The Internet of things (IoT) holds much commercial potential and could facilitate distributed multiple-input multiple-output (MIMO) communication in future systems. We study a distributed reception scenario in which a transmitter equipped with multiple antennas sends multiple streams via spatial multiplexing to a large number of geographically separated single antenna receive nodes. The receive nodes then quantize their received signals and forward the quantized received signals to a receive fusion center. With global channel knowledge and forwarded quantized information from the receive nodes, the fusion center attempts to decode the transmitted symbols. We assume the transmit vector consists of phase shift keying (PSK) constellation points, and each receive node quantizes its received signal with one bit for each of the real and imaginary parts of the signal to minimize the transmission overhead between the receive nodes and the fusion center. Fusing this data is a non-trivial problem because the receive nodes cannot decode the transmitted symbols before quantization. Instead, each receive node processes a single quantity, i.e., the received signal, regardless of the number of transmitted symbols. We develop an optimal maximum likelihood (ML) receiver and a low-complexity zero-forcing (ZF)-type receiver at the fusion center. Despite its suboptimality, the ZF-type receiver is simple to implement and shows comparable performance with the ML receiver in the low signal-to-noise ratio (SNR) regime but experiences an error rate floor at high SNR. It is shown that this error floor can be overcome by increasing the number of receive nodes. Hence, the ZF-type receiver would be a practical solution for distributed reception with spatial multiplexing in the era of the IoT where we can easily have a large number of receive nodes.
A multi-user cognitive (secondary) radio system is considered, where the spatial multiplexing mode of operation is implemented amongst the nodes, under the presence of multiple primary transmissions. The secondary receiver carries out minimum mean-squared error (MMSE) detection to effectively decode the secondary data streams, while it performs spectrum sensing at the remaining signal to capture the presence of primary activity or not. New analytical closed-form expressions regarding some important system measures are obtained, namely, the outage and detection probabilities; the transmission p…
The Internet of Things (IoT) could enable the development of cloud multiple-input multiple-output (MIMO) systems where internet-enabled devices can work as distributed transmission/reception entities. We expect that spatial multiplexing with distributed reception using cloud MIMO would be a key factor of future wireless communication systems. In this paper, we first review practical receivers for distributed reception of spatially multiplexed transmit data where the fusion center relies on quantized received signals conveyed from geographically separated receive nodes. Using the structures of …
Massive MIMO, a candidate for 5G technology, promises significant gains in wireless data rates and link reliability by using large numbers of antennas (more than 64) at the base transceiver station (BTS). Extra antennas help by focusing the transmission and reception of signal energy into ever-smaller regions of space. This brings huge improvements in throughput. However, it requires a large number of Radio Frequency (RF) chains (usually equal to number of transmit antennas), which is a major drawback. One approach to overcome these issues is to use Spatial Modulation (SM). In SM, an index of …
Link adaptation is a crucial part of many modern communications systems, allowing the system to adapt the transmission and reception strategies to changes in channel conditions. One of the fundamental components of the link adaptation mechanism is signal to noise ratio (SNR) estimation, measuring the instantaneous (mostly post processing) SNR at the receiver. That is, the SNR at the decoder input, which is an important metric for the prediction of decoder performance. In linearly decoded MIMO, which is the common MIMO decoding strategy, the post processing SNR is well defined. However, this is…
In this paper we study the maximum throughput achievable with optimal scheduling in multi-hop networks with highly directive antenna arrays capable of Space Division Multiplexing (SDM) at the transmitter and Space Division Multiple Access (SDMA) at the receiver. This network model is relevant for future millimeter wave (mmWave) systems, which are expected to implement self-backhauled cellular networks with very high data rates, relying on carrier frequencies between 10-300 GHz, channels with a very large bandwidth, and a large number of antenna elements, even in mobile devices. We adapt mmWave…
Physical layer security has been considered as an important security approach in wireless communications to protect legitimate transmission from passive eavesdroppers. This paper investigates the physical layer security of a wireless multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) communication system in the presence of a multiple-antenna eavesdropper. We first propose a transmit-filter-assisted secure MIMO-OFDM system which can destroy the orthogonality of eavesdropper's signals. Our proposed transmit filter can disturb the reception of eavesdropper whi…
In downlink multi-antenna systems with many users, the multiplexing gain is strictly limited by the number of transmit antennas $N$ and the use of these antennas. Assuming that the total number of receive antennas at the multi-antenna users is much larger than $N$, the maximal multiplexing gain can be achieved with many different transmission/reception strategies. For example, the excess number of receive antennas can be utilized to schedule users with effective channels that are near-orthogonal, for multi-stream multiplexing to users with well-conditioned channels, and/or to enable interferen…
Antennas of transmitters and receivers have been manipulated to increase the capacity of transmission and reception of signals. Using many elements in antennas to shape beams and direct nulls in a particular point for optimum signal transmission and reception has over decades, had tremendous positive influence in received power and signal to noise ratio (SNR). However, since the antenna elements manipulation can be done both at base station and device terminal, it gives rise to an important method of using several antennas to put and obtain signals to and from space with increased capacity. Th…
