二极管-STTRAM交叉阵列的多位读写方法
Multi-Bit Read and Write Methodologies for Diode-STTRAM Crossbar Array
摘要:
交叉开关阵列采用电阻式RAM(ReRAM)等新兴非易失性存储器技术,可提供高密度、快速存取速度和低功耗。然而,交叉开关的带宽被限制为每次访问的单比特读/写,以避免选择不期望的比特。提出了一种在二极管-STTRAM(自旋转移力矩RAM)交叉阵列中进行多位读写的技术。仿真表明,可以调整半选中单元的偏置电压,以提高读取期间的感测裕度,从而减少通过半选中单元的潜路径。在写操作中,半选中单元用脉冲电压源偏置,该脉冲电压源增加这些单元的写等待时间,并且使得能够写入2位,同时保持半选中位不受干扰。模拟结果表明,将半选中单元偏置700 mV可以实现多达512位的读取,同时维持512 × 512交叉开关,保持2.04年。2位写入需要50 mV的脉冲以优化能量。
英文摘要:
Crossbar arrays using emerging non-volatile memory technologies such as Resistive RAM (ReRAM) offer high density, fast access speed and low-power. However the bandwidth of the crossbar is limited to single-bit read/write per access to avoid selection of undesirable bits. We propose a technique to perform multi-bit read and write in a diode-STTRAM (Spin Transfer Torque RAM) crossbar array. Simulation shows that the biasing voltage of half-selected cells can be adjusted to improve the sense margin during read and thus reduce the sneak path through the half-selected cells. In write operation, the half-selected cells are biased with a pulse voltage source which increases the write latency of these cells and enables to write 2-bits while keeping the half-selected bits undisturbed. Simulation results indicate biasing the half-selected cells by 700mV can enable reading as much as 512-bits while sustaining 512x512 crossbar with 2.04 years retention. The 2-bit writing requires pulsing by 50mV to optimize energy.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。