非承压含水层中的跨孔段塞试验模拟
Modeling cross-hole slug tests in an unconfined aquifer
摘要:
一个修改后的版本公布的段塞测试模型,适用于无压含水层的跨孔段塞测试在瑞士的加宽网站进行的现场测试中收集的数据。该模型占地下水位的影响,使用线性化的运动条件。该模型还考虑了源井和观测井的惯性效应。这项工作的主要目的是证明这种半解析模式的适用性,多井和多级气动段塞测试。在源井中以离散的间隔施加气动扰动,并在观测井中以离散的垂直间隔进行监测。源井和观测井对之间的距离最多为4米。分析产生了垂直剖面的水力传导率,比存储,并在观察井的位置比产量。水力参数估计值进行比较,从以前的抽水和单井段塞试验在现场进行的结果,以及从粒径分析的沉积物收集在钻井安装过程中的估计。结果与先前的测试结果基本一致,表明存在砂和砾石含水层。敏感性分析表明,单产模型识别能力在后期最强。然而,由于低的信噪比,后期数据的有用性受到限制。
英文摘要:
A modified version of a published slug test model for unconfined aquifers is applied to cross-hole slug test data collected in field tests conducted at the Widen site in Switzerland. The model accounts for water-table effects using the linearised kinematic condition. The model also accounts for inertial effects in source and observation wells. The primary objective of this work is to demonstrate applicability of this semi-analytical model to multi-well and multi-level pneumatic slug tests. The pneumatic perturbation was applied at discrete intervals in a source well and monitored at discrete vertical intervals in observation wells. The source and observation well pairs were separated by distances of up to 4 m. The analysis yielded vertical profiles of hydraulic conductivity, specific storage, and specific yield at observation well locations. The hydraulic parameter estimates are compared to results from prior pumping and single-well slug tests conducted at the site, as well as to estimates from particle size analyses of sediment collected from boreholes during well installation. The results are in general agreement with results from prior tests and are indicative of a sand and gravel aquifer. Sensitivity analysis show that model identification of specific yield is strongest at late-time. However, the usefulness of late-time data is limited due to the low signal-to-noise ratios.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。