This paper studies the maximum throughput achievable with optimal scheduling in multi-hop mmWave picocellular networks with Multi-user Multiple-Input Multiple-Output (MU-MIMO) radios. MU-MIMO enables simultaneous transmission to multiple receivers (Space Division Multiplexing) and simultaneous reception from multiple transmitters (Space Division Multiple Access). The main contribution is the extension to MU-MIMO of the Network Utility Maximization (NUM) scheduling framework for multi-hop networks. We generalize to MU-MIMO the classic proof that Maximum Back Pressure (MBP) scheduling is NUM opt…
In this paper, we consider an overlay satellite-terrestrial network (OSTN) where an opportunistically selected terrestrial IoT network assist primary satellite communications as well as access the spectrum for its own communications in the presence of combined interference from extra-terrestrial and terrestrial sources. Hereby, a power domain multiplexing is adopted by the IoT network by splitting its power appropriately among the satellite and IoT signals. Relying upon an amplify-and-forward (AF)-based opportunistic IoT network selection strategy that minimizes the outage probability (OP) of …
A novel modulation scheme termed orthogonal frequency-division multiplexing with subcarrier number modulation (OFDM-SNM) has been proposed and regarded as one of the promising candidate modulation schemes for next generation networks. Although OFDM-SNM is capable of having a higher spectral efficiency (SE) than OFDM with index modulation (OFDM-IM) and plain OFDM under certain conditions, its reliability is relatively inferior to these existing schemes, because the number of active subcarriers varies. In this regard, we propose an enhanced OFDM-SNM scheme in this paper, which utilizes the flexi…
Ambient backscatter communication (AmBC) enables a passive backscatter device to transmit information to a reader using ambient RF signals, and has emerged as a promising solution to green Internet-of-Things (IoT). Conventional AmBC receivers are interested in recovering the information from the ambient backscatter device (A-BD) only. In this paper, we propose a cooperative AmBC (CABC) system in which the reader recovers information not only from the A-BD, but also from the RF source. We first establish the system model for the CABC system from spread spectrum and spectrum sharing perspectives…
Massive MIMO is considered to be one of the key technologies in the emerging 5G systems, but also a concept applicable to other wireless systems. Exploiting the large number of degrees of freedom (DoFs) of massive MIMO essential for achieving high spectral efficiency, high data rates and extreme spatial multiplexing of densely distributed users. On the one hand, the benefits of applying massive MIMO for broadband communication are well known and there has been a large body of research on designing communication schemes to support high rates. On the other hand, using massive MIMO for Internet-o…
In this article, the first general constructions of fast-decodable, more specifically (conditionally) $g$-group decodable, space-time block codes for the Nonorthogonal Amplify and Forward (NAF) Multiple-Input Multiple-Output (MIMO) relay channel under the half-duplex constraint are proposed. In this scenario, the source and the intermediate relays used for data amplification are allowed to employ multiple antennas for data transmission and reception. The worst-case decoding complexity of the obtained codes is reduced by up to $75%$. In addition to being fast-decodable, the proposed codes achie…
Multi-user multiple-input multiple-output (MU-MIMO) cellular systems with an excess of base station (BS) antennas (Massive MIMO) offer unprecedented multiplexing gains and radiated energy efficiency. Oscillator phase noise is introduced in the transmitter and receiver radio frequency chains and severely degrades the performance of communication systems. We study the effect of oscillator phase noise in frequency-selective Massive MIMO systems with imperfect channel state information (CSI). In particular, we consider two distinct operation modes, namely when the phase noise processes at the $M$ …
In this paper, we propose a wideband Full Duplex (FD) Multiple-Input Multiple-Output (MIMO) communication system comprising of an FD MIMO node simultaneously communicating with two multi-antenna UpLink (UL) and DownLink (DL) nodes utilizing the same time and frequency resources. To suppress the strong Self-Interference (SI) signal due to simultaneous transmission and reception in FD MIMO systems, we propose a joint design of Analog and Digital (A/D) cancellation as well as transmit and receive beamforming capitalizing on baseband Orthogonal Frequency-Division Multiplexing (OFDM) signal modelin…
In this paper we investigate the achievable rate of a system that includes a nomadic transmitter with several antennas, which is received by multiple agents, exhibiting independent channel gains and additive circular-symmetric complex Gaussian noise. In the nomadic regime, we assume that the agents do not have any decoding ability. These agents process their channel observations and forward them to the final destination through lossless links with a fixed capacity. We propose new achievable rates based on elementary compression and also on a Wyner-Ziv (CEO-like) processing, for both fast fadin…
Grant-free non-orthogonal multiple access (NOMA) is promising to achieve low latency massive access in Internet of Things (IoT) applications. In grant-free NOMA, pilot signals are often used for user activity detection (UAD) and channel estimation (CE) prior to multiuser detection (MUD) of active users. However, the pilot overhead makes the communications inefficient for IoT devices with sporadic transmissions and short data packets, or when the channel coherence time is short. Hence, it is desirable to improve the efficiency by avoiding the use of pilot signals, which can also further achieve…
To account for the massive uncoordinated random access scenario, which is relevant for the Internet of Things, Polyanskiy (2017) proposed a novel formulation of the multiple-access problem, commonly referred to as unsourced multiple access, where all users employ a common codebook and the receiver decodes up to a permutation of the messages. We extend this seminal work to the case where the number of active users is random and unknown a priori. We define a random-access code accounting for both misdetection (MD) and false alarm (FA), and derive a random-coding achievability bound for the Gauss…
To support massive connectivity and boost spectral efficiency for internet of things (IoT), a downlink scheme combining virtual multiple-input multiple-output (MIMO) and nonorthogonal multiple access (NOMA) is proposed. All the single-antenna IoT devices in each cluster cooperate with each other to establish a virtual MIMO entity, and multiple independent data streams are requested by each cluster. NOMA is employed to superimpose all the requested data streams, and each cluster leverages zero-forcing detection to de-multiplex the input data streams. Only statistical channel state information (…
