高场应用Bi-2212线材开发的新概念
New concept for the development of Bi-2212 wires for high field applications
摘要:
在Bi-2212导线中实现高临界电流的第一步是理解超导电流在长的长度上被在熔化阶段期间生长的大直径气泡阻挡,这导致导线直径的膨胀和超导细丝的去致密化。鉴于先前成功减少与气泡相关的空隙问题的方法是基于在热处理期间施加高过压,我们通过应用适当交替的凹槽轧制和拉拔技术的新概念来制造Bi-2212线材,目的是在热处理之前的工作程序期间已经使相致密化。我们在这里第一次能够达到与封闭端反应的电线-即与气体困在电线中,因为它发生在长长度的电线-与开放端反应的短电线中显示的临界电流值非常相同。这是无可辩驳的证据,证明只有通过变形技术,我们才能在熔化阶段之前通过适当地致密丝内的超导粉末来提高临界电流。在4.2 K和5 T下,我们的长模拟导线的全导体电流密度已经达到400 A/mm 2,通过架构优化仍然可以轻松提高。实际的突破是,通过一种可以直接应用于长长度线材的技术,在没有进一步复杂处理的情况下优化了致密化。
英文摘要:
The first step towards high critical currents in Bi-2212 wires was the comprehension that the supercurrent is blocked over long lengths by filament-diameter bubbles grown during the melt stage, which cause expansion of the wire diameter and dedensification of the superconducting filaments. Whereas the previous successful approach to reduce the problem of voids related to bubbles was based on the application of a high overpressure during the heat treatment, we fabricated Bi-2212 wires by applying a new concept of suitably alternating groove-rolling and drawing techniques with the aim of densifying the phase already during the working procedure prior to the heat treatment. We here for the first time were able to reach in wires reacted with closed ends - i.e. with gas trapped in the wire as it happens in long-length wires - the very same values of critical current shown in short wires reacted with open ends. This is the irrefutable evidence that, only by acting on the deformation technique, we were able to raise the critical current by properly densifying the superconducting powder inside the filaments already before the melt stage. Whole-conductor current densities in our long length simulation wires already reach 400 A/mm2 at 4.2 K and 5 T, which can be still easily increased through architecture optimization. The actual breakthrough is that the densification is optimized without further complex treatments through a technique which can be straightforwardly applied to long-lengths wires.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。