二维纺织复合材料层内能量耗散及尺寸效应的实验与数值研究
Experimental and Numerical Investigation of Intra-Laminar Energy Dissipation and Size Effect in Two-Dimensional Textile Composites
摘要:
大型复合材料结构的设计需要了解其力学性能的缩放,这是复合材料文献中经常忽略的一个方面。这一贡献分析,实验和数值模拟,纺织复合材料结构的层内尺寸效应。本文报道了由8层0度环氧树脂/碳纤维复合材料2 × 2层合板制成的几何形状相似的单边缺口试件的试验结果。结果表明,名义强度随着试样尺寸的增加而降低,并且实验数据可以很好地拟合Bazant尺寸效应定律,从而可以准确地识别材料的层内断裂能。通过数值研究其对复合材料管耐撞性的影响,阐明了在层内断裂是主要能量耗散机制的情况下准确估计Gf的重要性。模拟表明,对于所分析的几何形状,断裂能降低到测量值的50%对应于平台破碎载荷降低近42%。此外,假设峰值后的垂直应力下降,在大多数商业有限元代码中实现的基于强度的本构关系的典型假设,导致强度低估70%的顺序。本研究的主要结论是,准确测量断裂能和正确模拟纺织复合材料的断裂行为,包括其准脆性,是关键。这既不能通过忽略尺寸效应的基于强度或应变的方法来实现,也不能通过不考虑断裂过程区的有限性的LEFM来实现。
英文摘要:
Design of large composite structures requires understanding the scaling of their mechanical properties, an aspect often overlooked in the literature on composites. This contribution analyzes, experimentally and numerically, the intra-laminar size effect of textile composite structures. Test results of geometrically similar Single Edge Notched specimens made of 8 layers of 0 degree epoxy/carbon twill 2 by 2 laminates are reported. Results show that the nominal strength decreases with increasing specimen size and that the experimental data can be fitted well by Bazant's size effect law, allowing an accurate identification of the intra-laminar fracture energy of the material. The importance of an accurate estimation of Gf in situations where intra-laminar fracturing is the main energy dissipation mechanism is clarified by studying numerically its effect on crashworthiness of composite tubes. Simulations demonstrate that, for the analyzed geometry, a decrease of the fracture energy to 50% of the measured value corresponds to an almost 42% decrease in plateau crushing load. Further, assuming a vertical stress drop after the peak, a typical assumption of strength-based constitutive laws implemented in most commercial Finite Element codes, results in an strength underestimation of the order of 70%. The main conclusion of this study is that measuring accurately fracture energy and modeling correctly the fracturing behavior of textile composites, including their quasi-brittleness, is key. This can be accomplished neither by strength- or strain-based approaches, which neglect size effect, nor by LEFM which does not account for the finiteness of the Fracture Process Zone.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。