基于信标的802.15.4 RPL网络拓扑结构构建
Topology Construction in RPL Networks over Beacon-Enabled 802.15.4
摘要:
在本文中,我们提出了一个新的计划,允许耦合信标启用IEEE 802.15.4与RPL路由协议,同时保持完全符合这两个标准。我们通过将RPL DIO消息封装在信标帧中,为RPL提供了一种在创建802.15.4拓扑之前将路由信息传递到第2层的方法。该方案利用802.15.4命令帧来请求RPL DIO消息。命令帧的作用是重置控制发送DIO消息的涓流计时器。我们提供了一个详细的分析所提出的方案,以了解拓扑结构的建设成本所产生的开销。我们已经评估了该计划使用Contiki和防御级Cooja模拟器,并将我们的结果与用于在信标启用PAN中传播上层信息的最常见方案进行了比较。结果表明,在拓扑结构的建设阶段,并在稳定状态下的能源节约。
英文摘要:
In this paper, we propose a new scheme that allows coupling beacon-enabled IEEE 802.15.4 with the RPL routing protocol while keeping full compliance with both standards. We provide a means for RPL to pass the routing information to Layer 2 before the 802.15.4 topology is created by encapsulating RPL DIO messages in beacon frames. The scheme takes advantage of 802.15.4 command frames to solicit RPL DIO messages. The effect of the command frames is to reset the Trickle timer that governs sending DIO messages. We provide a detailed analysis of the overhead incurred by the proposed scheme to understand topology construction costs. We have evaluated the scheme using Contiki and the instruction-level Cooja simulator and compared our results against the most common scheme used for dissemination of the upper-layer information in beacon-enabled PANs. The results show energy savings during the topology construction phase and in the steady state.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。