1607.05225cond-mat.soft
收藏

机械应变对不同压力下压制润滑片剂性能的影响

The effect of mechanical strain on properties of lubricated tablets compacted at different pressures

Pallavi Pawar, Hee Joo, Gerardo Callegari, German Drazer, Alberto M. Cuitino, Fernando J. Muzzio

摘要:

采用完全析因试验设计,研究了共混剪切应变对压片工艺、相对密度和强度的影响。使用特设库埃特剪切单元使粉末共混物经受不同的剪切应变水平(剪切速率相对于时间的积分)。片剂压缩在不同的压实力使用一个仪器化的压实机模拟器,和压实曲线,显示在压实过程中的力-位移曲线。尽管模头填充共混物孔隙率(初始孔隙率)和最小模头内片剂孔隙率(在最大压实下)随剪切应变显著降低,但最终片剂孔隙率令人惊讶地与剪切应变无关。在模内最大压实与剪切应变的增加,事实上,在压实后松弛的表,这也增加了显着的剪切应变补偿。因此,仅片剂孔隙率不足以预测片剂拉伸强度。作为剪切应变的函数的“压实工作”的减少,和恢复的弹性工作的增加进行了观察,这表明较弱的颗粒-颗粒结合的剪切应变的增加。对于每个剪切应变水平,Ryskewitch Duckworth方程与作为片剂孔隙率函数的拉伸强度拟合良好,并且在零孔隙率下获得的渐近拉伸强度显示出作为剪切应变函数的60%降低。这与随着剪切应变增加而降低的结合效率一致。

英文摘要:

A full factorial design of experiments was used to study the effect of blend shear strain on the compaction process, relative density and strength of pharmaceutical tablets. The powder blends were subjected to different shear strain levels (integral of shear rate with respect to time) using an ad hoc Couette shear cell. Tablets were compressed at different compaction forces using an instrumented compactor simulator, and compaction curves showing the force-displacement profiles during compaction were obtained. Although the die-fill blend porosity (initial porosity) and the minimum in-die tablet porosity (at maximum compaction) decreased significantly with shear strain, the final tablet porosity was surprisingly independent of shear strain. The increase in the in-die maximum compaction with shear strain was, in fact, compensated during post-compaction relaxation of the tables, which also increased significantly with shear strain. Therefore, tablet porosity alone was not sufficient to predict tablet tensile strength. A decrease in the 'work of compaction' as a function of shear strain, and an increase in the recovered elastic work was observed, which suggested weaker particle-particle bonding as the shear strain increased. For each shear strain level, the Ryskewitch Duckworth equation was a good fit to the tensile strength as a function of tablet porosity, and the obtained asymptotic tensile strength at zero porosity exhibited a 60% reduction as a function of shear strain. This was consistent with a reduced bonding efficiency as the shear strain increased.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