实芯偶极子和开关电源:低成本光源?
Solid core dipoles and switching power supplies: lower cost light sources?
摘要:
由于功率半导体的改进,中频开关电源现在可以提供加速器通常所需的数百安培电流,在电流或电压模式下,零峰值噪声在kHz范围内约为0.06%。使用有限电磁程序进行建模,以确定CEBAF磁体的固体钢中感应的涡流和小的补充添加是否会将误差场降低到光束质量所需的5ppm水平。所考虑的磁体的预期最大磁场为0.85 T,并且在计算中使用产生该磁场所需的DC电流。在离散频率360 Hz、720 Hz或7200 Hz下,额外的0.1%电流纹波被添加到DC电流。在中心积分BdL的0.5%内的极点区域上,对于所有频率,所产生的AC场变化可以减少到小于0.1%输入纹波的1%,并且在7200 Hz时减少到其六分之一。将电流加倍,提供1.5T中心场,对于检查的情况,在光束处产生相同的纹波减少分数。对于具有铝真空容器和全能量直线加速器注入的光源,实芯偶极子和开关电源的组合可以导致显著的成本节省。
英文摘要:
As a result of improvements in power semiconductors, moderate frequency switching supplies can now provide the hundreds of amps typically required by accelerators with zero-to-peak noise in the kHz region ~0.06% in current or voltage mode. Modeling was undertaken using a finite electromagnetic program to determine if eddy currents induced in the solid steel of CEBAF magnets and small supplemental additions would bring the error fields down to the 5ppm level needed for beam quality. The expected maximum field of the magnet under consideration is 0.85T and the DC current required to produce that field is used in the calculations. An additional 0.1% current ripple is added to the DC current at discrete frequencies 360 Hz, 720 Hz or 7200 Hz. Over the region of the pole within 0.5% of the central integrated BdL the resulting AC field changes can be reduced to less than 1% of the 0.1% input ripple for all frequencies, and a sixth of that at 7200 Hz. Doubling the current, providing 1.5T central field, yielded the same fractional reduction in ripple at the beam for the cases checked. For light sources with aluminum vacuum vessels and full energy linac injection, the combination of solid core dipoles and switching power supplies may result in significant cost savings.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。